Investigation on lateral seismic isolation system of a typical long-span single-tower cable-stayed bridge for mountainous areas

Abstract

This study focuses on a reasonable lateral isolation system for a typical long-span single-tower cable-stayed bridge with a significantly asymmetric span arrangement that is particularly suitable for mountainous areas. Based on the Jinsha River Bridge, the significant structural asymmetry and its effects on structural seismic responses were analyzed. The significantly asymmetric characteristics could result in complex dynamic behavior in seismic conditions and the lateral seismic responses of the structure are governed by multiple modes. A multilinear model composed of an ideal elastoplastic element and a multilinear elastic element was used to simulate different hysteresis, and a parametric analysis was conducted to investigate the appropriate damping hysteresis for the lateral seismic isolation of such a bridge. It shows that the inverted S-shaped hysteresis has relatively smaller secant stiffness and could help to balance the great difference in the lateral stiffness of the tower/piers. Thus, the inverted S-shaped hysteresis could lead to more efficient damping effects and less base shear forces of the tower/piers. A correlation between the reasonable yield forces of the dampers in the lateral isolation system, determined through an influence matrix-based method, and the shear forces of the corresponding bearings in the lateral fixed system was also observed. Moreover, the influence of geological conditions including different terrain and site conditions on the reasonable lateral isolation system was further investigated. It suggests to use dampers at all tower/pier locations when the side span crosses a steep valley slope, while a lateral isolation system without using dampers at the auxiliary piers could be employed when the side span crosses a gentle valley slope. Soft sites require larger damper yield forces and cause greater seismic responses compared to hard sites.

Graphical abstract

Keywords

single-tower cable-stayed bridge / lateral isolation system / multilinear model / influence matrix / geological conditions

References

[1] GuanZLiJ. Advances in earthquake resisting systems for long-span bridges. Scientia Sinica (Technologica), 2021, 51(5): 493–504 (in Chinese)

[2] Xie W, Sun L. Transverse failure modes and control strategies of super long-span cable-stayed bridge under extreme earthquake. Journal of Vibroengineering, 2017, 19(8): 6152–6169

[3] Bauer K W, Wilson J R. Control-variate selection criteria. Naval Research Logistics, 1992, 39(3): 307–321

[4] XuXLiuWLiLLiSFangH. Optimized earthquake reduction design of cable-stayed bridges. Earthquake Engineering and Engineering Dynamics, 2006, 26(2): 119–124 (in Chinese)

[5] YeAFanL. Lateral constraint systems for super-long-span cable-stayed bridge. China Journal of Highway and Transport, 2007, 20(2): 63–67 (in Chinese)

[6] Hamby D M. A review of techniques for parameter sensitivity analysis of environmental-models. Environmental Monitoring and Assessment, 1994, 32(2): 135–154

[7] Shen Y, Li J, Freddi F, Igarashi A, Zhou J. Numerical investigation of transverse steel damper (TSD) seismic system for suspension bridges considering pounding between girder and towers. Soil Dynamics and Earthquake Engineering, 2022, 155: 107203

[8] Zhou L, Shahria Alam M, Song A, Ye A. Probability-based residual displacement estimation of unbonded laminated rubber bearing supported highway bridges retrofitted with transverse steel damper. Engineering Structures, 2022, 272: 115053

[9] Jiang L, Yan Y, Wen T, Jiang L, Yu K, Pang L. System-level seismic fragility of high-speed railway track-bridge system with component-replaceable U-shaped combined steel damper. Structures, 2023, 58: 105452

[10] Guan Z, Li J, Xu Y. Performance test of energy dissipation bearing and its application in seismic control of a long-span bridge. Journal of Bridge Engineering, 2010, 15(6): 622–630

[11] Cai X, Zhu Y, Wang J, Wang P, Wen Y. Seismic behavior of self-centering precast segmental bridge piers with external auxetic steel shear panel dampers. Structures, 2023, 58: 105647

[12] Liu M, Gao H, Wang J, Dong Z, Yan H. Earthquake damage index and fragility analysis of steel damper for seismic isolation bridge. Applied Sciences-Basel, 2023, 13(12): 7095

[13] Camara A, Astiz M A. Analysis and control of cable-stayed bridges subject to seismic action. Structural Engineering International, 2014, 24(1): 27–36

[14] Camara A, Cristantielli R, Astiz M A, Málaga-Chuquitaype C. Design of hysteretic dampers with optimal ductility for the transverse seismic control of cable-stayed bridges. Earthquake Engineering & Structural Dynamics, 2017, 46(11): 1811–1833

[15] ShenXNiXYeA. A new type of metallic damper for bridges’ aseismic performance in transverse direction. Journal of Vibration and Shock, 2014, 33(21): 96–101 (in Chinese)

[16] ShenXNiXYeA. Seismic system and design method of transverse metallic yielding dampers on long-span cable-stayed bridge side piers. China Civil Engineering Journal, 2016, 49(5): 110–119 (in Chinese)

[17] Shen X, Wang X, Ye Q, Ye A. Seismic performance of transverse steel damper seismic system for long span bridges. Engineering Structures, 2017, 141: 14–28

[18] Burcsi P, Kovacs A. Exhaustive search methods for CNS polynomials. Monatshefte für Mathematik, 2008, 155(3–4): 421–430

[19] XuYZengS. Study of optimal seismic mitigation of steel dampers arranged on cable-stayed bridge in transverse bridge direction. Bridge Construction, 2017, 47(3): 53–58 (in Chinese)

[20] Xu Y, Zeng Z, Cui C, Zeng S. Practical design method of yielding steel dampers in concrete cable-stayed bridges. Applied Sciences-Basel, 2019, 9(14): 2857

[21] Wen J, Han Q, Xie Y, Du X, Zhang J. Performance-based seismic design and optimization of damper devices for cable-stayed bridge. Engineering Structures, 2021, 237: 112043

[22] Niu J, Ding Y, Shi Y, Li Z. A simplified design method for metallic dampers used in the transverse direction of cable-stayed bridges. Earthquake Engineering and Engineering Vibration, 2020, 19(2): 483–497

[23] HeXZhangJFanCYangYXiaoX. Study of transverse seismic system for Xigu Huanghe River Bridge in Lanzhou. Bridge Construction, 2018, 48(1): 65–70 (in Chinese)

[24] WangHShenWHeTHuangMZhuH. Optimal seismic mitigation of transverse C-shaped steel damper of two series-connected long-span cable-stayed bridges. Journal of Civil Engineering and Management, 2021, 38(4): 133–139 (in Chinese)

[25] Guan Z, You H, Li J. Lateral isolation system of a long-span cable-stayed bridge with heavyweight concrete girder in a high seismic region. Journal of Bridge Engineering, 2017, 22(1): 4016104

[26] GuanZYouHGuoH. Responses of cable-stayed bridge transversely isolated with elastoplastic cable pairs and fluid viscous damper subjected to near fault ground motions. Journal of Tongji University (Natural Science), 2016, 44(11): 1653–1659 (in Chinese)

[27] Guan Z, You H, Li J. An effective lateral earthquake-resisting system for long-span cable-stayed bridges against near-fault earthquakes. Engineering Structures, 2019, 196: 109345

[28] YouHGuanZ. Elastoplastic cable pair and viscous damper used in the lateral seismic isolation of cable-stayed bridges. Journal of Vibration and Shock, 2017, 36(14): 183–188 (in Chinese)

[29] Guan Z, Li J, Qu H. Shake table test and numerical study on a capable and resilient lateral seismic isolation system for long-span cable-stayed bridges. Soil Dynamics and Earthquake Engineering, 2023, 164: 107629

[30] Guo J, Li M, Wu Y, Xiao Y, Guan Z. Experimental study on a cable-stayed bridge isolated with the combination of elastoplastic cables and fluid viscous dampers in the transverse direction. Engineering Structures, 2024, 302: 117447

[31] Ancheta T D, Darragh R B, Stewart J P, Seyhan E, Silva W J, Chiou B S J, Wooddell K E, Graves R W, Kottke A R, Boore D M. . NGA-West2 database. Earthquake Spectra, 2014, 30(3): 989–1005

[32] Xu Y, Cui C, Zeng Z, Zeng S. Shake table experimental study of cable-stayed bridges with two different design strategies of H-shaped towers. Earthquake Engineering and Engineering Vibration, 2021, 20(2): 483–493

[33] Xie W, Sun L, Lou M. Shaking table test verification of traveling wave resonance in seismic response of pile-soil-cable-stayed bridge under non-uniform sine wave excitation. Soil Dynamics and Earthquake Engineering, 2020, 134: 106151

[34] Thai H T, Kim S E. Second-order inelastic analysis of cable-stayed bridges. Finite Elements in Analysis and Design, 2012, 53: 48–55

[35] Shi Z, Dimitrakopoulos E G. Nonsmooth dynamics prediction of measured bridge response involving deck-abutment pounding. Earthquake Engineering & Structural Dynamics, 2017, 46(9): 1431–1452

[36] Hinrichs N, Oestreich M, Popp K. Dynamics of oscillators with impact and friction. Chaos, Solitons and Fractals, 1997, 8(4): 535–558

[37] JTG3363-2019. Specifications for Design of Foundation of Highway Bridges and Culverts. Beijing: Ministry of Transport of the People’s Republic of China, 2019 (in Chinese)

[38] JTG/T2231-01-2020. Specifications for Seismic Design of Highway Bridges. Beijing: Ministry of Transport of the People’s Republic of China, 2020 (in Chinese)

[39] Mokha A, Constantinou M C, Reinhorn A M, Zayas V A. Experimental study of friction-pendulum isolation system. Journal of Structural Engineering, 1991, 117(4): 1201–1217

[40] Tsopelas P, Constantinou M C, Kim Y S, Okamoto S. Experimental study of FPS system in bridge seismic isolation. Earthquake Engineering & Structural Dynamics, 1996, 25(1): 65–78

[41] Fenz D M, Constantinou M C. Behaviour of the double concave friction pendulum bearing. Earthquake Engineering & Structural Dynamics, 2006, 35(11): 1403–1424

[42] WanXHouHWanWXiongS. Study on the mechanical properties of the laminated rubber isolation bearing with annular steel wire ropes. Journal of Wuhan University of Technology, 2016, 38(5): 64–69 (in Chinese)

[43] Ou Y C, Wang P H, Tsai M S, Chang K C, Lee G C. Large-scale experimental study of precast segmental unbonded posttensioned concrete bridge columns for seismic regions. Journal of Structural Engineering, 2010, 136(3): 255–264

[44] ZhangSGuanZ. Reasonable transverse isolation system for long-span single-tower cable-stayed bridges with hybrid girders in mountainous areas. Journal of Basic Science and Engineering, 2024, 32(1): 258–272 (in Chinese)

[45] Dicleli M. Performance of seismic-isolated bridges in relation to near-fault ground-motion and characteristics. Earthquake Spectra, 2006, 22(4): 887–907

[46] Dimitrakopoulos E, Makris N, Kappos A J. Dimensional analysis of the earthquake-induced pounding between adjacent structures. Earthquake Engineering & Structural Dynamics, 2009, 38(7): 867–886

[47] Jónsson M H, Bessason B, Haflidason E. Earthquake response of a base-isolated bridge subjected to strong near-fault ground motion. Soil Dynamics and Earthquake Engineering, 2010, 30(6): 447–455

[48] Benedettini F, Rega G, Alaggio R. Nonlinear oscillations of a four-degree-of-freedom model of a suspended cable under multiple internal resonance conditions. Journal of Sound and Vibration, 1995, 182(5): 775–798

[49] Kang H, Guo T, Zhu W. Analysis on in-plane 2:2:1 internal resonance of a complex cable-stayed bridge system under external harmonic excitation. Journal of Computational and Nonlinear Dynamics, 2021, 16(10): 101001

RIGHTS & PERMISSIONS

Higher Education Press