Migration of manganese and iron during the adsorption-regeneration cycles for arsenic removal

Abstract

Fe-Mn binary oxide incorporated into porous diatomite (FMBO-diatomite) was prepared in situ and regenerated in a fixed-bed column for arsenite [As(III)] and arsenate [As(V)] removal. Four consecutive adsorption cycles were operated under the following conditions: Initial arsenic concentration of 0.1 mg·L^-1, empty bed contact time of 5 min, and pH 7.0. About 3000, 3300, 3800, and 4500 bed volumes of eligible effluent (arsenic concentration≤0.01 mg·L^-1) were obtained in four As(III) adsorption cycles; while about 2000, 2300, 2500, and 3100 bed volumes of eligible effluent were obtained in four As(V) adsorption cycles. The dissection results of FMBO-diatomite fixed-bed exhibited that small amounts of manganese and iron were transferred from the top of the fixed-bed to the bottom of the fixed-bed during As(III) removal process. Compared to the extremely low concentration of iron (<0.01 mg·L^-1), the fluctuation concentration of Mn²⁺ in effluent of the As(III) removal column was in a range of 0.01–0.08 mg·L^-1. The release of manganese suggested that manganese oxides played an important role in As(III) oxidation. Determined with the US EPA toxicity characteristic leaching procedure (TCLP), the leaching risk of As(III) on exhausted FMBO-diatomite was lower than that of As(V).

Keywords

arsenic / adsorption / filtration / regeneration / fixed-bed

References

[1] Yoshida T, Yamauchi H, Fan Sun G. Chronic health effects in people exposed to arsenic via the drinking water: Dose-response relationships in review. Toxicology and Applied Pharmacology, 2004, 198(3): 243–252

[2] Lee Y, Um I H, Yoon J. Arsenic(III) oxidation by iron(VI) (ferrate) and subsequent removal of arsenic(V) by iron(III) coagulation. Environmental Science & Technology, 2003, 37(24): 5750–5756

[3] Gholami M M, Mokhtari M A, Aameri A, Alizadeh Fard M R. Application of reverse osmosis technology for arsenic removal from drinking water. Desalination, 2006, 200(1-3): 725–727

[4] Di Natale F, Erto A, Lancia A, Musmarra D. Experimental and modelling analysis of As(V) ions adsorption on granular activated carbon. Water Research, 2008, 42(8-9): 2007–2016

[5] Sarkar S, Blaney L M, Gupta A, Ghosh D, Sengupta A K. Arsenic removal from groundwater and its safe containment in a rural environment: Validation of a sustainable approach. Environmental Science & Technology, 2008, 42(12): 4268–4273

[6] Smedley P L, Kinniburgh D G. A review of the source, behaviour and distribution of arsenic in natural waters. Applied Geochemistry, 2002, 17(5): 517–568

[7] Lin T F, Wu J K. Adsorption of arsenite and arsenate within activated alumina grains: Equilibrium and kinetics. Water Research, 2001, 35(8): 2049–2057

[8] Richmond W R, Loan M, Morton J, Parkinson G M. Arsenic removal from aqueous solution via ferrihydrite crystallization control. Environmental Science & Technology, 2004, 38(8): 2368–2372

[9] Banerjee K, Amy G L, Prevost M, Nour S, Jekel M, Gallagher P M, Blumenschein C D. Kinetic and thermodynamic aspects of adsorption of arsenic onto granular ferric hydroxide (GFH). Water Research, 2008, 42(13): 3371–3378

[10] Katsoyiannis I A, Ruettimann T, Hug S J. pH dependence of Fenton reagent generation and As(III) oxidation and removal by corrosion of zero valent iron in aerated water. Environmental Science & Technology, 2008, 42(19): 7424–7430

[11] Chang F F, Qu J H, Liu H J, Liu R P, Zhao X. Fe-Mn binary oxide incorporated into diatomite as an adsorbent for arsenite removal: preparation and evaluation. Journal of Colloid and Interface Science, 2009, 338(2): 353–358

[12] Chang F F, Qu J H, Liu R P, Zhao X, Lei P J. Practical performance and its efficiency of arsenic removal from groundwater using Fe-Mn binary oxide. Journal of Environmental Sciences (China), 2010, 22(1): 1–6

[13] Jessen S, Larsen F, Koch C B, Arvin E. Sorption and desorption of arsenic to ferrihydrite in a sand filter. Environmental Science & Technology, 2005, 39(20): 8045–8051

[14] Leupin O X, Hug S J, Badruzzaman A B M. Arsenic removal from Bangladesh tube well water with filter columns containing zerovalent iron filings and sand. Environmental Science & Technology, 2005, 39(20): 8032–8037

[15] US EPA. Hazardous waste management system; Identification and listing of hazardous waste; toxicity characteristics revisions; final rule. Federal Register, 1990, 55(61): 11798–11877

[16] Zhang G S, Qu J H, Liu H J, Liu R P, Li G T. Removal mechanism of As(III) by a novel Fe-Mn binary oxide adsorbent: Oxidation and sorption. Environmental Science & Technology, 2007, 41(13): 4613–4619

[17] Ministry of Health of China and Standardization Administration of China. Standard for Drinking Water Quality (GB 5749-2006), 2007, 7

[18] Moore J N, Walker J R, Hayes T H. Reaction scheme for the oxidation of As(III) to As(V) by birnessite. Clays and Clay Minerals, 1990, 38(5): 549–555

[19] Chang Y Y, Song K H, Yang J K. Removal of As(III) in a column reactor packed with iron-coated sand and manganese-coated sand. Journal of Hazardous Materials, 2008, 150(3): 565–572

[20] Manning B A, Fendorf S E, Bostick B, Suarez D. Arsenic(III) oxidation and arsenic(V) adsorption reactions on synthetic birnessite. Environmental Science & Technology, 2002, 36(5): 976–981

RIGHTS & PERMISSIONS

Higher Education Press and Springer-Verlag Berlin Heidelberg