Experimental study of two saturated natural soils and their saturated remoulded soils under three consolidated undrained stress paths

Abstract

In this paper, an experimental investigation is conducted to study the mechanical behavior of saturated natural loess, saturated natural filling in ground fissure and their corresponding saturated remoulded soils under three consolidated undrained triaxial stress tests, namely, conventional triaxial compression test (CTC), triaxial compression test (TC) and reduced triaxial compression test (RTC). The test results show that stress-strain relation, i.e. strain-softening or strain-hardening, is remarkably influenced by the structure, void ratio, stress path and confining pressure. Natural structure, high void ratio, TC stress path, RTC stress path and low confining pressures are favorable factors leading to strain-softening. Excess pore pressure during shearing is significantly affected by stress path. The tested soils are different from loose sand on character of strain-softening and are different from common clay on excess pore water pressure behavior. The critical states in p′– q space in CTC, TC and RTC tests almost lie on one line, which indicates that the critical state is independent of the above stress paths. As for remoulded loess or remoulded filling, the critical state line (CSL) and isotropic consolidation line (ICL) in e-log p′ space are almost straight, while for natural loess or natural filling, in e-log p′ space there is a turning point on the CSL, which is similar to the ICL.

Keywords

stress paths / static liquefaction / natural soil / remoulded soil / loess / structure / total strength indices / excess pore pressure

References

[1] Castro G. Liquefaction of sands. Dissertation for the Doctoral Degree. Cambridge: Harvard University, 1969

[2] Poulos S J. The steady state of deformation. Journal of Geotechnical Engineering, 1981, 107(5): 553–562

[3] Poulos S J, Castro G, France J W. Liquefaction evaluation procedure. Journal of Geotechnical Engineering, 1985, 111(6): 772–792

[4] Ishihara K. Liquefaction and flow failure during earthquakes: thirty-third rankine lecture. Geotechnique, 1993, 43(3): 351–415

[5] Yamamuro J A, Lade P V. Steady state concepts and static liquefaction of silty sands. Journal of Geotechnical and Geoenvironmental Engineering, 1998, 124(9): 868–877

[6] Chang Y S, Wang X D, Zai J M, Xu J L. Stress path tests of cohesive soil. Journal of Nanjing University of technology, 2005, 27(5): 36–44 (in Chinese)

[7] Zeng L L, Chen X P. Analysis of mechanical characteristics of soft soil under different stress paths. Rock and Soil Mechanics, 2009, 30(5): 1264–1270 (in Chinese)

[8] Liu Z D, Xing Y C. A new method for determining the parameters of cap-model. Water Resources & Water Engineering, 1993, 4(4): 1–8 (in Chinese)

[9] Yang P. Influence of stress path on deformation and strength characteristics of saturated intact loess. Dissertation for the Master Degree, Xi’an: Xi’an University of Technology, 2007 (in Chinese)

[10] Yang Z M, Zhao C G, Wang L M, Rao W G. Liquefaction behaviros and steady state strength of saturated loess. Chinese Journal of Rock Mechanics and Engineering, 2007, 35(12): 83–86 (in Chinese)

[11] Zhang D X, Wang G H, Luo C Y, Chen J, Zhou Y X. A rapid loess flow slide triggered by irrigation in China. Landslides, 2009, 6(1): 55–60

[12] Zhou Y X, Zhang D X, Zhou X D. Undrained consolidation triaxial test for flow sliding mechanism of loess landslides. Journal of Engineering Geology, 2010, 18(1): 72–77 (in Chinese)

[13] Zhou Y X, Zhang D X, Luo C Y, Chen J.Experimental research on steady strength of saturated loess. Rock and Soil Mechanics, 2010, 31(5): 1486–1490,1496 (in Chinese)

[14] Leroueil S, Vaughan P R. The general and congruent effects of structure in natural soils and weak rocks. Geotechnique, 1990, 40(3): 467–488

[15] Diaz-Rodriguez J A, Leroueil S, Aleman J D. Yielding of mexico city clay and other natural clays. Journal of Geotechnical Engineering, 1992, 118(7): 981–995

[16] Malandraki V, Toll D G. Triaxial tests on weakly bonded soil with changes in stress path. Journal of Geotechnical and Geoenvironmental Engineering, 2001, 127(3): 282–291

[17] Yin J, Hong Z S, Gao Y F. Yielding characteristics of natural soft Lianyungang clay. Journal of Southeast University, 2009, 39(5): 1059–1064 (Natural Science Edition)

[18] Liu M F, Yao Y P, Kong D Q. The experimental study of saturated structural K₀ consolidated loess. Journal of Xi’an University of Architecture & Technology, 2008, 40(2): 238–248 (Natural Science Edition)

[19] Lamber T W. Stress path method. Journal of the Soil Mechanics and Foundations, 1967, 93(6): 309–331

[20] Lamber T W, Marr W A. Stress path method: second edition. Journal of Geotechnical Engineering, 1979, 105(6): 727–738

[21] Ng C W W. Stress paths in relation to deep excavations. Journal of Geotechnical and Geoenvironmental Engineering, 1999, 125(5): 357–363

[22] Cai M. Influence of stress path on tunnel excavation response – Numerical tool selection and modeling strategy. Tunnelling and Underground Space Technology, 2008, 23(6): 618–628

[23] Weng M C, Jeng F S, Hsieh Y M, Huang T H. A simple model for stress-induced anisotropic softening of weak sandstones. International Journal of Rock Mechanics and Mining Sciences, 2008, 45(2): 155–166

[24] Chen C N, Tseng C T. 2D tunneling chart from redistributed 3D principal stress path. Tunnelling and Underground Space Technology, 2010, 25(4): 305–314

[25] Bilotta E, Stallebrass S E. Prediction of stresses and strains around model tunnels with adjacent embedded walls in overconsolidated clay. Computers and Geotechnics, 2009, 36(6): 1049–1057

[26] Dai F C, Lee C F, Wang S J, Feng Y Y. Stress–strain behavior of a loosely compacted volcanic-derived soil and its significance to rainfall-induced fill slope failures. Engineering Geology, 1999, 53(3-4): 359–370

[27] Zhou B C. Influence of stress path on effective shear strength parameters of reshaped clay. Journal of Huazhong University of Science & Technology, 2007, 35(12): 83–86 (Nature Science Edition)

[28] Gibbs H J, Holland W Y. Petrographic and engineering properties of loess. United States Department of the Interior Bureau of Reclamation. Engineering Monograph, 1960, 28: 1–37

[29] Bishop A W, Wesley L. A hydraulic triaxial apparatus for controlled stress path testing. Geotechnique, 1975, 25(4): 657–670

[30] Menzies B K. A computer controlled hydraulic triaxial testing system. In: Advanced triaxial testing of soil and rock, ASTM STP 977 Philadelphia, 1988, 82–94

[31] Casagrande A. Determination of the pre-consolidation load and its practical significance. In: Proceedings of the 1st International Conference on Soil Mechanics and Foundation. Cambridge: Harvard University Press, 1936, 60–64

[32] Chandler R J. Clay sediments in depositional Basins: the geotechnical cycle. Quarterly Journal of Engineering Geology, 2000, 33(1): 7–39

[33] Jiang M J, Yu H S, Leroueil S. A simple and efficient approach to capturing bonding effect in natural sands by discrete element method. International Journal for Numerical Methods in Engineering, 2007, 69(6): 1158–1193

[34] Roscoe K H, Schofield A N, Thurairajah A. Yield of clays in states wetter than critical. Geotechnique, 1963, 13(3): 211–240

[35] Bishop A W. Progressive failure-with special reference to the mechanism causing it. In: Proceedings of the Geotechnical Conference, Norway, 1967, 142–150

[36] Pan X Q, Pan L, Luo S H. Influence of stress path on ϕ_cu of normally-consolidated saturated clay. Dam Observation and Geotechnical Tests, 1997, 21(4): 25–30 (in Chinese)

RIGHTS & PERMISSIONS

Higher Education Press and Springer-Verlag Berlin Heidelberg