Shear behavior of novel prestressed concrete beam subjected to monotonic and cyclic loading

Fang Yu , Dali Yao , Jinqing Jia , Feng Wu

Transactions of Tianjin University ›› 2014, Vol. 20 ›› Issue (4) : 257 -265.

PDF
Transactions of Tianjin University ›› 2014, Vol. 20 ›› Issue (4) : 257 -265. DOI: 10.1007/s12209-014-2258-y
Article

Shear behavior of novel prestressed concrete beam subjected to monotonic and cyclic loading

Author information +
History +
PDF

Abstract

Prestressed steel ultrahigh-strength reinforced concrete (PSURC) beam is a new type of prestressed concrete beam, which not only has a considerable compressive strength attributed to the ultrahigh strength concrete, but also ensures a certain degree of ductility at failure due to the existence of structural steel. Five of these beams were monotonically tested until shear failure to investigate the static shear performance including the failure pattern, load-deflection behavior, shear capacity, shear crack width and shear ductility. The experimental results show that these beams have superior shear capacity, crack control ability and shear ductility. To study the shear performance under repeated overloading, seven PSURC beams were loaded in cyclic test simultaneously. The overall shear performance of cycled beams is similar to that of uncycled beams at low load level but different at high load level. The shear capacity and crack control ability of cycled beams at high load level are reduced, whereas the shear ductility is improved. In addition, the influences of variables including the degree of prestress, stirrup ratio and load level on the shear performance of both uncycled and cycled beams were also discussed and compared, respectively.

Keywords

prestressed concrete beam / structural steel / ultrahigh strength concrete / shear behavior / cyclic loading

Cite this article

Download citation ▾
Fang Yu, Dali Yao, Jinqing Jia, Feng Wu. Shear behavior of novel prestressed concrete beam subjected to monotonic and cyclic loading. Transactions of Tianjin University, 2014, 20(4): 257-265 DOI:10.1007/s12209-014-2258-y

登录浏览全文

4963

注册一个新账户 忘记密码

References

[1]

Chen L, Graybeal Benjamin A. Modeling structural performance of ultrahigh performance concrete Igirders[J]. Journal of Bridge Engineering, 2012, 17(5): 754-764.

[2]

Graybeal Benjamin A. Flexural behavior of an ultrahigh-performance concrete I-girder[J]. Journal of Bridge Engineering, 2008, 13(6): 602-610.

[3]

Steinberg E. Structural reliability of prestressed UHPC flexure modes for bridge girders[J]. Journal of Bridge Engineering, 2010, 15(1): 65-72.

[4]

Yao D, Jia J, Yu F, et al. Analysis on the shear ductility of prestressed high-strength concrete beams[J]. Journal of Harbin Engineering University, 2013, 34(5): 65-72.

[5]

Fu C, Li Y, Liang Shuting. Experimental study on simply supported prestressed steel reinforced concrete beams[J]. Journal of Building Structures, 2007, 28(3): 62-73.

[6]

Xue W, Li J, Li Kun. Experimental studies on seismic performance of prestressed steel concrete composite beams[J]. Journal of Harbin Institute of Technology, 2007, 39(4): 656-660.

[7]

Forrest Richard W B, Higgins C, Ekin Senturk A. Experimental and analytical evaluation of reinforced concrete girders under low-cycle shear fatigue[J]. ACI Structural Journal, 2010, 107(2): 199-207.

[8]

Sun X, Huang Chengkui. Research on shear behavior of reinforced concrete beams under cyclic loading[J]. Journal of Dalian University of Technology, 2006, 46(1): 69-74.

[9]

Shahawi Mohsen E I, de Batchelor Barrington V. Fatigue of partially prestressed concrete[J]. Journal of Structural Engineering, 1986, 112(3): 524-537.

[10]

Yao D, Jia J, Tu B, et al. Elastic stiffness analysis on ultra-high strength prestress concrete beam[J]. Journal of Wuhan University of Technology (Transportation Science & Engineering), 2013, 37(1): 74-76.

[11]

Lin C-H, Lee F-Sheng. Shear behavior of high-workability concrete beams[J]. ACI Structural Journal, 2003, 100(5): 599-608.

[12]

Lin C-H, Lee F-Sheng. Ductility of highperformance concrete beams with high-strength lateral reinforment[J]. ACI Structural Journal, 2001, 98(4): 600-608.

[13]

Fathifazl G, Razaqpur G, Isgor B, et al. Shear strength of reinforced recycled concrete beams with stirrups[J]. Magazine of Concrete Research, 2010, 62(10): 685-699.

[14]

Lee S-C, Cho J-Y, Oh B-Hwan. Shear behavior of large-scale post-tensioned girders with small shear span-depth ratio[J]. ACI Structural Journal, 2010, 107(2): 137-145.

[15]

Yi W, Pan B, Yanmei. Experimental study on the shear failure of reinforced concrete beams with grade HRB500 steel stirrups[J]. China Civil Engineering Journal, 2012, 45(4): 56-62.

[16]

Yi W, Yanmei. Experimental study on shear behavior of high-strength concrete beams with high-strength stirrups[J]. Journal of Building Structures, 2009, 30(4): 94-101.

AI Summary AI Mindmap
PDF

102

Accesses

0

Citation

Detail

Sections
Recommended

AI思维导图

/