Transition metal sulfides are commonly studied as photocatalysts for water splitting in solar-to-fuel conversion. However, the effectiveness of these photocatalysts is limited by the recombination and restricted light absorption capacity of carriers. In this paper, a broad spectrum responsive In₂S₃/Bi₂S₃ heterojunction is constructed by in-situ integrating Bi₂S₃ with the In₂S₃, derived from an In-MOF precursor, via the high-temperature sulfidation and solvothermal methods. Benefiting from the synergistic effect of wide-spectrum response, effective charge separation and transfer, and strong heterogeneous interfacial contacts, the In₂S₃/Bi₂S₃ heterojunction demonstrates a rate of 0.71 mmol/(g∙h), which is 2.2 and 1.7 times as much as those of In₂S₃ (0.32 mmol/(g∙h) and Bi₂S₃ (0.41 mmol/(g∙h)), respectively. This paper provides a novel idea for rationally designing innovative heterojunction photocatalysts of transition metal sulfides for photocatalytic hydrogen production.

Metal-free graphitic carbon nitride (g-C₃N₄) has captured significant attention as a low-cost and efficient hydrogen production photocatalyst through. Effectively regulating the microstructure and accelerating the separation of photogenerated carriers remain crucial strategies for promoting the photocatalytic performance of this material. Herein, a novel sulfur–carbon co-doped g-C₃N₄ (SCCN) hierarchical microtubules filled with abundant nanosheets inside by thermal polymerization is reported. Numerous nanosheets create abundant pores and cavities inside the SCCN microtubes, thereby increasing the specific surface area of g-C₃N₄ and providing sufficient reactant attachment sites. Besides, the hierarchical structure of SCCN microtubules strengthens the reflection and scattering of light, and the utilization of visible light is favorably affected. More importantly, co-doping S and C has greatly improved the photocatalytic performance of graphitic carbon nitride, optimized the band gap structure and enhanced the photogenerated carrier splitting. Consequently, the SCCN exhibits a remarkable photocatalytic H₂ evolution rate of 4868 μmol/(g·h). This work demonstrates the potential of multi-nonmetal doped g-C₃N₄ as the ideal photocatalyst for H₂ evolution.

It has been widely reported that, for faceted nanocrystals, the two adjacent facets with different band levels contribute to promoted charge separation, and provide active sites for photocatalytic reduction and oxidation reaction, respectively. In such cases, only one family of facets can be used for photocatalytic hydrogen evolution. Herein, by using SrTiO₃ nanocrystals enclosed by {023} and {001} facets as a model photocatalyst, this paper proposed a strategy to achieve the full-facets-utilization of the nanocrystals for photocatalytic hydrogen via chemically depositing Pt nanoparticles on all facets. The photo-deposition experiment of CdS provided direct evidence to demonstrate that the {023} facets which were responsible for photooxidation reaction can be function-reversed for photocatalytic hydrogen evolution after depositing Pt nanoparticles, together with the {001} facets. Thus, the full-facets-utilization led to a much-improved activity for photocatalytic hydrogen, in contrast to those SrTiO₃ nanocrystals with only {001} facets deposited by Pt nanoparticles via a photo-deposition method.

Hydrogen production from photoelectrochemical (PEC) water splitting has been regarded as a promising way to utilize renewable and endless solar energy. However, semiconductor film grown on photoelectrode suffers from numerous challenges, leading to the poor PEC performance. Herein, a straightforward sol-gel method with the ligand-induced growth strategy was employed to obtain dense and homogeneous copper bismuthate photocathodes for PEC hydrogen evolution reaction. By various characterizations, it was found that the nucleation and surface growth of CuBi₂O₄ layer induced by 2-methoxyethanol ligand (2-CuBi₂O₄) demonstrated a decent crystallinity and coverage, as well as a large grain size and a low oxygen vacancy concentration, leading to the good ability of light absorption and carrier migration. Consequently, under simulated sunlight irradiation (AM1.5G, 100 mW/cm²), the 2-CuBi₂O₄ photocathode achieved an enhanced photocurrent density of −1.34 mA·cm⁻² at 0.4 V versus the reversible hydrogen electrode and a promising applied bias photon-to-current efficiency of 0.586%. This surface modification by ligand growth strategy will shed light on the future design of advanced photoelectrodes for PEC water splitting.

Electrocatalytic CO₂ reduction (ECR) offers an attractive approach to realizing carbon neutrality and producing valuable chemicals and fuels using CO₂ as the feedstock. However, the lack of cost-effective electrocatalysts with better performances has seriously hindered its application. Herein, a one-step co-electrodeposition method was used to introduce Zn, a metal with weak *CO binding energy, into Cu to form Cu/Zn intermetallic catalysts (Cu/Zn IMCs). It was shown that, using an H-cell, the high Faradaic efficiency of C₂₊ hydrocarbons/alcohols ({\mathrm{F}\mathrm{E}}_{{\mathrm{C}}_{2+}}) could be achieved in ECR by adjusting the surface metal components and the applied potential. In suitable conditions, FE_C2+ and current density could be as high as 75% and 40 mA/cm², respectively. Compared with the Cu catalyst, the Cu/Zn IMCs have a lower interfacial charge transfer resistance and a larger electrochemically active surface area (ECSA), which accelerate the reaction. Moreover, the *CO formed on Zn sites can move to Cu sites due to its weak binding with *CO, and thus enhance the C–C coupling on the Cu surface to form C₂₊ products.

Sunlight-powered water splitting presents a promising strategy for converting intermittent and virtually unlimited solar energy into energy-dense and storable green hydrogen. Since the pioneering discovery by Honda and Fujishima, considerable efforts have been made in this research area. Among various materials developed, Ga(X)N/Si (X = In, Ge, Mg, etc.) nanoarchitecture has emerged as a disruptive semiconductor platform to split water toward hydrogen by sunlight. This paper introduces the characteristics, properties, and growth/synthesis/fabrication methods of Ga(X)N/Si nanoarchitecture, primarily focusing on explaining the suitability as an ideal platform for sunlight-powered water splitting toward green hydrogen fuel. In addition, it exclusively summarizes the recent progress and development of Ga(X)N/Si nanoarchitecture for photocatalytic and photoelectrochemical water splitting. Moreover, it describes the challenges and prospects of artificial photosynthesis integrated device and system using Ga(X)N/Si nanoarchitectures for solar water splitting toward hydrogen.