TRIP steel retained austenite transformation under cyclic V-bending deformation

Hongyang Li , Yanjing Zhang , Wenjun Zhao , Zhifei Gu , Xianchao Li , Jinlong Ma

Journal of Wuhan University of Technology Materials Science Edition ›› 2014, Vol. 29 ›› Issue (3) : 594 -600.

PDF
Journal of Wuhan University of Technology Materials Science Edition ›› 2014, Vol. 29 ›› Issue (3) : 594 -600. DOI: 10.1007/s11595-014-0963-y
Article

TRIP steel retained austenite transformation under cyclic V-bending deformation

Author information +
History +
PDF

Abstract

To investigate the transformation behavior of TRIP steel retained austenite under cyclic load, cyclic V-bending deformation of low carbon Si-Mn TRIP600 was studied by experiment and finite element in this paper. The results showed that, under cyclic V-bending deformation, retained austenite in TRIP steel transformed into martensite gradually with the increasing of bending times, and for the symmetrical characteristic, upper surface and lower surface presented the same transformation tendency. From the first to the fourth V-bending deformation, retained austenite volume fraction decreased nearly linearly and then attained saturation step by step. Compressive stress state was helpful for martensite transformation than tension stress state with V-bending deformation, and strain magnitude was the determining factor for retaining austenite martensitic transformation. With the increasing of bending times effective stress increased and the relationship between maximum effective stress and bending times was nearly linear. Effective stress and effective strain distribution were non-uniform, the maximum effective stress and effective strain were present in the center of the samples. The relationships between retained austenite and V-bending times, and retained austenite with effective strain were set up as Eqs.(1)–(5). The relationship was typical quadric function, decreased linearly for the initial deformation and attained saturation finally.

Keywords

TRIP steel / martensitic transformation / retained austenite / cyclic load

Cite this article

Download citation ▾
Hongyang Li, Yanjing Zhang, Wenjun Zhao, Zhifei Gu, Xianchao Li, Jinlong Ma. TRIP steel retained austenite transformation under cyclic V-bending deformation. Journal of Wuhan University of Technology Materials Science Edition, 2014, 29(3): 594-600 DOI:10.1007/s11595-014-0963-y

登录浏览全文

4963

注册一个新账户 忘记密码

References

[1]

Takahashi M Development of High Strength Steels for Automobiles[C]. Nippon Steel Tech. Rep., 2003, 88: 2-6.

[2]

Wang S, Wang X, Hua Lixian Relationship between Retained Austenite Strain For Si-Mn TRIP Steel [J]. J. Univ. Sci. Technol. B, 1995, 2(1): 7-10.

[3]

Sugimoto K, Kobayashi M, Yasuki S, . Influence of Deformation Temperature on the Bauschinger Effect of a TRIP-Aided Dual-Phase Steel[J]. J. Jpn. Inst. Met., 1994, 58(5): 501-506.

[4]

Leblond J B Mathematical Modelling of Transformation Plasticity in Steels II: Coupling with Strain Hardening Phenomena[J]. Int. J. Plast., 1989, 5(6): 573-591.

[5]

Taleb L, Sidoroff F A Micromechanical Modeling of the Greenwood-Johnson Mechanism in Transformation induced Plasticity[J]. Int. J. Plast., 2003, 19(10): 1 821-1 842.

[6]

Fischer F D, Berveiller M, Tanaka K, . Continuum Mechanical Aspects of Phase Transformations in Solids[J]. Arch. Appl. Mech., 1994, 64(2): 54-85.

[7]

Mazzoni-Leduca L, Pardoenb T, Massart T J Strain Gradient Plasticity Analysis of Transformation Induced Plasticity in Multiphase Steels[J]. Int. J. Solids Struct., 2008, 45(20): 5 397-5 418.

[8]

Iwamoto T, Tsuta T Computational Simulation on Deformation Behavior of CT Specimens of TRIP Steel under Mode I Loading for Evaluation of Fracture Toughness[J]. Int. J. Plast., 2002, 18(11): 1 583-1 606.

[9]

Li S H, Dan W J, Zhang W G, . Influences of Cyclic Loading on Martensite Transformation of TRIP Steels[J]. Met. Mater. Int., 2013, 19(2): 251-257.

[10]

Yan Y H, Kai G Y, Jian M D Transformation Behavior of Retained Austenite under Different Deformation Modes for Low Alloyed TRIPassisted Steels[J]. Mater. Sci. Eng., A, 2006, 441(1): 331-335.

[11]

Hilditch T B, Timokhina I B, Robertson L T, . Cyclic Deformation of Advanced High-Strength Steels: Mechanical Behavior and Microstructural Analysis[J]. Metall. Mater. Trans. A, 2009, 40(2): 342-353.

[12]

Sugimoto K I, Kobayashi M, Yasuki S I Cyclic Deformation Behavior of a Transformation-Induced Plasticity-Aided Dual-Phase Steel[J]. Metall. Mater. Trans. A, 1997, 28(12): 2 637-2 644.

[13]

Stolarz J, Baffie N, Magnin T Effect of Grain Size on Austenite Stability and Room Temperature Low Cycle Fatigue Behaviour of Solution Annealed AISI 316LN Austenitic Stainless Steel[J]. Mater. Sci. Technol., 2007, 23(11): 1 278-1 284.

[14]

Müller-Bollenhagen C, Zimmermann M, Christ H J Very High Cycle Fatigue Behavior of Austenitic Stainless Steel and the Effect of Straininduced Martensite[J]. Int. J. Fatigue, 2010, 32(6): 936-942.

AI Summary AI Mindmap
PDF

119

Accesses

0

Citation

Detail

Sections
Recommended

AI思维导图

/