Cutting Force Model for a Small-diameter Helical Milling Cutter

i

This article has been updated. A Correction to this article was published on .

i

The Original Article was published on

i

The Original Article was published on

i

This article has been updated

i

This article was retracted on

i

This article has been updated

Abstract

In the milling process, the major flank wear land area (two-dimensional measurement for the wear) of a small-diameter milling cutter, as wear standard, can reflect actual changes of the wear land of the cutter. By analyzing the wearing characteristics of the cutter, a cutting force model based on the major flank wear land area is established. Characteristic parameters such as pressure parameter and friction parameter are calculated by substituting tested data into their corresponding equations. The cutting force model for the helical milling cutter is validated by experiments. The computational and experimental results show that the cutting force model is almost consistent with the actual cutting conditions. Thus, the cutting force model established in the research can provide a theoretical foundation for monitoring the condition of a milling process that uses a small-diameter helical milling cutter.

Keywords

helical milling cutter, major flank wear land area, cutting force model, characteristic parameter

CHANGE HISTORY

A Correction to this paper has been published:
https://doi.org

The Retraction Note was updated to reflect reception of statements of disagreement from all authors.

This article has been retracted.Please see the Retraction Notice for more detail:
https://doi.org