Three-dimensional DEM investigation of the stress-dilatancy relation of grain-cementing type methane hydrate-bearing sediment

Abstract

In this study, the Discrete Element Method (DEM) was employed to investigate numerically the effects of hydrate cementation and intermediate principal stress on the stress-dilatancy relation of grain-cementing type methane hydrate-bearing sediment (MHBS) by conducting a series of conventional and true triaxial tests. A novel 3D thermo-hydro-mechanical-chemical (THMC) contact model for MHBS was employed. The numerical results show that with increasing hydrate saturation and back pressure, or decreasing confining pressure, temperature and salinity, the stress-dilation relation of grain-cementing type MHBS evolves from dilation-dominant to bond-dominant. For the clean sand samples, the relationship between the normalized stress ratio η/M_cr and the dilatancy rate d is close under different intermediate principal stress coefficients. However, for the MHBS samples, this relationship is still affected by the intermediate principal stress coefficient b, due to the effect of hydrate cementation.

Keywords

Stress-dilatancy / Cementation / Methane hydrate bearing sediment / Discrete element method / Intermediate principal stress

Declaration of competing interest

We declare that we do not have any commercial or associative interest that represents a conflict of interest in connection with the work submitted.

Acknowledgements

This research was financially supported by the National Natural Science Foundation of China (Grant No.51639008 and No.51890911), and State Key Lab. of Disaster Reduction in Civil Engineering (Grant No. SLDRCE14-A-04), which is greatly appreciated.

References

[1] P. Wu, Y. Li, W. Liu, X. Sun, X. Kong, Y.C. Song, Cementation failure behavior of consolidated gas hydrate-bearing sand, J. Geophys. Res.: Solid Earth 125 (1) (2020), e2019JB018623.

[2] A. Masui, H. Haneda, Y. Ogata, K. Aoki, The effect of saturation degree of methane hydrate on shear strength of synthetic methane hydrate sediments, in: Proceedings of the Fifth International Conference on Gas Hydrates, Curran Assoc., Red Hook, N. Y, 2005, pp. 657-663.

[3] J.C. Santamarina, C. Ruppel, The impact of hydrate saturation on the mechanical, electrical, and thermal properties of hydrate-bearing sand, silts, and clay, in: Proceedings of the 6th International Conference on Gas Hydrates, Canada, Vancouver, 2008, pp. 6-10.

[4] K. Miyazaki, A. Masui, N. Tenma, Y. Ogata, K. Aoki, T. Yamaguchi, Y. Sakamoto, Study on mechanical behavior for methane hydrate sediment based on constant strain-rate test and unloading-reloading test under triaxial compression, Int. J. Offshore Polar Eng. 20 (2010) 61-67.

[5] Y. Song, F. Yu, Y. Li, W. Liu, J. Zhao, Mechanical property of artificial methane hydrate under triaxial compression, J. Nat. Gas Chem. 19 (3) (2010) 246-250.

[6] Y.H. Li, Y.C. Song, W. Liu, F. Yu, Experimental research on the mechanical properties of methane hydrate-ice mixtures, Energies 5 (2) (2012) 181-192.

[7] M. Hyodo, Y. Li, J. Yoneda, Y. Nakata, N. Yoshimoto, A. Nishimura, Y. Song, Mechanical behavior of gas-saturated methane hydrate-bearing sediments, J. Geophys. Res.: solid earth 118 (10) (2013a) 5185-5194.

[8] M. Hyodo, J. Yoneda, N. Yoshimoto, Y. Nakata, Mechanical and dissociation properties of methane hydrate-bearing sand in deep seabed, Soils Found. 53 (2) (2013b) 299-314.

[9] M. Hyodo, N. Yoshimoto, A. Kato, J. Yoneda, Shear strength and deformation of methane hydrate bearing sand with fines, in: Proceedings of the International Conference on Soil Mechanics and Geotechnical Engineering, Paris, France, 2013, pp. 2-6.

[10] T. Luo, Y. Song, Y. Zhu, W. Liu, Y. Liu, Y. Li, Z. Wu, Triaxial experiments on the mechanical properties of hydrate-bearing marine sediments of South China Sea, Mar. Petrol. Geol. 77 (2016) 507-514.

[11] A. Kato, Y. Nakata, M. Hyodo, N. Yoshimoto, Macro and micro behaviour of methane hydrate-bearing sand subjected to plane strain compression, Soils Found. 56 (5) (2016) 835-847.

[12] Z. Liu, S. Dai, F. Ning, L. Peng, H. Wei, C. Wei, Strength estimation for hydratebearing sediments from direct shear tests of hydrate-bearing sand and silt, Geophys. Res. Lett. 45 (2) (2018) 715-723.

[13] S. Kajiyama, Y. Wu, M. Hyodo, Y. Nakata, K. Nakashima, N. Yoshimoto, Experimental investigation on the mechanical properties of methane hydratebearing sand formed with rounded particles, J. Nat. Gas Sci. Eng. 45 (2017) 96-107.

[14] P.B. Kerkar, K. Horvat, K.W. Jones, D. Mahajan, Imaging methane hydrates growth dynamics in porous media using synchrotron X-ray computed microtomography, G-cubed 15 (12) (2014) 4759-4768.

[15] M. Chaouachi, A. Falenty, K. Sell, F. Enzmann, M. Kersten, D. Haberthür, W.F. Kuhs, Microstructural evolution of gas hydrates in sedimentary matrices observed with synchrotron X-ray computed tomographic microscopy, Gcubed 16 (6) (2015) 1711-1722.

[16] K. Sell, E.H. Saenger, A. Falenty, M. Chaouachi, D. Haberthür, F. Enzmann, M. Kersten, On the path to the digital rock physics of gas hydrate-bearing sedimentseprocessing of in situ synchrotron-tomography data, Solid Earth 7 (4) (2016) 1243-1258.

[17] S. Pinkert, Dilation behavior of gas-saturated methane-hydrate bearing sand, Energies 12 (15) (2019) 2937.

[18] P.A. Cundall, O.D. Strack, A discrete numerical model for granular assemblies, Geotechnique 29 (1) (1979) 47-65.

[19] J. Brugada, Y.P. Cheng, K. Soga, J.C. Santamarina, Discrete element modelling of geomechanical behaviour of methane hydrate soils with pore-filling hydrate distribution, Granul. Matter 12 (5) (2010) 517-525.

[20] J.W. Jung, J.C. Santamarina, K. Soga, Stress-strain response of hydrate-bearing sands: numerical study using discrete element method simulations, J. Geophys. Res.: Solid Earth 117 (B4) (2012).

[21] M.J. Jiang, J. He, J.F. Wang, B. Chareyre, F.Y. Zhu, DEM analysis of geomechanical properties of cemented methane hydrateebearing soils at different temperatures and pressures, Int. J. GeoMech. 16 (3) (2015a), 04015087.

[22] M.J. Jiang, F.Y. Zhu, S. Utili, Investigation into the effect of backpressure on the mechanical behavior of methane-hydrate-bearing sediments via DEM analyses, Comput. Geotech. 69 (2015c) 551-563.

[23] Z.F. Shen, M.J. Jiang, DEM simulation of bonded granular material. Part II: extension to grain-coating type methane hydrate bearing sand, Comput. Geotech. 75 (2016) 225-243.

[24] J. Liu, M.J. Jiang, DEM simulation of coexistence type methane hydrate bearing sediments, Environmental Geotechnics (2019) 1-12.

[25] M.J. Jiang, J. Liu, Z.F. Shen, DEM simulation of grain-coating type methane hydrate bearing sediments along various stress paths, Eng. Geol. 261 (2019a) 105280.

[26] J. He, R. Blumenfeld, H.H. Zhu, Mechanical behaviors of sandy sediments bearing pore-filling methane hydrate under different intermediate principal stress, Int. J. GeoMech. 21 (5) (2021), 04021043.

[27] H. Wang, Y. Chen, B. Zhou, S. Xue, Investigation of the effect of cementing ratio on the mechanical properties and strain location of hydrate-bearing sediments by using DEM, J. Nat. Gas Sci. Eng. 94 (2021) 104123.

[28] M.J. Jiang, R.H. Sun, M. Arroyo, W.H. Du, Salinity effects on the mechanical behaviour of methane hydrate bearing sediments: a DEM investigation, Comput. Geotech. 133 (2021) 104067.

[29] M.J. Jiang, Z.F. Shen, J.F. Wang, A novel three-dimensional contact model for granulates incorporating rolling and twisting resistances, Comput. Geotech. 65 (2015b) 147-163.

[30] M.J. Jiang, H.S. Yu, D. Harris, A novel discrete model for granular material incorporating rolling resistance, Comput. Geotech. 32 (5) (2005) 340-357.

[31] M.J. Jiang, A. Zhang, W.H. Du, Discrete element analysis of the fabric evolution of granular soils during cyclic loading, in: International Conference on Discrete Element Methods, Springer, Singapore, 2016, pp. 837-844.

[32] M.J. Jiang, J. Liu, Z.F. Shen, B.L. Xi, Exploring the critical state properties and major principal stress rotation of sand in direct shear test using the distinct element method, Granul. Matter 20 (2) (2018a) 25.

[33] M.J. Jiang, A. Zhang, C. Fu, 3-D DEM simulations of drained triaxial tests on inherently anisotropic granulates, European Journal of Environmental and Civil Engineering 22 (sup1) (2018b) s37-s56.

[34] M.J. Jiang, A. Zhang, T. Li, Distinct element analysis of the microstructure evolution in granular soils under cyclic loading, Granul. Matter 21 (2) (2019b) 21, 39.

[35] M.J. Jiang, A. Zhang, Z.F. Shen, Granular soils: from DEM simulation to constitutive modeling, Acta Geotechnica 15 (2020) 1723-1744.

[36] S.L. Jin, Three Dimensional Experimental and Numerical Study on Micro-and Macro-Mechanical Behaviors of Structural Sands, Tongji University, Shanghai, China., 2016. Ms Thesis. (in Chinese)

[37] Itasca Particle, Flow Code in Three Dimensions (PFC3D), User's Manual, Version 5.0, Itasca Consulting Group, Minneapolis, 2015.

[38] A. Marri, M. Eng, The Mechanical Behaviour of Cemented Granular Materials at High Pressures, University of Nottingham, 2010.