Analytical study on damping performances of magnetorheological grease damper based on disk squeeze mode and experimental test

Abstract

In this paper, a small displacement-type magnetorheological grease (MRG) damper based on disk squeeze mode is proposed. The squeeze flow differential equation is obtained. The Navier slip condition is considered on the surfaces and the boundary compatible condition is established. The radial velocity profiles and the radial pressure distributions are derived respectively, and the mathematical stress expression is calculated. To verify rationality of analytical method, the MRG damper is designed and fabricated according to the technical requirements of an engine vibration isolation system. The experimental damping force from MTS870 Electro-hydraulic Servo with sine wave excitation shows that the proposed analytical method is feasible and provides the reference value for designing MRG damper based on disk squeeze mode.

Keywords

magnetorheological grease (MRG) / damper / squeeze model

References

[1] Bird R B, Armstrong R C, Hassager O. Dynamics of Polymeric Liquids. New York: Wiley, 1977, 19-21

[2] Scott J R. Theory and application of the parallel plate viscometer. Trans Inst Rubber Ind, 1931, 7(2): 169-186

[3] Gartling D K, Phan-Thien N. A numerical simulation of a plastic fluid in a parallel-plate plastometer. Journal of Non-Newtonian Fluid Mechanics, 1984, 14: 347-360

[4] Davis A M J, Frenkel A L. Cylindrical liquid bridges squeezed between parallel plates: exact Stokes flow solutions and hydrodynamic forces. Phys Fluids A, 1992, 4(6): 1105-1109

[5] Laun H M, Rady M, Hassager O. Analytical solutions for squeeze flow with partial wall ship. Journal of Non-Newtonian Fluid Mechanics, 1999, 81(1-2): 1-15

[6] Roussel N, Lanos C, Toutou Z. Identification of Bingham fluid flow parameters using a simple squeeze test. Journal of Non-Newtonian Fluid Mechanics, 2006, 135(1): 1-7

[7] Kalyon D M, Tang H S. Inverse problem solution of squeeze flow for parameters of generalized Newtonian fluid and wall slip. Journal of Non-Newtonian Fluid Mechanics, 2007, 143(2-3): 133-140

[8] Vishwanath K P, Kandasamy A. Inertia effects in circular squeeze film bearing using Herschel-Bulkley lubricants. Applied Mathematical Modelling, 2010, 34(1): 219-227

[9] Zhu K Q, Ge R. Squeezing flow of electrorheological fluid between two circular plates. Journal of Tsinghua University (Sci & Tech), 1999, 39(8): 80-83

[10] Yang S P, Zhu K Q. Note on a paper by Laun: The squeeze force for a power law fluid.Journal of Non-Newtonian Fluid Mechanics, 2005, 132(1-3): 84-85

[11] Xu C H, Huang W B, Xu Y. Squeeze flow of Bingham fluid between two parallel disks with wall slip. Journal of China Agricultural University, 2003, 8(2): 7-10

[12] Pinkus O, Sternlicht B. Theory of Hydrodynamic Lubrication. New York: McGraw Hill, 1961

RIGHTS & PERMISSIONS

Higher Education Press and Springer-Verlag Berlin Heidelberg