Numerical study on formation blockage and back-pumping during geothermal water reinjection in weakly consolidated heterogeneous reservoirs using a novel mechanism model

Abstract

For the utilization of low-medium temperature geothermal water, the well injection capacity for tail water disposal is often reduced due to the migration of self-generated particles and the invasion of suspended particles, especially in weakly consolidated sandstone reservoirs. In this paper, a novel mechanism model of formation blockage and recovery by back-pumping during geothermal water reinjection was established based on the classification and bridging principle of movable particles in porous media. The model validity was confirmed by fitting the field tests in Xining Basin, China. Then a comprehensive sensitivity analysis of influencing factors was conducted based on the model using a numerical simulation method. The results show that in a weakly consolidated heterogeneous reservoir, a series of preferential seepage channels and low-permeability zones will be formed between reinjection and production wells due to the migration and precipitation of different types of movable particles. The blockage mainly occurs in the formation within 30 m away from the reinjection well. The self-generated and invasive coarse particles are the dominant factor to cause blockage. Back-pumping is an effective method to relieve the blockage in the formation near the well. The well reinjection capacity can be restored to larger than 70% of the initial. This established mechanism model can be an effective means to investigate the particle movement law in geothermal development.

Keywords

Particle migration / Formation blockage / Back-pumping / Mechanism model / Sensitivity analysis

References

[1] J. Liu, The status of geothermal reinjection, Hydrogeol. Eng. Geol. 30 (3) (2003) 100-104 (in Chinese with English abstract).

[2] L. Zhang, J. Ezekiel, D. Li, J. Pei, S. Ren, Potential assessment of CO₂ injection for heat mining and geological storage in geothermal reservoirs of China, Appl. Energy 122 (2014) 237-246.

[3] L. Zhang, X. Li, Y. Zhang, G. Cui, C. Tan, S. Ren, CO₂ injection for geothermal development associated with EGR and geological storage in depleted high-temperature gas reservoirs, Energy 123 (2017) 139-148.

[4] H. Yang, Z. Lv, L. Wang, C. Feng, J. Wang, Z. Xu, Y. Huang, Z. Li, W. Kang, Stability mechanism of controlled acid-resistant hydrophobic polymer nanospheres on CO₂ foam, Fuel 346 (2023) 128332.

[5] E. Kaya, S.J. Zarrouk, M.J. O'Sullivan, Reinjection in geothermal fields: a review of worldwide experience, Renew. Sustain. Energy Rev. 15 (1) (2011) 47-68.

[6] L. Zhang, S. Geng, J. Chao, Z. Zhao, Y. Luo, H. Chen, G. Qin, Corrosion risk assessment of geothermal reinjection wellbore in Xining Basin, China, Geothermics 90 (2021) 101995.

[7] P. Seibt, T. Kellner, Practical experience in the reinjection of cooled thermal waters back into sandstone reservoirs, Geothermics 32 (4-6) (2003) 733-741.

[8] H. Bouwer, Role of groundwater recharge in treatment and storage of wastewater for reuse, Water Sci. Technol. 24 (9) (1991) 295-302.

[9] A. Kalantariasl, K. Schulze, J. Storz, C. Burmester, S. Küenckeler, Z. You, A. Badalyan, P. Bedrikovetsky, Produced water re-injection and disposal in low permeable reservoirs, J. Energy Resour. Technol. 141 (2019) 072905.

[10] P. Seibt, F. Kabus, M. Wolfgramm, J. Bartels, A. Seibt, Monitoring of hydrogeothermal plants in Germany: an overview, in: Proceedings of World Geothermal Conference, 2010. Bali (Indonesia), April 25-29.

[11] J. Wu, J. Zhang, X. Li, F. Shi, P. Zhang, M. Bai, Experiment on artificial pressure reinjection of geothermal water in Xian suburb. J. Water Resour, Water Eng. 25 (5) (2014) 215-218 (in Chinese with English abstract).

[12] J. Lin, X. Liu, B. Gao, X. Wang, Analyses and discussion on geothermal reinjection test in Tianjin, J. H. Polytech. Univ. 25 (3) (2006) 200-204 (in Chinese with English abstract).

[13] M. Marquez, W. Williams, M. Knobles, P. Bedrikovetsky, Z. You, Fines migration in fractured wells: integrating modeling with field and laboratory data, SPE Prod. Oper. 29 (4) (2014) 309-322.

[14] Z. Zhao, G. Qin, Y. Luo, S. Geng, L. Yang, R. Wen, J. Chao, L. Zhang, Experimental study on reservoir physical properties and formation blockage risk in geothermal water reinjection in Xining Basin: taking well DR2018 as an example, Energies 14 (9) (2021) 2671.

[15] L. Zhang, S. Geng, J. Chao, L. Yang, Z. Zhao, G. Qin, S. Ren, Scaling and blockage risk in geothermal reinjection wellbore: experiment assessment and model prediction based on scaling deposition kinetics, J. Pet. Sci. Eng. 209 (2022) 109867.

[16] P. Sandrine, V. Francois, N. Patrick, Chemical stimulation techniques for geothermal wells: experiments on the three-well EGS system at Soultz-sous-Forêts, France, Geothermics 38 (2009) 349-359.

[17] Z. Zhao, Analysis on the change mechanism of temporary blockage in recharge well and its removal process, Hydrogeol. Eng. Geol. 5 (1988) 39-42 (in Chinese with English abstract).

[18] M. Sun, J. Zhang, J. Wei, Experimental research on pumping lifting from gravity artificial recharge well of underground water source heat pump system, Gas Heat 29 (8) (2009) 1-4 (in Chinese with English abstract).

[19] K.C. Khilar, H.S. Fogler, Migration of Fines in Porous Media, Kluwer: Academic Publishers, 1998.

[20] N. Tufenkji, Modeling microbial transport in porous media: traditional approaches and recent developments, Adv. Water Resour. 30 (6) (2007) 1455-1469.

[21] S. Jafari, M. Salmanzadeh, M. Rahnama, G. Ahmadi, Investigation of particle dispersion and deposition in a channel with a square cylinder obstruction using the lattice Boltzmann method, J. Aerosol Sci. 41 (2) (2010) 198-206.

[22] P. Sun, H. Song, J. Qi, J. Wang, Z. Xu, M. Yuan, Study on sand control techniques for loose sandstone geothermal wells in Guantao formation of Neogene, Sci. Technol. Innov. 6 (2019) 12-14 (in Chinese with English abstract).

[23] Z. You, A. Badalyan, Y. Yang, P. Bedrikovetsky, M. Hand, Fines migration in geothermal reservoirs: laboratory and mathematical modelling, Geothermics 77 (2019) 344-367.

[24] Y. Yang, W. Yuan, J. Hou, Z. You, Review on physical and chemical factors affecting fines migration in porous media, Water Res. 214 (2022) 118172.

[25] L. Zhang, J. Chao, S. Geng, Z. Zhen, H. Chen, Y. Luo, G. Qin, Particle migration and blockage in geothermal reservoirs during water reinjection: laboratory experiment and reaction kinetic model, Energy 206 (2020) 118234.

[26] L. Zhang, S. Geng, L. Yang, R. Wen, C. He, Z. Zhao, G. Qin, Formation blockage risk analysis of geothermal water reinjection: rock property analysis, pumping and reinjection tests, and long-term reinjection prediction, Geosci. Front. 13 (2021) 101299.

[27] Z. Zhao, G. Qin, Y. Luo, J. Chao, S. Geng, L. Zhang, Characteristics of geothermal water in the Xining Basin and risk of reinjection scaling, Hydrogeol. Eng. Geol. 48 (5) (2021) 193-204 (in Chinese with English abstract).

[28] J. Chao, Study on Risk Assessment of Formation Blockage in Geothermal Water Reinjection in Xining Basin, China University of Petroleum (East China), Qingdao, 2021 (in Chinese with English abstract).

[29] S. Geng, Numerical Study on Blockage Mechanism and Reinjection Recovery of Mid-low Temperature Geothermal Water, China University of Petroleum (East China), Qingdao, 2022 (in Chinese with English abstract).

[30] P.C. Carman, Fluid flow through granular beds, Trans. Inst. Chem. Eng. 15 (1937) 150-166.

[31] CMG, Manual of Advanced Process and Thermal Reservoir Simulator (STARS), Computer Modeling Group, Calgary, 2015.

[32] L. Zhang, R. Feng, S. Geng, M. Meng, X. Li, B. Ren, F. Yan, Influence of geological structures on the hydrate accumulation in the subsea shallow formations, J. Nat. Gas Sci. Eng. 90 (2021) 103897.

[33] Tianjin Land Resources and Housing Administration, Operating Regulations for Geothermal Reinjection Operation in Tianjin, 2006 (in Chinese).

[34] J. Yin, Dynamic analysis and research on geothermal development in Leling area, S, Technol. Innov. Appl. 6 (2020) 65-66 (in Chinese with English abstract).

[35] H. Wang, J. Xiong, Y. Tang, Current situation and development trend of sand control and completion technology abroad, Sov. Chem. Ind. 43 (4) (2014) 69-70 (in Chinese).

[36] L. Wang, A Study of Geothermal Reinjection in the Guantao Reservoir in Tianjin, China University of Geosciences, Beijing, 2014 (in Chinese with English abstract).

[37] X. Ren, X. Gao, Study on sand retaining effect of filter screen mesh in geothermal well, Nat. Gas Oil 36 (5) (2018) 69-74 (in Chinese with English abstract).

[38] R.G. Pasikki, F. Libert, K. Yoshioka, R. Leonard, Well stimulation techniques applied at the Salak geothermal field, in: Proceedings of the World Geothermal Congress, Bali, 2010 (Indonesia), April 25-29.

[39] L. Zhang, S. Geng, J. Kang, J. Chao, L. Yang, F. Yan, Experimental study on the heat exchange mechanism in a simulated self-circulation wellbore, Energies 13 (11) (2020) 2918.

[40] L. Zhang, L. Yang, S. Geng, S. Ren, Comparative experiment of wellbore self-circulation heat mining capacity with different heat-carrying fluids, Lithosphere S5 (2021) 2953458.