Experimental and theoretical investigations of the lateral vibrations of an unbalanced Jeffcott rotor

Abstract

The current work experimentally explores and then theoretically examines the lateral vibrations of an unbalanced Jeffcott rotor-system working at several unbalance conditions. To this end, three conditions of eccentric masses are considered by using a Bently Nevada RK-4 rotor kit. Measurements of the steady-state as well as the startup data at rigid and flexible rotor states are captured by conducting a setup that mimics the vibration monitoring industrial practices. The linear governing equation of the considered rotor is extracted by adopting the Lagrange method on the basis of rigid rotor assumptions to theoretically predict the lateral vibrations. The dynamic features of the rotor system such as the linearized bearing induced stiffness are exclusively acquired from startup data. It is demonstrated that, with an error of less than 5%, the proposed two-degrees-of-freedom model can predict the flexural vibrations at rigid condition. While at flexible condition, it fails to accurately predict the dynamic response. In contrast to the other works where nonlinear mathematical models with some complexities are proposed to mathematically model the real systems, the present study illustrates the applicability of employing simple models to predict the dynamic response of a real rotor-system with an acceptable accuracy.

Keywords

rotor-dynamics / Jeffcott rotor / lateral vibrations / Lagrange method / system-equivalent stiffness / sleeve bearings / oil film induced stiffness

References

[1] Krodkiewski J M, Ding J, Zhang N. Identification of unbalance change using a non-linear mathematical model for multi-bearing rotor systems. Journal of Sound and Vibration, 1994, 169(5): 685–698

[2] Sanches F D, Pederiva R. Rotor faults identification using correlation analysis and model order reduction. In: The 22nd International Congress of Mechanical Engineering (COBEM 2013). Ribeirão Preto, 2013

[3] Pjadatare H P, Pratiher B. Nonlinear frequencies and unbalanced response analysis of high speed rotor-bearing systems. Procedia Engineering, 2016, 144: 801–809

[4] Gunter E J. Introduction to Rotor Dynamics: Critical Speed and Unbalance Response Analysis. Charlottesville, VA: RODYN Vibration Analysis, Inc., 2001

[5] Rabczuk T, Ren H, Zhuang X. A nonlocal operator method for partial differential equations with application to electromagnetic waveguide problem. Computers, Materials and Continua, 2019, 59(1): 31–55

[6] Taplak H, Uzmay I, Yıldırım S. Design of artificial neural networks for rotor dynamics analysis of rotating machine systems. Journal of Scientific and Industrial Research, 2005, 64: 411–419

[7] Anitescu C, Atroshchenko E, Alajlan N, Rabczuk T. Artificial neural network methods for the solution of second order boundary value problems. Computers, Materials & Continua, 2019, 59(1): 345–359

[8] Malenovský E. Using the modal method in rotor dynamic systems. International Journal of Rotating Machinery, 2003, 9(3): 181–196

[9] Guo H, Zhuang X, Rabczuk T. A deep collocation method for the bending analysis of Kirchhoff Plate. Computers, Materials and Continua, 2019, 59(2): 433–456

[10] Hong J, Chen X, Wang T F, Ma Y. Optimization of dynamics of non-continuous rotor based on model of rotor stiffness. Mechanical Systems and Signal Processing, 2019, 131: 166–182

[11] Weder M, Horisberger B, Monette C, Sick M, Dual J. Experimental modal analysis of disk-like rotor-stator system coupled by viscous liquid. Journal of Fluids and Structures, 2019, 88: 198–215

[12] Chipato E, Shaw A D, Friswell M I. Frictional effects on the nonlinear dynamics of an overhung rotor. Communications in Nonlinear Science and Numerical Simulation, 2019, 78: 104875

[13] Saxena A, Chouksey M, Parey A. Measurement of FRFs of coupled geared rotor system and the development of an accurate finite element model. Mechanism and Machine Theory, 2018, 123: 66–75

[14] Sharan A S, Somashekhar S H, Venkatesha C S, Karunanidhi S. Investigation on the critical parameters affecting the working design dynamics of a torque motor employed in an electro-hydraulic servovalve. Simulation, 2019, 95(1): 31–49

[15] Yadav H K, Upadhyay S H, Harsha S P. Study of effect of unbalanced forces for high speed rotor. Procedia Engineering, 2013, 64: 593–602

[16] Shad M R, Michon G, Berlioz A. Modeling and analysis of nonlinear rotordynamics due to higher order deformation bending. Applied Mathematical Modelling, 2011, 35(5): 2145–2159

[17] Gunter E J. Understanding amplitude and phase in rotating machinery RODYN vibration analysis. In: Vibration Institute 33rd Annual Meeting. Harrisburg, PA: Vibration Institute, 2009

[18] RK-4 Rotor Kit. Bently Nevada Asset Condition Monitroing. Minden, Nevada, 1631

[19] Ginsperg J. Advanced Engineering Dynamics. 2nd ed. Cambridge: Cambridge University Press, 1998

[20] Yukio I, Toshio Y. Linear and Nonlinear Rotordynamics: A Modern Treatment with Applications. 2nd ed. Wiley-VCH Verlag & Co., 2012

[21] Butterworth J, Lee J H, Davidson B. Experimental determination of modal damping form full scale testing. In: The 13th World Conference on Earthquake Engineering. Bently Parkway South, 2004

[22] Singh B, Nanda B K. Estimation of damping in layered welded structures with unequal thickness. Shock and Vibration, 2012, 19(6): 1463–1475

[23] API 670. American Petroleum Institute Standard, Machinery Protection Systems. 5th ed. 2014

[24] Littler J D. An assessment of some of the different methods for estimating damping from full Scale testing. Journal of Wind Engineering and Industrial Aerodynamics, 1995, 57(2–3): 179–189

[25] Apuzzo A, Barretta R, Faghidian S A, Luciano R, Marotti de Sciarra F. Free vibrations of elastic beams by modified nonlocal strain gradient theory. International Journal of Engineering Science, 2018, 133: 99–108

[26] Barretta R, Čanađija M, Luciano R, de Sciarra F M. Stress-driven modeling of nonlocal thermoelastic behavior of nanobeams. International Journal of Engineering Science, 2018, 126: 53–67

[27] Barretta R, Ali Faghidian S, Luciano R, Medaglia C M, Penna R. Stress-driven two-phase integral elasticity for torsion of nano-beams. Composites. Part B, Engineering, 2018, 145: 62–69

[28] Apuzzo A, Barretta R, Luciano R, Marotti de Sciarra F, Penna R. Free vibrations of Bernoulli-Euler nano-beams by the stress-driven nonlocal integral model. Composites. Part B, Engineering, 2017, 123: 105–111

[29] Beer F B, Russell Johnston Jr. E, DeWolf J T, Mazurek D F. Mechanics of Materials. 7th ed. McGraw-Hill Education, 2014

[30] Kelm R D. Journal Bearing Analysis. Oak Brook: Vibration Institute Publications, 2004

[31] Nicholas J C, Barrett L E. The effect of bearing support flexibility on critical speed prediction. ASLE Transactions, 1986, 29(3): 329–338

[32] Abduljabbar Z, ElMadany M M, Al-Bahkali E. On the vibration and control of a flexible rotor mounted on fluid film bearings. Journal of Computers and Structures, 1997, 65(5): 849–856

RIGHTS & PERMISSIONS

Higher Education Press