Theoretical and experimental study on seismic response control on top of Three-Gorges ship lift towers using magnetorheological intelligent isolation system and its key technique

Abstract

A vertical ship lift under earthquake excitation may suffer from a whipping effect due to the sudden change of building lateral stiffness at the top of the ship lift towers. This paper proposes a roof magnetorheological (MR) intelligent isolation system to prevent the seismic whipping effect on machinery structures. Theoretically, the dynamic models of MR damper and the mechanical model of ship lift was established, the inverse neural network controlling algorithm was proposed and the fundamental semi-active control equation for the Three-Gorges ship lift where the MR intelligent isolation system was installed was deduced. Experimentally, the experimental model of the ship lift was given, the vibrating table experiment of the MR intelligent isolation system controlling the whipping effect was carried out and the results of the inverse neural network control strategy and passive isolation strategy were compared. In practical aspect, the large-scale MR damper (500 kN) and a sliding support with limited stiffness were designed and fabricated. It was proven that the MR intelligent isolation system with proper control strategy can greatly reduce the seismic whipping effect on the top workshop of the ship lift and be simple and effective enough to be applied to real engineering structures.

Keywords

Three-Gorges ship lift tower / whipping effect / magnetorheological (MR) intelligent isolation system / neural network / sliding steel supporting

References

[1] Wu Jiefang, Chen Minzhong, Dai Xinhe, Niu Xinqiang. Whole structure aseismic computation of Three Gorges project’s shiplift. Journal of Yangtze River Scientific Research Institute, 1997, 14(3): 44-47 (in Chinese)

[2] Chen Houqun, Hu Xiao, Wang Ji, Li Deyu, Yu Ying. Dynamic test and analysis for shiplifter tower structure of the Three Gorge project on shaking table. Earthquake Engineering and Engineering Vibration, 1999, 19(1): 47-53 (in Chinese)

[3] Qu Weilian, Lv Mingyun, Li Xuean. Fuzzy seismic control of top building of lift-ship structure with roof intelligent isolation system. Earthquake Engineering and Engineering Vibration, 2002, 22(3): 129-137 (in Chinese)

[4] Yang G. Large-scale magnetorheological fluid damper for vibration mitigation:modeling, testing and conrol. Dissertation for the Doctoral Degree. Indiana: University of Notre Dame, 2001

[5] Housner G W, Bergman L A, Caughey T K, Chassiakos A G, Claus R O, Masri S F, Skelton R E, Soong T T, Spencer B F, Yao J T P. Structural control: past, present and future. Journal of Engineering Mechanics, 1997, 123(9): 897-971

[6] Ou Jinping. Structure Vibration Control: Active, Semi-active, Intelligent Control. Beijing: Science Press, 2003 (in Chinese)

[7] Fujitani H, . Development of 400kN magnetorheological damper for a real base-isolated building. In: Proceedings of SPIE Conference Smart Structures and Materials, Vol. 5052, Bellingham(WA): SPIE-International Society for Optical Engineering, 2003, 265-276

[8] Ni Y Q, Ko J M, Chen Z Q, Spencer B F. Lessons learned from application of semi-active MR dampers to bridge cables for wind-rain-induced vibration control. In: Proceedings of China-Japan Workshop on Vibration Control and Health Monitoring of Structures and Third Chinese Symposium on Structural Vibration Control, Shanghai, China. 2002

[9] Zhou Qiang, Qu Weilian. Two mechanical models for magnetorheological damper and corresponding test verification. Earthquake Engineering and Engineering Vibration, 2002, 22: 144-150 (in Chinese)

RIGHTS & PERMISSIONS

Higher Education Press and Springer-Verlag Berlin Heidelberg