Optimizing Fastening Systems Characteristics to Prevent Stray Current at Urban Tracks

Abstract

Stray current in urban railway systems presents a significant challenge, including localized corrosion of rails, fastening systems, and adjacent metal structures, which compromises infrastructure safety. This study focuses on enhancing the resistance of rail fastening systems to mitigate stray current. Laboratory tests were conducted on samples where rails were fixed using two different fastening systems. During testing, the samples were subjected to 26 VDC, and electrical resistance and potential distribution were measured under controlled conditions. The results indicated that both systems were inadequately insulated, resulting in stray current, although in one system the anchor bolts were insulated primarily to prevent current leakage into the track substructure. Material analysis showed that the elastomeric elements in this system were not specified for high electrical resistance, so stray current was not prevented. Modifications for both systems were proposed to improve stray current prevention and were analyzed using numerical models in COMSOL Multiphysics software. The study highlights the importance of establishing precise requirements for the electrical resistance of fastening systems and developing a standardized methodology for measuring resistance.

Keywords

Urban tracks / Fastening systems / Stray current / Corrosion / Electrical resistance / Rail-to-earth potential

References

[1] Seimbille D (2014) Design of power supply system in DC electrified transit railways—influence of the high voltage network. Dissertation, KTH Royal Institute of Technology, Stockholm, Sweden

[2] Aatif S, Hu H, Rafiq F, He Z. Analysis of rail potential and stray current in MVDC railway electrification system. Rail Eng Sci, 2021, 26: 394-407

[3] Lin Y, Li K, Su M, Meng Y. Research on stray current distribution of metro based on numerical simulation. IEEE Int Symp Electromagn Compat, 2018

[4] Hanrob P, Kulworawanichpong T, Sumpavakup C, Ratniyomchai T. Evaluation of rail potential and stray current reduction by using NEG-ETP in DC railway system. Energy Rep, 2022, 8: 1166-1174

[5] Ma M. Operation mode of DC traction power supply system and its feeder protection. J Phys Conf Ser, 2021

[6] Xu SY, Li W, Wang YQ. Effects of vehicle running mode on rail potential and stray current in DC mass transit systems. IEEE Trans Veh Technol, 2013, 62: 3569-3580

[7] Kampeerawat W, Jongudomkarn J, Kirawanich P, Sumpavakup C. Effect of voltage limiting device operation on rail potential and stray current in DC railway systems. GMSARN Int J, 2023, 17: 213-219

[8] Cotton I, Charalambous C, Aylott P, Ernst P. Stray current control in DC mass transit systems. IEEE Trans Veh Technol, 2005, 54: 722-730

[9] Peelen WHA, Neeft EAC, Leegwater G, Van Kanten-Roos W, Courage WMG. Monitoring DC stray current interference of steel sheet pile structures in railway environment. Heron, 2011, 56: 107-122

[10] Makeyaw A, Yang X, Sun X, Liu K, Wu T, Chen L. Utility transformer DC bias caused by metro stray current—a review. Energies, 2025, 18 Article ID: 3678

[11] Ma J, Wang Z, Qian G, Lin W, Fan Y. Characteristics of stray current distribution in the power supply system of subway tunnels with a hollow circular section structure. Energies, 2025

[12] Ogunsola A, Mariscotti A, Sandrolini L. Estimation of stray current from a DC-electrified railway and impressed potential on a buried pipe. IEEE Trans Power Deliv, 2012, 27: 2238-2246

[13] Sun X, Yang X, Zhao R, Wang Z, Chen M, Zheng TQ. S-transform based time–frequency evaluation of dynamic stray current in zero-resistance converter system. Energies, 2025

[14] Vranešić K, Bhagat S, Mariscotti A, Vail R. Measures and prescriptions to reduce stray current in the design of new track corridors. Energies, 2023

[15] Zhou Q, Lin S, Zhang W. Analysis and mitigation of stray current in modern metro systems with OVPD and PSD. IEEE Trans Transp Electrif, 2023

[16] Charalambous CA, Aylott P, Buxton D. Stray current calculation and monitoring in DC mass-transit systems: interpreting calculations for real-life conditions and determining appropriate safety margins. IEEE Veh Technol Mag, 2016, 11: 24-31

[17] Tzeng YS, Lee CH. Analysis of rail potential and stray currents in a direct-current transit system. IEEE Trans Power Deliv, 2010, 25: 1516-1525

[18] Dolara A, Foiadelli F, Leva S. Stray current effects mitigation in subway tunnels. IEEE Trans Power Deliv, 2012, 27: 2304-2311

[19] Charalambous CA, Cotton I, Aylott P. Modeling for preliminary stray current design assessments: the effect of crosstrack regeneration supply. IEEE Trans Power Deliv, 2013, 28: 1899-1908

[20] Fichera F, Mariscotti A, Ogunsola A. Evaluating stray current from DC electrified transit systems with lumped parameter and multi-layer soil models. IEEE EuroCon, 2013

[21] Ogunsola A, Sandrolini L, Mariscotti A. Evaluation of stray current from a DC-electrified railway with integrated electric-electromechanical modeling and traffic simulation. IEEE Trans Ind Appl, 2015, 51: 5431-5441

[22] Charalambous CA. Comprehensive modeling to allow informed calculation of DC traction systems’ stray current levels. IEEE Trans Veh Technol, 2017, 66: 9667-9677

[23] Cai Z, Zhang X, Cheng H. Evaluation of DC-subway stray current corrosion with integrated multi-physical modeling and electrochemical analysis. IEEE Access, 2019, 7: 168404-168411

[24] Lin S, Huangfu Y, Zhou Q, Wang A. Evaluation and analysis model of stray current in the metro depot. IEEE Trans Transp Electrif, 2021, 7: 1780-1794

[25] Lin S, Wang A, Liu M, Lin X, Zhou Q, Zhao L. A multiple section model of stray current of DC metro systems. IEEE Trans Power Deliv, 2021, 36: 1582-1593

[26] Zhou Q, Lin S, Lin X, Wang A. A uniform model for stray current of long-line DC metro systems. IEEE Trans Transp Electrif, 2022, 8: 2915-2927

[27] Zhu Q, Cao A, Zaifend W, Song J, Shengli C. Stray current corrosion in buried pipeline. Anti-Corros Methods Mater, 2011, 58: 234-237

[28] Cui G, Li ZL, Yang C, Wang M. The influence of DC stray current on pipeline corrosion. Pet Sci, 2016, 13: 135-145

[29] Tang K. Stray current induced corrosion of steel fibre reinforced concrete. Cem Concr Res, 2017, 100: 445-456

[30] Chen Z, Koleva D, Van Breugel K. A review on stray current-induced steel corrosion in infrastructure. Corros Rev, 2017, 35: 397-423

[31] Mujezinović A, Martinez S, Kekez K. Estimating harmful effect of dynamic stray currents on pipeline by simultaneous multiparametric field measurements, continuous wavelet cross-correlation analysis, and frequency plots. Mater Corros, 2018

[32] Wang C, Li W, Wang Y, Yang X, Xu S. Study of electrochemical corrosion on Q235A steel under stray current excitation using combined analysis by electrochemical impedance spectroscopy and artificial neural network. Constr Build Mater, 2020

[33] Li Y, Jiao M, Wang Y, Li W, Kang H, Zhang W. Effect of soil salt content on stray current corrosion of buried metal. IEEE Access, 2022, 10: 85843-52553

[34] Li X, Chen J, Yang X, He R, Meng T (2024) Development of stray current detection system for buried steel pipeline based on STM 32, Third International Conference on Testing Technology and Automation Engineering 13079. https://doi.org/10.1117/12.3015428

[35] Li S, Liu W, Ma Q, Liu F, Yang Z, Yang S. Novel method for rail insulation degradation diagnosis driven by diffusion law of stray current. Int J Electr Power Energy Syst, 2025

[36] Vranešić K, Lakušić S, Serdar M. Influence of stray current on fastening system components in urban railway tracks. Appl Sci (Basel), 2023

[37] Vranešić K, Lakušić S, Serdar M, Alar V. Detrimental effect of stray current on rails and fastening systems in urban railway tracks. Constr Build Mater, 2023

[38] Vranešić K, Haladin I, Burnać K. Influence of climate changes on railway superstructure. J Croat Assoc Civ Eng, 2025, 77: 43-67

[39] CENELEC: EN_50122-2_2022: Railway applications—fixed installations—electrical safety, earthing and the return circuit—part 2: Provisions against the effects of stray currents caused by DC traction systems

[40] Du G, Xia Y, Li Q, Zhang G, Zheng Z, Guo X, et al.. Method for mitigating stray current in DC metro line with local high insulation. Electr Eng, 2025, 107: 11199-11208

[41] Bhagat S, Yang X, Wang M, Mariscotti A. Review and evaluation of stray current mitigation for urban rail transit. Trans China Electrotech Soc, 2020, 36: 101-109

[42] Bhagat S, Bongiorno J, Mariscotti A. Uncertainty of standardized track insulation measurement methods for stray current assessment. Sensors (Basel), 2023, 23: 1-19

[43] Wang C, Wang Y, Xu S, Li W, Wang S, Wen S, et al.. Intelligent measurement method of transition resistance of insulation fasteners in urban rail transit system based on SSA-optimized algorithm. Eng Fail Anal, 2024, 165(November): 1-6

[44] Xu S, Sun J, Wang C, Xing F. Novel method for insulation degradation location of rail transit system based on fiber grating. IEEE Trans Veh Technol, 2024, 73(2): 1899-1909

[45] Vranešić K (2022) Impact of stray currents on rail fastening components in urban areas. Dissertation. University of Zagreb

[46] Bai Y, He Z, Qu S, Wang X, Li P, Zhang X, et al.. Rail pad damping characteristics in track vibration reduction evaluated through hammer tests and theoretical analysis. Measurement, 2025, 239: 2-7

[47] Seyedkazemi M, Wenqi H, Jing G, Ahmadi P, Shuguo W, Khajehdezfuly A. Visco-elastic materials in railway superstructure: a comprehensive review. Road Mater Pavement Des, 2025

[48] Kraśkiewicz C, Urbaniak M, Piotrowski A. Experimental study on the elastic support in a discrete rail fastening system used in ballastless tram track structures. Materials, 2025

[49] Yang G, He Y, Han J, Wang X, Chi M. Study on the non-linear vibration and impact characteristics of composite structure of embedded track. J Low Freq Noise Vib Act Control., 2025, 44: 1726-1745

[50] GDM-9061 Specifications. https://www.gwinstek.com/en-global/products/downloadSeriesSpec/1901. Accessed 26 February 2026

[51] Fluke 179 TRMS Digital Multimeter. https://www.fluke.com/en/product/electrical-testing/digital-multimeters/fluke-179. Accessed 26 February 2026

[52] CEN. EN 13146-5 2012 Railway applications—track—test methods for fastening systems—part 5: Determination of electrical resistance

[53] STM International—ASTM D5291-10 (2015) standard test methods for instrumental determination of carbon, hydrogen, and nitrogen in petroleum products and lubricants

[54] CE: EN 13146—Railway applications. track. Test methods for fastening systems

[55] Wang Y, Li Y, Li H, Dang W, Zheng A. Study on the correlation between soil resistivity and multiple influencing factors using the entropy weight method and genetic algorithm. Electr Power Syst Res, 2025, 246: 1-6

[56] Naik TR, Asce F, Kraus RN, Ramme BW, Chun YM, Kumar R. High-carbon fly ash in manufacturing conductive CLSM and concrete. J Mater Civ Eng, 2006, 18: 743-746

[57] Memon S, Fromme P. Use of Rail boot and collection mat to control the electrolysis of rail and utilities in dv powered transit agencies. Joint Rail Conference, 2014

[58] Xu W, Zhang B, Deng Y, Wang Z, Jiang Q, Yang L, et al.. Corrosion of rail tracks and their protection. Corros Rev, 2021, 39: 1-13

RIGHTS & PERMISSIONS

The Author(s)