Numerical simulation of mechanical controlling parameters for Type IV cracking on the welding joints of martensitic heat-resistant steel

Abstract

The maximum principal stress, von Mises equivalent stress and equivalent creep strain in the welding joint of martensitic heat-resistant steel (9Cr1MoVNb) are simulated by finite-element method (FEM) under the condition of 600°C and applied stress of 80 MPa. The results show that the maximum principal stress and von Mises equivalent stress are high on the curved points of two sides of the groove face near the fine-grain heat-affected zone (HAZ). The creep strain mainly concentrates in the fine-grain HAZ; the maximum creep strain locates in the bottom of fine-grain HAZ of specimen. The stress triaxiality in the fine-grain HAZ is maximum, and creep cracking occurs because of the intensive constrain of base metal and weld. The simulation result is good in agreement with those of crack initiation site and propagation path by using the stress triaxiality as the mechanical controlling parameter of weld joint of martensite heat-resistant steel. Therefore, it is reasonable that the stress triaxiality is used for analysis initiation and propagation of Type IV cracking in the fine-grain HAZ.

Keywords

martensitic heat-resistant steel / Type IV cracking / von Mises equivalent stress / equivalent creep strain / numerical simulation