Evidence of shear stress component in Lüders front based on an in-situ synchrotron high-energy X-ray diffraction experiment

Abstract

The formation and propagation of Lüders bands are important phenomena in the plastic deformation of some critical structural materials. The propagating Lüders front, which is structurally unstable, plays a key role in this process. Yet, the microstructural and stress states of the Lüders front are challenging to characterize and remain insufficiently understood. The present study utilized in-situ synchrotron-based high-energy X-ray diffraction on a fine-grained medium-Mn transformation-induced plasticity steel exhibiting typical Lüders banding behavior. Detailed analysis of evolving diffraction patterns was performed regarding peak intensity, full width at half maximum, and measured lattice strain. An abnormal measured lattice strain asymmetry was observed from the Debye rings that were collected when the Lüders front overlapped with the irradiated volume. This allows for a discussion of the local microstructural and stress states of the Lüders front, evidencing the possibility of a local shear stress component with a tilted principal stress axis. The work offers new insights into the micro-mechanisms of Lüders banding. It provides a practical and efficient analytical method for studying the dynamics of localized deformations, particularly when deformation is inhomogeneous within the characterized volume or inconsistent with macroscopic deformation.

Keywords

Synchrotron X-ray diffraction / medium-Mn steel / Lüders bands / shear stress

References

[1] Suh DW.Medium Mn transformation-induced plasticity steels: recent progress and challenges.Scr Mater2017;126:63-7

[2] Aydin H,Jung IH.Development of 3rd generation AHSS with medium Mn content alloying compositions.Mater Sci Eng A2013;564:501-8

[3] Guo Z,Yang W.Microstructures and Mechanical properties of high-Mn TRIP steel based on warm deformation of martensite.Metall Mater Trans A2015;46:1704-14

[4] He BB.Strong and ductile medium Mn steel without transformation-induced plasticity effect.Mater Rese Lett2018;6:365-71

[5] Han J,Jung JG.The effects of the initial martensite microstructure on the microstructure and tensile properties of intercritically annealed Fe-9Mn-0.05C steel.Acta Mater2014;78:369-77

[6] Hu J,Meng Q,Li Y.Tailoring retained austenite and mechanical property improvement in Al-Si-V containing medium Mn steel via direct intercritical rolling.Mater Sci Eng A2022;855:143904

[7] Tian G,Bao Z,Yan L.Achieving 1.5 GPa grade medium Mn steel with high ductility via interrupted intercritical annealing process.Mater Sci Eng A2024;905:145943

[8] Bai S,Niu W,Liang W.Microstructure and mechanical properties of a medium-Mn steel with 1.3 GPa-strength and 40%-ductility.Materials2021;14:2233 PMCID:PMC8123636

[9] Chen P,Li XW.Investigation of the hot-rolled medium-Mn steels with ultra-high strength and considerable ductility.J Mater Eng Perform2025;1-6

[10] Lan H,Ma Y,Du L.Influence of intercritical annealing on microstructure, ductility, and toughness of medium Mn steels.J Mater Eng Perform2025;34:14272-84

[11] Steineder K,Schneider R,Sommitsch C.On the microstructural characteristics influencing the yielding behavior of ultra-fine grained medium-Mn steels.Acta Mater2017;139:39-50

[12] Heo YU,Lee HC.Fabrication of an ultrafine-grained structure by a compositional pinning technique.Acta Mater2014;77:236-47

[13] Wang S,Zhao Z,Luo X.Effect of microstructure evolution on Lüders strain and tensile properties in an intercritical annealing medium-Mn steel.J Iron Steel Res Int2021;28:762-72

[14] Ma J,Sun L.Two-step intercritical annealing to eliminate Lüders band in a strong and ductile medium Mn steel.Metall Mater Trans A2018;49:4404-8

[15] Emadoddin E,Daneshi G.Correlation between Luder strain and retained austenite in TRIP-assisted cold rolled steel sheets.Mater Sci Eng A2007;447:174-9

[16] Mao W,Gong W,Kawasaki T.Quantitatively evaluating the huge Lüders band deformation in an ultrafine grain stainless steel by combining in situ neutron diffraction and digital image correlation analysis.Scr Mater2023;235:115642

[17] Wang X,He B,Huang M.Microscopic strain partitioning in Lüders band of an ultrafine-grained medium Mn steel.Mater Sci Eng A2019;761:138050

[18] Wang X,Liu C,Huang M.Extraordinary Lüders-strain-rate in medium Mn steels.Materialia2019;6:100288

[19] Benzing JT,Mates SP,Raabe D.Intercritical annealing to achieve a positive strain-rate sensitivity of mechanical properties and suppression of macroscopic plastic instabilities in multi-phase medium-Mn steels.Mater Sci Eng A Struct Mater2021;803:140469 PMCID:PMC8176460

[20] Liu R,Lin C.A novel design to eliminate Lüders band in medium-Mn steel and its microstructure-property relationship.Crystals2023;13:936

[21] Qiu H,Inoue T.Yield-point phenomenon and plastic bands in ferrite-pearlite steels.Materials2022;16:195 PMCID:PMC9821852

[22] Mao W,Gong W.Martensitic transformation-governed Lüders deformation enables large ductility and late-stage strain hardening in ultrafine-grained austenitic stainless steel at low temperatures.Acta Mater2024;278:120233

[23] Fu J,Sui H,Duan H.Simulations of the localized necking and Lüders band in irradiated metals by crystal plasticity.Acta Mech Sin2023;39:22339

[24] Sarafanov GF.Deformation instability in crystalline alloys: Lüders bands.Mater Phys Mech2021;47

[25] Sun B,Vanderesse N.Macroscopic to nanoscopic in situ investigation on yielding mechanisms in ultrafine grained medium Mn steels: Role of the austenite-ferrite interface.Acta Mater2019;178:10-25

[26] Ma Y,Schökel A.Phase boundary segregation-induced strengthening and discontinuous yielding in ultrafine-grained duplex medium-Mn steels.Acta Mater2020;200:389-403

[27] Liang Z,Lu J,Tasan C.Influence of co-existing medium Mn and dual phase steel microstructures on ductility and Lüders band formation.Acta Mater2021;221:117418

[28] Luo H,Huang M.Effect of intercritical annealing on the Lüders strains of medium Mn transformation-induced plasticity steels.Mater Des2015;83:42-8

[29] Zhang M,Ding J.In situ high-energy X-ray diffraction mapping of Lüders band propagation in medium-Mn transformation-induced plasticity steels.Mater Res Lett2018;6:662-7

[30] Yan S,Liang T.Unusual step-like stress flow behavior and mechanisms of a 1.3 GPa grade medium-Mn steel with 51.2% ductility.Mater Des2023;235:112380

[31] Han J,Manladan SM.Effect of Lüders bands by strain ageing on strain distribution, microstructure and texture evolution of high-strength pipe steel.Acta Metall Sin2021;34:657-67

[32] Ma J,Lu Q,Wang L.Temperature-dependent macroscopic mechanical behaviors and their microscopic explanations in a medium Mn steel.Metall Mater Trans A2020;51:5180-6

[33] Liu Y,Li Y.Correlation of TRIP effect and Lüders band in a 2.3 GPa ultra-high yield strength medium Mn steel with martensite matrix.Mater Sci Eng A2025;930:148172

[34] Wang X,Huang M.Kinematic and thermal characteristics of Lüders and Portevin-Le Châtelier bands in a medium Mn transformation-induced plasticity steel.Acta Mater2017;124:17-29

[35] Liu C,Wang X,Jiang C.A new perspective on Lüders band formation in medium-Mn steels based on Lüders-strain-rate and dislocation evolution.Mater Sci Eng A2024;901:146553

[36] Varanasi RS,Sun B.Localized deformation inside the Lüders front of a medium manganese steel.Mater Sci Eng A2021;824:141816

[37] Zhang M,Ding J.In situ high-energy X-ray diffraction investigation of the micromechanical behavior of Fe-0.1C-10Mn-0/2Al steel at room and elevated temperatures.Mater Sci Eng A2018;729:444-51

[38] Lobodyuk VA,Pereloma EV.On tetragonality of the martensite crystal lattice in steels.Metall Mater Trans A2019;50:97-103

[39] Maruyama N,Tabata S.Microscopic shear deformation characteristics of the Lüders front in a metastable austenitic transformation-induced-plasticity steel.ISIJ Int2023;63:899-909

[40] Shariat BS,Yang H,Liu Y.Shear strain evolution during tension-induced Lüders-type deformation of polycrystalline NiTi plates.Mater Sci Eng A2022;839:142774