Microscopic insights into the mechanical behavior of a Ni-Co-based superalloy through in-situ neutron diffraction

Abstract

The micromechanical behaviors and dislocation evolution in a polycrystalline Ni-Co-based superalloy were systematically investigated by in situ neutron diffraction tensile testing combined with line profile analysis. The results reveal the sequential activation of γ′ shearing and Orowan looping mechanisms, with interphase load partitioning governed by strain-dependent interactions of dislocation and precipitate. During the initial plastic deformation, the γ and γ′ phases undergo co-deformation through dislocation shearing without load transfer, while the Orowan looping facilitates the load transfer from γ to γ′ phase at a higher strain level. Furthermore, the low stacking fault energy leads to a rising fraction of screw dislocations by suppressing cross-slip. Crucially, the pinning effect of γ′ precipitates hinders the rearrangement of these dislocations into low-energy structures, resulting in the formation of high-energy, weakly screened dislocation configurations. These findings provide new evidence for the planar slip dominance in Ni-Co-based superalloys, enabling quantitative assessment of microstructural evolution and micromechanical responses.

Keywords

Ni-Co-based superalloy / neutron diffraction / lattice strain / dislocation evolution

References

[1] Reed RC.The superalloys: fundamentals and applications, 1st ed.; Cambridge University Press, New York, 2006.

[2] Williams JC.Progress in structural materials for aerospace systems.Acta Mater2003;51:5775-99

[3] Osada T,Nagashima N,Yokokawa T.Optimum microstructure combination for maximizing tensile strength in a polycrystalline superalloy with a two-phase structure.Acta Mater2013;61:1820-9

[4] Zhang R,Bi Z.γ′′ variant-sensitive deformation behaviour of Inconel 718 superalloy.J Mater Sci Technol2022;126:169-81

[5] Gu Y,Yuan Y.Research progress in a high performance cast & wrought superalloy for turbine disc applications.Acta Metall Sin2015;51:1191-206

[6] Tian C,Cui C.Effects of Co content on tensile properties and deformation behaviors of Ni-based disk superalloys at different temperatures.Mater Des2015;88:123-31

[7] Gu YF,Harada H.Development of Ni-Co base alloys for high-temperature disk applications. In Superalloys 2008 (Eleventh International Symposium), Champion, PA, USA, September 14-18, 2008; Reed, R. C.; Green, K. A, Caron, P.; Gabb, T. P.; Fahrmann, M. G.; Huron, E. S., Eds.; TMS: Warrendale, PA, 2008; pp 53-61.

[8] Al-hammadi RA,Cui C,Zhou Y.Effects of temperature on superplastic and fracture behaviors of a Ni-Co-based superalloy.J Alloys Compd2023;958:170524

[9] Gu Y,Cui C,Sato A.New Ni-Co-base disk superalloys with higher strength and creep resistance.Scr Mater2006;55:815-8

[10] Yuan Y,Osada T,Yokokawa T.A new method to strengthen turbine disc superalloys at service temperatures.Scr Mater2012;66:884-9

[11] Vorontsov VA,Hardy MC,Bantounas I.Precipitate dissolution during deformation induced twin thickening in a CoNi-base superalloy subject to creep.Acta Mater2022;232:117936

[12] Li Y,Liu B.Investigation of microstructure evolution and mechanical properties of multi-precipitation Ni-Co base superalloys.Mater Sci Eng A2021;801:140333

[13] Yang C,Wang X.Effect of pre-tensile treatments on the mechanical properties and deformation mechanism of a novel Ni-based superalloy.Mater Sci Eng A2023;874:145063

[14] Ding R,Qin H.Effect of test temperature on deformation microstructure and tensile property of a novel Ni-Co-based superalloy.Mater Sci Eng A2024;915:147269

[15] Qi D,Du K.Temperature effects on the transition from lomer-cottrell locks to deformation twinning in a Ni-Co-based superalloy.Scr Mater2016;125:24-8

[16] Daymond M,Clausen B.Evidence of variation in slip mode in a polycrystalline nickel-base superalloy with change in temperature from neutron diffraction strain measurements.Acta Mater2007;55:3089-102

[17] Preuss M,Grant B.The effect of γ′ particle size on the deformation mechanism in an advanced polycrystalline nickel-base superalloy. In Superalloys 2008 (Eleventh International Symposium), Champion, PA, USA, September 14-18, 2008; Reed, R. C.; Green, K. A, Caron, P.; Gabb, T. P.; Fahrmann, M. G.; Huron, E. S., Eds.; TMS: Warrendale, PA, 2008; pp 405-14.

[18] Grant BM,Quinta da Fonseca J,Preuss M.Deformation behaviour of an advanced nickel-based superalloy studied by neutron diffraction and electron microscopy.Acta Mater2012;60:6829-41

[19] Jaladurgam NR,Kelleher J,Steuwer A.Microstructure-dependent deformation behaviour of a low γ′ volume fraction Ni-base superalloy studied by in-situ neutron diffraction.Acta Mater2020;183:182-95

[20] Goodfellow A,Jones N,Hardy M.The effect of Mo on load partitioning and microstrain evolution during compression of a series of polycrystalline Ni-Based superalloys.Acta Mater2019;176:318-29

[21] Huang S,An K.Deformation mechanisms in a precipitation-strengthened ferritic superalloy revealed by in situ neutron diffraction studies at elevated temperatures.Acta Mater2015;83:137-48

[22] Yang J,Gao T.Deformation behavior of nickel-based superalloys with bimodal γ′ size distribution studied by in-situ neutron diffraction combined with EVPSC modeling.J Alloys Compd2024;977:173382

[23] Gao Y,Li H.Grain-size dependent elastic-plastic deformation behaviour of inconel 625 alloy studied by in-situ neutron diffraction.Intermetallics2021;138:107340

[24] Jaladurgam NR,Colliander MH.Macro- and micro-mechanical behaviour of a γ′ strengthened Ni-based superalloy at cryogenic temperatures.Mater Des2021;209:109954

[25] Francis E,Fonseca JQD.High-temperature deformation mechanisms in a polycrystalline nickel-base superalloy studied by neutron diffraction and electron microscopy.Acta Mater2014;74:18-29

[26] Ungár T,Ribárik G.Crystallite size distribution and dislocation structure determined by diffraction profile analysis: principles and practical application to cubic and hexagonal crystals.J Appl Crystallogr2001;34:298-310

[27] Ribárik G,Gubicza J.MWP-fit : a program for multiple whole-profile fitting of diffraction peak profiles by abinitio theoretical functions.J Appl Crystallogr2001;34:669-76

[28] Harjo S,Tomota Y.Work hardening, dislocation structure, and load partitioning in lath martensite determined by in situ neutron diffraction line profile analysis.Metall Mater Trans A2017;48:4080-92

[29] Akama D,Takaki S.Change in dislocation characteristics with cold working in ultralow-carbon martensitic Steel.ISIJ Int2016;56:1675-80

[30] Gubicza J,Nagy P.In-situ study of the microstructure evolution during tension of a Mg-Y-Zn-Al alloy processed by rapidly solidified ribbon consolidation technique.J Magnes Alloys2024;12:2024-40

[31] Ying H,He H.Anomalous dislocation response to deformation strain in CrFeCoNiPd high-entropy alloys with nanoscale chemical fluctuations.Scr Mater2024;250:116181

[32] Xiao Z,Gu J.Tensile properties and deformation mechanisms of a new Ni-Co base superalloy from room temperature up to 750 °C.Intermetallics2022;150:107697

[33] Oishi R,Nishimaki Y.Rietveld analysis software for J-PARC.Nucl Instrum Methods Phys Res Sect A2009;600:94-6

[34] Coakley J.Lattice strain evolution in a high volume fraction polycrystal nickel superalloy.Scr Mater2012;67:435-8

[35] Ungár T,Jóni B.Dislocation structure in different texture components determined by neutron diffraction line profile analysis in a highly textured Zircaloy-2 rolled plate.J Appl Crystallogr2015;48:409-17

[36] Ribárik G,Ungár T.The convolutional multiple whole profile (CMWP) fitting method, a global optimization procedure for microstructure determination.Crystals2020;10:623

[37] Blondé R,Zhao L.High-energy X-ray diffraction study on the temperature-dependent mechanical stability of retained austenite in low-alloyed TRIP steels.Acta Mater2012;60:565-77

[38] Ma S,Majumdar B.Microstress evolution during in situ loading of a superalloy containing high volume fraction of γ′ phase.Scr Mater2003;48:525-30

[39] Dye D,Reed R.A two phase elastic-plastic self-consistent model for the accumulation of microstrains in Waspaloy.Acta Mater2001;49:1271-83

[40] Stone H,Reed R.On the generation of microstrains during the plastic deformation of Waspaloy.Acta Mater1999;47:4435-48

[41] Mcallister D,Peterson B,Wang Y.Lower temperature deformation mechanisms in a γ′′-strengthened Ni-base superalloy.Scr Mater2016;115:108-12

[42] Jackson M.Heat treatment of UDIMET 720Li: the effect of microstructure on properties.Mater Sci Eng A1999;259:85-97

[43] Ungár T,Révész Á.The contrast factors of dislocations in cubic crystals: the dislocation model of strain anisotropy in practice.J Appl Crystallogr1999;32:992-1002

[44] Borbély A.X-ray line profiles analysis of plastically deformed metals.Comptes Rendus Physique2012;13:293-306

[45] Ungár T,Topping M.Characterizing dislocation loops in irradiated polycrystalline Zr alloys by X-ray line profile analysis of powder diffraction patterns with satellites.J Appl Crystallogr2021;54:803-21

[46] Kuhlmann-wilsdorf D.Theory of plastic deformation: - properties of low energy dislocation structures.Mater Sci Eng A1989;113:1-41

[47] Kuhlmann-wilsdorf D.Chapter 59 the LES theory of solid plasticity.Dislocations Solids 2002;11:211-342

[48] Kumagai M,Kuroda M.In situ diffraction characterization on microstructure evolution in austenitic stainless steel during cyclic plastic deformation and its relation to the mechanical response.Mater Sci Eng A2021;820:141582