A new mixed type crack propagation criterion in shale reservoirs

Abstract

Hydraulic fracturing is a mainstream technology for unconventional oil and gas reservoirs development all over the world. How to use this technology to achieve high-level oil and gas resource extraction and how to form complex fracture networks as hydrocarbon transportation channels in tight reservoirs, which depends to a large extent on the interaction between hydraulic and pre-existing cracks. For hydraulic fracturing of fractured reservoirs, the impact of natural fractures, perforation direction, stress disturbances, faults and other influencing factors will produce a mixed Ⅰ&Ⅱ mode hydraulic fracture. To forecast whether hydraulic fractures cross pre-existing fractures, according to elastic mechanics and fracture mechanics, a stress state of cracks under the combination of tensile (Ⅰ) and shear (Ⅱ) is presented. A simple mixed-mode Ⅰ&Ⅱ hydraulic fracture's crossing judgment criterion is established, and the propagation of hydraulic fractures after encountering natural fractures is analyzed. The results show that for a given approaching angle there exists a certain range of stress ratio when crossing occurs. Under high approaching angle and large stress ratio, it is likely that hydraulic cracks will go directly through pre-existing cracks. The reinitiated angle is always controlled within the range of approximately 30° among the main direction of penetration.

Keywords

Crack propagation criterion / Stress ratio / Approaching angle / Reinitiated angle / Mechanical model

Declaration of competing interest

No potential conflict of interest was reported by the authors.

Acknowledgments

This work was supported by National Natural Science Foundation of China (52074248) and Fundamental Research Funds for the Central Universities (2652019105,2652022207).

References

[1] P. Tan, H.W. Pang, R.X. Zhang, et al., Experimental investigation into hydraulic fracture geometry and proppant migration characteristics for southeastern Sichuan deep shale reservoirs, J. Petrol. Sci. Eng. 184 (106517) (2020).

[2] P. Tan, Y. Jin, K. Han, et al., Analysis of hydraulic fracture initiation and vertical propagation behavior in laminated shale formation, Fuel 206 (2017) 482-493.

[3] Q.S. Li, H.L. Xing, J.J. Liu, A review on hydraulic fracturing of unconventional reservoir, Petroleum 1 (1) (2015) 8-15.

[4] K.B. Walsh, J.H. Haggerty, J.B. Jacquet, Uneven impacts and uncoordinated studies: a systematic review of research on unconventional oil and gas development in the United States, Energy Res. Social Sci. 66 (1) (2020) 101-156.

[5] I. Kim, Swinging shale: shale oil, the global oil market, and the geopolitics of oil, Int. Stud. Q. 64 (3) (2020) 544-557.

[6] C.N. Zou, Z. Yang, R.K. Zhu, et al., Progress in China's unconventional oil & gas exploration and development and theoretical technologies, Acta Geol. Sin. 89 (6) (2015) 979-1007.

[7] O.R. Lazar, K.M. Bohacs, J.H.S. Macquaker, Capturing key attributes of finegrained sedimentary rocks in outcrops, cores, and thin sections: nomenclature and description guidelines, J. Sediment. Res. (85) (2015) 230-246.

[8] C.H. Guo, B.J. Bai, M.Z. Wei,Study on gas permeability in nano pores of shale gas reservoirs, in:SPE Canadian Unconventional Resources Conference 2013, Unconventional Becoming Conventional: Lessons Learned and New Innovations, Society of Petroleum Engineers, 2013.

[9] R.G. Loucks, R.M. Reed, S.C. Ruppel, Morphology, genesis, and distribution of nanometer-scale pores in siliceous mudstones of the Mississippian Barnett Shale, J. Sediment. Res. 79 (12) (2009) 848-861.

[10] M.E. Curtis, R.J. Ambrose, C.H. Sondergeld, Structural characterization of gas shales on the micro-and nano-scales, in: Canadian Unconventional Resources and International Petroleum Conference, Society of Petroleum Engineers, 2010.

[11] R. Kalyani, Awakening the slumbering giant: how horizontal drilling technology brought the endangered species act to bear on hydraulic fracturing, Case West. Reserv. Law Rev. 63 (4) (2013) 1143-1166.

[12] C.N. Zou, Q. Zhao, D.Z. Dong, et al., Geological characteristics, main challenges and future prospect of shale gas, Nat. Gas Geosci. 28 (12) (2017) 1781-1796.

[13] O. Kolawole, I. Ispas, Interaction between hydraulic fractures and natural fractures: current status and prospective directions, J. Pet. Explor. Prod. Technol. 10 (4) (2020) 1613-1634.

[14] K. Wang, G.D. Zhang, F. Du, et al., Simulation of Directional Propagation of Hydraulic Fractures Induced by Slotting Based on Discrete Element Method, ISSN 2405-6561, Petroleum, 2022.

[15] Amir Ghaderi, Jaber Taheri-Shakib, Mohamad Amin Sharifnik, The effect of natural fracture on the fluid leak-off in hydraulic fracturing treatment, Petroleum 5 (1) (2019) 85-89.

[16] Z.F. Luo, N.L. Zhang, L.Q. Zhao, et al., General criterion for intersection between hydraulic induced fractures and pre-existing natural fractures, Petroleum 5 (3) (2019) 315-320.

[17] Jaber Taheri-Shakib, Amir Ghaderi, Mohammad Amin Sharif Nik, Numerical study of influence of hydraulic fracturing on fluid flow in natural fractures, Petroleum 5 (3) (2019) 321-328.

[18] B. Yildirim, W. Cao, S. Durucan, The Effect of Natural Fracture Heterogeneity on Hydraulic Fracture Performance and Seismic Response in Shale and Coal Formations, U.S. Rock Mechanics/Geomechanics Symposium Seattle, Washington, 2018.

[19] X. Weng, C.E. Cohen, O. Kresse, Chapter 10. Impact of Preexisting Natural Fractures on Hydraulic Fracture Simulation, Unconventional Oil & Gas Resources Handbook, 2016, pp. 289-331.

[20] L. Norman, F. Jessen, The effects of existing fractures in rocks on the extension of hydraulic fractures, J. Petrol. Technol. 20 (2) (1963) 203-209.

[21] A.A. Daneshy, Hydraulic fracture propagation in the presence of planes of weakness, in: The SPE European Spring Meeting, Journal of Petroleum Technology, 1974.

[22] T.L. Blanton, Propagation of hydraulically and dynamically induced fractures in naturally fractured reservoirs, in: SPE Unconventional Gas Technology Symposium, Society of Petroleum Engineers, 1986.

[23] N.R. Warpinski, L.W. Teufel, Influence of geologic discontinuities on hydraulic fracture propagation, SPE Journal of Petroleum Technology 39 (2) (1987) 209-220.

[24] L.J.L. Beugelsdijk, C.J. De Pater, K. Sato, Experimental hydraulic fracture propagation in a multi-fractured medium, in: SPE Asia Pacific Conference on Integrated Modelling for Asset Management, Society of Petroleum Engineers, 2000.

[25] J. Zhou, M. Chen, Y. Jin, Analysis of fracture propagation behavior and fracture geometry using a tri-axial fracturing system in naturally fractured reservoirs, Int. J. Rock Mech. Min. Sci. 45 (7) (2008) 1143-1152.

[26] J.E. Olson, B. Bahorich, J. Holder, Examining hydraulic fracture: natural fracture interaction in hydrostone block experiments,in:SPE Hydraulic Fracturing Technology Conference, Society of Petroleum Engineers, 2012.

[27] W. Wang, J.E. Olson, Prodanovic, et al., Interaction between cemented natural fractures and hydraulic fractures assessed by experiments and numerical simulations, J. Petrol. Sci. Eng. 167 (2018) 506-516.

[28] C.E. Renshaw, D.D. Pollard, An experimentally verified criterion for propagation across unbounded frictional interfaces in brittle, linear elastic-materials, Int. J. Rock Mech. Min. Sci. Geomech. Abstracts 32 (3) (1995) 237-249.

[29] H. Gu, X. Weng, Criterion for fractures crossing frictional interfaces at nonorthogonal angles, in: The 44th U.S. Rock Mechanics Symposium and 5th U. S.-Canada Rock Mechanics Symposium, 2010. Salt Lake City, Utah.

[30] H. Gu, X. Weng, J.B. Lund, et al., Hydraulic fracture crossing natural fracture at non-orthogonal angles, a criterion, its validation and applications,in:SPE Hydraulic Fracturing Technology Conference and Exhibition, Society of Petroleum Engineers, 2012.

[31] W. Cheng, Y. Jin, M. Chen, et al., A criterion for identifying hydraulic fractures crossing natural fractures in 3D space, Petrol. Explor. Dev. 41 (3) (2014) 336-340.

[32] Y. Zeng, W. Cheng, X. Zhang, et al., A criterion for identifying a mixed-mode I/II hydraulic fracture crossing a natural fracture in the subsurface, Energy Explor. Exploit. 38 (6) (2020) 2507-2520.

[33] X. Zhang, R.G. Jeffrey, Fluid-driven nucleation and propagation of splay fractures from a permeable fault, J. Geophys. Res. Solid Earth 121 (7) (2016) 5257-5277.

[34] C. Barton, D. Moos, K. Tezuka, Geomechanical wellbore imaging: implications for reservoir fracture permeability, AAPG Bull. 93 (11) (2009) 1551-1569.

[35] M.D. Zoback, A.H. Kohi, Unconventional Reservoir Geomechanics, Cambridge University Press, 2019.

[36] X.Y. Guo, K. Wu, C. An, et al., Numerical investigation of effects of subsequent parent-well injection on interwell fracturing interference using reservoirgeomechanics-fracturing modeling, SPE J. 24 (4) (2019) 1884-1902.

[37] B.K. Atkinson, Rock Fracture Dynamics, Geological Press, 1992.

[38] Y.Z. Wang, B. Hou, D. Wang, et al., Features of fracture height propagation in cross-layer fracturing of shale oil reservoirs, Petrol. Explor. Dev. 48 (2) (2021) 402-410.

[39] J.W. Kao, Y. Jin, W.N. Fu, et al., Experimental research on the morphology of hydraulic fractures in deep shale under high difference of in-situ horizontal stresses, Chin. J. Rock Mech. Eng. 37 (6) (2018) 1332-1339.

[40] B.T. Lin, C. Shi, L. Zhuang, et al., Study on fracture propagation behavior in ultra-heavy oil reservoirs based on true tri-axial experiments, Petrol. Explor. Dev. 47 (3) (2020) 608-616.

[41] Y. Zhao, P.F. He, Y.F. Zhang, et al., A new criterion for a toughness-dominated hydraulic fracture crossing a natural frictional interface, Rock Mech. Rock Eng. (52) (2019) 2617-2629.

[42] D.J. Zhu, W.S. Du, A criterion for a hydraulic fracture crossing a frictional interface considering T-stress, ISSN 920-4105, J. Petrol. Sci. Eng. 209 (2022).

[43] J.C. Jaeger, N.G.W. Cook, R.W. Zimmerman,Fundamentals of Rock Mechanics, fourth ed.ed., Blackwell Publishing, 2007.