RESEARCH ARTICLE

Effects of critical geometric parameters on the optical performance of a conical cavity receiver

  • Hu XIAO 1 ,
  • Yanping ZHANG , 2 ,
  • Cong YOU 3 ,
  • Chongzhe ZOU 1 ,
  • Quentin FALCOZ 4
Expand
  • 1. School of Energy and Power Engineering, Huazhong University of Science and Technology, Wuhan 430074, China
  • 2. School of Energy and Power Engineering, Huazhong University of Science and Technology, Wuhan 430074, China; China-EU Institute for Clean and Renewable Energy, Huazhong University of Science and Technology, Wuhan 430074, China
  • 3. China-EU Institute for Clean and Renewable Energy, Huazhong University of Science and Technology, Wuhan 430074, China
  • 4. China-EU Institute for Clean and Renewable Energy, Huazhong University of Science and Technology, Wuhan 430074, China; PROMES-CNRS Laboratory, 7 rue du Four Solaire, 66120 Font-Romeu-Odeillo-via, France

Received date: 04 Sep 2018

Accepted date: 28 Feb 2019

Published date: 15 Dec 2019

Copyright

2019 Higher Education Press and Springer-Verlag GmbH Germany, part of Springer Nature

Abstract

The optical performance of a receiver has a great influence on the efficiency and stability of a solar thermal power system. Most of the literature focuses on the optical performance of receivers with different geometric shapes, but less research is conducted on the effects of critical geometric parameters. In this paper, the commercial software TracePro was used to investigate the effects of some factors on a conical cavity receiver, such as the conical angle, the number of loops of the helical tube, and the distance between the focal point of the collector and the aperture. These factors affect the optical efficiency, the maximum heat flux density, and the light distribution in the conical cavity. The optical performance of the conical receiver was studied and analyzed using the Monte Carlo ray tracing method. To make a reliable simulation, the helical tube was attached to the inner wall of the cavity in the proposed model. The results showed that the amount of light rays reaching the helical tube increases with the increasing of the conical angle, while the optical efficiency decreases and the maximum heat flux density increases. The increase in the number of loops contributed to an increase in the optical efficiency and a uniform light distribution. The conical cavity receiver had an optimal optical performance when the focal point of the collector was near the aperture.

Cite this article

Hu XIAO , Yanping ZHANG , Cong YOU , Chongzhe ZOU , Quentin FALCOZ . Effects of critical geometric parameters on the optical performance of a conical cavity receiver[J]. Frontiers in Energy, 2019 , 13(4) : 673 -683 . DOI: 10.1007/s11708-019-0630-2

Acknowledgments

This research was supported by the National Program of International Science and Technology Cooperation of China (Project No. 2014DFA60990).
1
Tsoutsos T, Gekas V, Marketaki K. Technical and economical evaluation of solar thermal power generation. Renewable Energy, 2003, 28(6): 873–886

DOI

2
Huang W, Huang F, Hu P, Chen Z. Prediction and optimization of the performance of parabolic solar dish concentrator with sphere receiver using analytical function. Renewable Energy, 2013, 53(9): 18–26

DOI

3
Flesch R, Stadler H, Uhlig R, Pitz-Paal R. Numerical analysis of the influence of inclination angle and wind on the heat losses of cavity receivers for solar thermal power towers. Solar Energy, 2014, 110(110): 427–437

DOI

4
Xiao L, Wu S Y, Li Y R. Numerical study on combined free-forced convection heat loss of solar cavity receiver under wind environments. International Journal of Thermal Sciences, 2012, 60(1): 182–194

DOI

5
Wu S Y, Guo F H, Xiao L. Numerical investigation on combined natural convection and radiation heat losses in one side open cylindrical cavity with constant heat flux. International Journal of Heat and Mass Transfer, 2014, 71(3): 573–584

DOI

6
Wu S Y, Xiao L, Li Y R. Effect of aperture position and size on natural convection heat loss of a solar heat-pipe receiver. Applied Thermal Engineering, 2011, 31(14–15): 2787–2796

DOI

7
Cui F, He Y, Cheng Z, Li Y. Study on combined heat loss of a dish receiver with quartz glass cover. Applied Energy, 2013, 112(4): 690–696

DOI

8
Reddy K S, Vikram T S, Veershetty G. Combined heat loss analysis of solar parabolic dish- modified cavity receiver for superheated steam generation. Solar Energy, 2015, 121: 78–93

DOI

9
Vikram T S, Reddy K S. Estimation of heat losses from modified cavity mono-tube boiler receiver of solar parabolic dish for steam generation. Energy Procedia, 2014, 57: 371–380

DOI

10
Collado F J. One-point fitting of the flux density produced by a heliostat. Solar Energy, 2010, 84(4): 673–684

DOI

11
Li H, Huang W, Huang F, Hu P, Chen Z. Optical analysis and optimization of parabolic dish solar concentrator with a cavity receiver. Solar Energy, 2013, 92(4): 288–297

DOI

12
Xie W T, Dai Y J, Wang R Z. Numerical and experimental analysis of a point focus solar collector using high concentration imaging PMMA Fresnel lens. Energy Conversion and Management, 2011, 52(6): 2417–2426

DOI

13
Li X, Dai Y J, Wang R Z. Performance investigation on solar thermal conversion of a conical cavity receiver employing a beam-down solar tower concentrator. Solar Energy, 2015, 114: 134–151

DOI

14
Daabo A M, Mahmoud S, Al-Dadah R K. The optical efficiency of three different geometries of a small scale cavity receiver for concentrated solar applications. Applied Energy, 2016, 179: 1081–1096

DOI

15
Daabo A M, Ahmad A, Mahmoud S, Al-Dadah R K. Parametric analysis of small scale cavity receiver with optimum shape for solar powered closed Brayton cycle applications. Applied Thermal Engineering, 2017, 122: 626–641

DOI

16
Li S, Xu G, Luo X, Quan Y, Ge Y. Optical performance of a solar dish concentrator/receiver system: influence of geometrical and surface properties of cavity receiver. Energy, 2016, 113: 95–107

DOI

17
Wang F, Lin R, Liu B, Tan H, Shuai Y. Optical efficiency analysis of cylindrical cavity receiver with bottom surface convex. Solar Energy, 2013, 90(4): 195–204

DOI

18
Shuai Y, Xia X L, Tan H P. Radiation performance of dish solar concentrator/cavity receiver systems. Solar Energy, 2008, 82(1): 13–21

DOI

19
Przenzak E, Szubel M, Filipowicz M. The numerical model of the high temperature receiver for concentrated solar radiation. Energy Conversion and Management, 2016, 125: 97–106

DOI

20
Andraka C E, Yellowhair J, Iverson B D. A parametric study of the impact of various error contributions on the flux distribution of a solar dish concentrator. In: ASME 2010 4th International Conference on Energy Sustainability, Phoenix, AZ, USA, 2010, 2: 565–580

21
Zou C, Zhang Y, Feng H, Falcoz Q, Neveu P, Gao W, Zhang C. Effects of geometric parameters on thermal performance for a cylindrical solar receiver using a 3D numerical model. Energy Conversion and Management, 2017, 149: 293–302

DOI

22
Zou C, Zhang Y, Falcoz Q, Neveu P, Zhang C, Shu W, Huang S. Design and optimization of a high-temperature cavity receiver for a solar energy cascade utilization system. Renewable Energy, 2017, 103: 478–489

DOI

23
Prakash M, Kedare S B, Nayak J K. Investigations on heat losses from a solar cavity receiver. Solar Energy, 2009, 83(2): 157–170

DOI

24
Prakash M, Kedare S B, Nayak J K. Determination of stagnation and convective zones in a solar cavity receiver. International Journal of Thermal Sciences, 2010, 49(4): 680–691

DOI

25
Wang J, Yang S, Jiang C, Yan Q, Lund P D. A novel 2-stage dish concentrator with improved optical performance for concentrating solar power plants. Renewable Energy, 2017, 108: 92–97

DOI

26
Zhu Y, Shi J, Li Y, Wang L, Huang Q, Xu G. Design and thermal performances of a scalable linear Fresnel reflector solar system. Energy Conversion and Management, 2017, 146: 174–181

DOI

27
Sarwar J, Georgakis G, Kouloulias K, Kakosimos K E. Experimental and numerical investigation of the aperture size effect on the efficient solar energy harvesting for solar thermochemical applications. Energy Conversion and Management, 2015, 92: 331–341

DOI

28
Chang H, Duan C, Wen K, Liu Y, Xiang C, Wan Z, He S, Jing C, Shu S. Modeling study on the thermal performance of a modified cavity receiver with glass window and secondary reflector. Energy Conversion and Management, 2015, 106: 1362–1369

DOI

29
Jafrancesco D, Sansoni P, Francini F, Fontani D. Strategy and criteria to optically design a solar concentration plant. Renewable & Sustainable Energy Reviews, 2016, 60: 1066–1073

DOI

30
Hasuike H, Yoshizawa Y, Suzuki A, Tamaura Y. Study on design of molten salt solar receivers for beam-down solar concentrator. Solar Energy, 2006, 80(10): 1255–1262

DOI

Outlines

/