Simulation studies on optimizing oil productivity in oil rim reservoirs under gas cap blow down production strategy

Abstract

Gas cap blow down strategy is normally deployed for Ultra-thin oil rim reservoirs with huge gas caps due to extremely high gas oil ratios from wells in such reservoirs. The current state leads to loss of production from the oil reserves due to high initial reservoir pressure thus, reducing its net present value. Data on important factors essential to the productivity of oil rim reservoirs are used to build a heterogeneous ultra-thin reservoir with a time step of 10,000 days using the Eclipse software and its embedded correlations. The reservoir is subjected to a gas cap blowdown via a gas well, then an oil well is initiated into the model at onset and after time periods of 2000 days, 4000 days, 6000 days and 8000 days to estimate the oil recovery. It is expected that due to the large nature of the gas cap, pressure decline will be drastic and leading to a low oil recovery, hence the injection of water and gas at different rates at the periods indicated. The results indicate an oil recovery of 4.3% during gas cap blow down and 10.34% at 6000 days. Peak oil recoveries of 12.64% and 10.80% are estimated under 30,000 Mscf/day at 4000 days and 1000 stb/day at 6000 days respectively. This shows an incremental oil recovery of 8.34% and 6.5% over that recorded during gas cap blow down. The results also indicate that the gas production at those periods was not greatly affected with an estimated increment of 257 Bscf recorded during 30,000 Mscf/day at 4000 days. All secondary injection schemes at the respective time steps had positive impact on the overall oil recoveries. It is recommended that extra production and injection wells be drilled, enhanced oil recovery options and injection patterns be considered to further increase oil recovery.

Keywords

Oil rim / Gas cap blow down / Water and gas injection / Oil recovery factor

References

[1] S. Kolbikov,Peculiarities of Thin Oil Rim Development Paper SPE160678 Presented at the SPE Russian Oil and Gas Exploration and Production Technical Conference and Exhibition, vol. 16, Russia, Moscow, 2012.

[2] Masoudi Rahim, How to Get the Most Out of Your Oil Rim Reservoir, 2012. SP--39548.

[3] A.L. Kazeem, A.W. Inewari, O.A. Ademola, Preliminary Assessment of Oil-Rim Reservoirs: A Review of Current Practices and Formulation of New Concepts. Nigeria Annual International Conference and Exhibition, 2010. Calabar:SPE-136955-MS.

[4] O.A. Olabode, O.D. Orodu, S. Isehunwa, A. Mamudu, T. Rotimi, Effect of foam and WAG (water alternating gas) injection on performance of thin oil rim reservoirs, J. Petrol. Sci. Eng. 171 (2018a) 1443-1454.

[5] C. Cosmos, O. Fatoke, Challenges of gas development: Soku field oil rim Reservoirs,in: Annual International Conference and Exhibition, 2004. Abuja, SPE-88894.

[6] U. Iyare, J. Marcelle-De silva,Effect of gas cap and aquifer strenght on the optimal well location for thin oil rim reservoirs, in:SPETT 2012 Energy Conference and Exhibition, 2012. Port of Spain, Trinidad.

[7] O. Olamigoke, A. Peacock, First pass screening of reservoirs with large gas caps for oil rim development, in: 33rd Annual SPE Technical Conference and Exhibition, Abuja, 2012. SP--128603.

[8] S. Ibukun, Evaluation of Oil Rim Reservoirs Development e A Case Study, Master of Science Thesis of the University of Ibadan, Department of Petroleum Engineering, 2011.

[9] O.A. Olabode, G. Egeonu, T. Ojo, O. Oguntade, Bamigboye O production forecast for Niger delta oil rim synthetic reservoirs, Data Brief 19 (2018c) 2205-2214.

[10] C. Kabir, A. Chawathe, S. Jenkins, A. Olayomi, C. Aigbe, Developing New Fields Using Probabilistic Reservoir Forecasting, 2002. OnePetro SPE-87643-MS.

[11] B. Obah, Simplified models for forecasting oil production: Niger delta oil rim reservoirs case, Petrol. Technol. Dev. J. 2 (2) (2012).

[12] Oluwasanmi Olabode, Emmanuel Etim, Okoro Emeka, Ogunkunle Tope, Victoria Abraham, Onuh Charles, Predicting post breakthrough performance of water and gas coning, Int. J. Mech. Eng. Technol. 10 (2) (2019).

[13] B.T. Hauge, W.I. Ferguson,T. Kydland, A.S. Norsk Hydro, Horizontal wells in the water zone: the most effective way of tapping oil from thin oil zones?, TX, October, in:66th Annual Technical Conference and Exhibition of the Society of Petroleum Engineers Held in Dallas, 1991, pp. 6-9. SPE 22929.

[14] Oluwasanmi Olabode, Gerald Egeonu, Temiloluwa Ojo, Oreofeoluwa Bamigboye, Predicting the effect of well trajectory and production rates on concurrent oil and gas recovery from thin oil rims, IOP Conf. Ser. Mater. Sci. Eng. 413 (1) (2018b), 012051.

[15] S.C. Keng, R. Masoudi, H. Kartooti, R. Shaedin, M.B. Othman, Petronas, Smart horizontal well drilling and completion for effective development of thin oil rim reservoirs in Malaysia, International petroleum technology conference, Kuala Lumpur, December (2014) 10-12.

[16] S.O. Ogiriki, G.O. Imonike, N.O. Ogolo, M.O. Onyekonwu, Optimum well type for oil rim reservoirs with large gas cap and strong aquifer, in: SPE-193411-MS, Annual International Conference of the SPE August 6-8, Lagos, Nigeria, 2018.

[17] D. Sharraqd, B. Brice, D. MacDonald,Application of horizontal wells at Prudhoe Bay. New Orleans: annual technical conference and exhibition, SPE-15376-MS, J. Petrol. Technol. 39 (11) (1986).

[18] V. Mangrove, K. Sandarusi, A. Schmalz, G. Schut, P. Nucharoen, Improved oil recovery through the use of horizontal well in thin oil column: a case study from platong field, Gulf of Thailand, in:Asia Pacific Oil and Gas Conference and Exhibition, 2003. Jakarta, Indonesia. SPE-80475-MS.

[19] H.M. Mackow, J. Trujillo, A. Stephen, Finding new limits with horizontal wells in a thin oil column in the Mahogany Gas Field, in: Trinidad: Latin America and Caribbean Petroleum Engineering Conference, Offshore Trinidad, 2003, pp. 1-14.

[20] K. Seines, S. Lien, B. Haug, Troll Horizontal Well Tests Demonstrates Large Production Potentials from Thin Oil Zones, SPE international meeting on petroleum engineering Beijing, 1992. SPE 22373.

[21] Effect of horizontal well length variation on productivity of gas condensate well, Olabode O. A. And Egeonu G. I, Int. J. Appl. Eng. Res ISSN 12 (20) (2017) 9271-9284, 0973-4562.

[22] H. Irrgang, Evaluation and management of thin oil column reservoir in Australia, Australian Petroleum Production And Exploration Association 34 ( 1) (1994) 64-78.

[23] A. Uwaga, A. Lawal, Concurrent gas cap and oil-rim production: the swing gas option,in: Spe Annual International Conference and Exhibition, 2006, 105985. Abuja. Paper.

[24] V.P. Sascha, N. Marc, Concurrent Oil and Gas Development Wells: A Smart Well Solution to Thin Oil. International Petroleum Technology Conference. Kuala Lumpur. IPTC-12344-MS, 2008.

[25] K. Lawal, A. Inewari, A. Adenuga, Preliminary assessment of oil rim reservoirs: a review of current practices and formulation of new concepts,in:34th Annual SPE International Conference and Exhibition, Tinapa, Calabar, SPE-136995-MS, 2010.

[26] Olabode Oluwasanmi Effect of water and gas injection schemes on synthetic oil rim models, J. Pet. Explor. Prod. Technol. (2020a), https://doi.org/10.1007/s13202-020-00850-3.

[27] Olabode Oluwasanmi, Oyinkepreye Orodu, Isehunwa Sunday, Ake Daniel, Optimizing productivity in oil rims: simulation studies on horizontal well placement under simultaneous oil and gas production, J. Pet. Explor. Prod. Technol. (2020b), https://doi.org/10.1007/s13202-020-01018-9.

[28] R. Masoudi,How to Get the Most Out of Your Oil Rim Reservoirs? Reservoir Management and Hydrocarbon Recovery Enhancement Initiatives, 2013. SPE-16740-MS.

[29] C.S. Kabir, M. Agamini, R.A. Holguin,Production strategy for thin oil columns in saturated reservoirs, in:Spe Annual Technical Conference, 2004, https://doi.org/10.2118/89755-MS. SPE-89755-MS, Abuja.

[30] P. Behrenbrunch,L. Mason, Optimal Oil Field Development of Fields with a Small Gas Cap and Strong Aquifer, 1993. SPE325353.

[31] C. Keng-Seng, M.K. Azmukiff, D. Nasir, Breaking oil recovery limit in Malaysian thin oil rim reservoirs: water inection optimization,in: International Petroleum Technology Conference IPTC-14157-MS OnePetro, 2012.

[32] E. Razak, K. Chan, N. Darman, Breaking oil recovery limit in Malaysian thin oil rim reservoirs: force balance Revisited,in: SPE EUROPEC/EAGE Annual Conference and Exhibition, 2010. Barcelona:SPE-130388-MS.

[33] M. Nagib, I. Ezuka, G. Nasr, Economic Comparison of Intelligent Wells in Simultaneous Production of Oil and Gas Reserves from Single Wellbore, 2011, p. 26. SPE-132925.

[34] D. Vo, S. Witjaksana, S. Waryan, A. Dharmawan, I. Harmawan, M. Okuno, Reservoir management for ultrathin oil colums under gas cap and water support: Attaka field examples, Jakarta, in:SPE Asia Pacific Oil and Gas Conference and Exhibition, 2001, pp. 1-12. SPE 68675).

[35] Ezzem A. Razak, Keng Seng Chan, Nasir Darman,Risk of Losing Oil Reserve by Gas-Cap Gas Production in Malaysian Thin Oil Rim Reservoirs, 2010, https://doi.org/10.2118/132070-MS. Paper presented at the International Oil and Gas Conference and Exhibition in China, Beijing, China, June 2010. SPE-132070-MS.

[36] I. Onyekwu, A. Peacock, S. Matemilola, O. Igiehon, SPE, SPDC, Improving oil recovery from oil rim reservoirs by simultaneous gas and water injection, in: SPE Nigerian Annual International Conference and Exhibition. Abuja: SPE-162956-MS, 2012.

[37] K. Torgier, S. Wennemo, O. Gudmund, H. Norsk, Reservoir Management Aspects of Producing Oil from Thin Oil Rims in the Troll Field. 25th Annual Offshore Technology Conference, OTC-7173-MS, Houston, Texas, 1993.

[38] B. Thang, F. James, D. Raj, S. Carigali, H. Richard, A. Mohamed, Improving oil recovery from thin oil rim by simultaneous down dip gas and up dip water injection-Samarang field, offshore Malaysia,in:Conference at Oil & Gas West Asia, Muscat, 2010. SP--128392.

[39] Olabode Oluwasanmi, Alonge-Niyi Pastor, Onuh Charles, Nwozor Christopher, Orisamika Seyi, Optimizing productivity in oil rims: simulation studies on water and gas injection patterns, Arabian J. Geosci. 11 (3) (2021a) 1461-1474, https://doi.org/10.1007/s12517-021-06945-3.

[40] A.G. Wafaa, G. Ridha, A. Meshal,Designing a simultaneous water alternating gas process for optimizing oil recovery, in:Annual Conference and Exhibition, 2009. Amsterdam, SPE-120375-MS.

[41] Olabode Oluwasanmi, Ogbebor Osabuhien, Onyeka Emmanuela, Belema Felix, The effect of chemically enhanced oil recovery on thin oil rim reservoirs, J. Pet. Explor. Prod. Technol. (2021b), https://doi.org/10.1007/s13202-021-01090-9.

[42] Oluwasanmi Olabode, David Alaigba, Daniel Oramabo, Oreofeoluwa Bamigboye, Modelling low salinity water flooding as a tertiary oil recovery technique, J. Model. Simul. Eng. (2020c), https://doi.org/10.1155/2019/6485826. Article ID-6485826.

[43] D.A. Al-Obaidi, W.J. Al-Mudhafar, A.K. Wojtanowicz, M.S. Al-Jawad, D. Saini, Evaluation of gas and downhole water sink-assisted gravity drainage GDWSAGD process in saturated oil reservoirs with infinite-acting aquifer, Paper presented at the SPE Western Regional Meeting, San Jose, California, USA, https://doi.org/10.2118/195332-MS , 2017.

[44] W. Al-Mudhafar, D.N. Rao, E. McCreery, Evaluation of immiscible CO₂ enhance oil recovery through the CGI, WAG, and GAGD processes in South Rumaila oil field, in: The 79th EAGE Conference and Exhibition, 2017, https://doi.org/10.3997/2214-4609.201701349, 16-19 June), Paris, France.