Improving creep strain and mechanical properties of Al-Zn-Mg-Cu alloy under high stress level via pre-aging

Abstract

This study delved into the influence of pre-aging on the creep behavior and mechanical properties of an Al-Zn-Mg-Cu alloy subjected to high creep level. The creep strain was improved significantly for both pre-aged (120 °C for 6 h) and T4 samples under high creep stresses (280 MPa). Notably, pre-aging endowed the alloy with a long “peak-aging strengthening zone” during high-stress creep aging. This can effectively extend the creep aging time and enhance the creep strain while maintaining high strength of the alloy. This may stem from the additional consumption of vacancies and solute atoms by the pre-aging treatment, inhibiting the transformation of the η′phase into the η phase. Moreover, the pre-aging promotes the formation of fine, high density, and uniformly distributed η′ phase. It can also reduce the diffusion of solute atoms from inter grain to grain boundaries (GBs) during high-stress creep aging. This effectively impeded the coarsening of precipitates at GBs, reducing the width of the precipitation-free zone, and consequently minimized plasticity loss induced by high creep stress. Therefore, a suitable pre-aging can make the samples still maintain outstanding mechanical properties during the high-stress creep aging, which opens a new way of thinking to enhance the creep deformation behavior and aging-strengthening behavior in a synchronized manner. In particular, this provides a new approach to address the tendency of large rib-stiffened tank plates to develop high-stress zones during creep aging, leading to over-aging.

Keywords

AA7150 alloy / pre-aging treatment / high-stress creep aging / creep-aging response / strength / precipitation behavior

References

[1] Azimi A, Shokuhfar A, Zolriasatein A. Nanostructured Al-Zn-Mg-Cu-Zr alloy prepared by mechanical alloying followed by hot pressing [J]. Materials Science and Engineering A, 2014, 595: 124-130

[2] Huang R-s, Yang H-f, Sun P, et al.. Effects of Mg contents on microstructures and corrosion behaviors of homogenization Al-Zn-Mg-Cu alloys [J]. Corrosion Science, 2023, 223: 111461

[3] Huang R-s, Sun P, Zhou L-x, et al.. The effects of deformation parameters on the second phases and softening behavior of Al-Zn-Mg-Cu alloys [J]. Journal of Materials Research and Technology, 2024, 33: 2226-2243

[4] Jeshvaghani R A, Zohdi H, Shahverdi H R, et al.. Influence of multi-step heat treatments in creep age forming of 7075 aluminum alloy: Optimization for springback, strength and exfoliation corrosion [J]. Materials Characterization, 2012, 73: 8-15

[5] Jiang X-y, Zhang Y, Yi D-q, et al.. Low-temperature creep behavior and microstructural evolution of 8030 aluminum cables [J]. Materials Characterization, 2017, 130: 181-187

[6] Li H, Zhan L-h, Huang M-h, et al.. Investigation on the asymmetric creep ageing behaviour of 2195-T84 Al-Li alloy under different tensile and compressive stress levels [J]. Intermetallics, 2021, 131: 107078

[7] Jeshvaghani R A, Shahverdi H R, Hadavi S M M. Investigation of the age hardening and operative deformation mechanism of 7075 aluminum alloy under creep forming [J]. Materials Science and Engineering A, 2012, 552: 172-178

[8] Lyu F-g, Li Y, Shi Z-s, et al.. Stress and temperature dependence of stress relaxation ageing behaviour of an Al-Zn-Mg alloy [J]. Materials Science and Engineering A, 2020, 773: 138859

[9] Zhan X, Tang J-g, Li H-z, et al.. Effects of non-isothermal aging on mechanical properties, corrosion behavior and microstructures of Al-Cu-Mg-Si alloy [J]. Journal of Alloys and Compounds, 2020, 819: 152960

[10] Lei C, Yang H, Li H, et al.. Dependence of creep age formability on initial temper of an Al-Zn-Mg-Cu alloy [J]. Chinese Journal of Aeronautics, 2016, 29(5): 1445-1454

[11] Dong Y, Ye L-y, Tang J-g, et al.. The effects of temperature on the creep-aging behavior and mechanical properties of AA2050-T34 alloy [J]. Materials Science and Engineering A, 2020, 796: 140010

[12] Yang H-f, Duan Y-hua. Near-orientation deformation banding formation mechanism of Al-Mg-Mn-Er alloy [J]. Materials Research Letters, 2025, 13(4): 328-337

[13] Lin Y C, Zhang J-l, Chen M-song. Evolution of precipitates during two-stage stress-aging of an Al-Zn-Mg-Cu alloy [J]. Journal of Alloys and Compounds, 2016, 684: 177-187

[14] Li H, Zhan L-h, Huang M-h, et al.. Effects of pre-strain and stress level on stress relaxation ageing behaviour of 2195 Al-Li alloy: Experimental and constitutive modelling [J]. Journal of Alloys and Compounds, 2021, 851: 156829

[15] Ma Z-y, Zhan L-h, Liu C-h, et al.. Stress-level-dependency and bimodal precipitation behaviors during creep ageing of Al-Cu alloy: Experiments and modeling [J]. International Journal of Plasticity, 2018, 110: 183-201

[16] Hu L-b, Zhan L-h, Liu Z-l, et al.. The effects of pre-deformation on the creep aging behavior and mechanical properties of Al-Li-S4 alloys [J]. Materials Science and Engineering A, 2017, 703: 496-502

[17] Chen F, Zhong J, Zhan L-h, et al.. Effect of pre-aging on creep aging properties and microstructure evolution of 2195 Al-Li alloy [J]. Journal of Materials Research and Technology, 2022, 21: 1029-1041

[18] Yang W-h, Zhang Y-l, Yang H-f, et al.. Effect of non-isothermal retrogression and re-aging treatment on microstructure evolution and mechanical properties of Al-Zn-Mg-Cu alloy [J]. Journal of Materials Research and Technology, 2024, 31: 1728-1743

[19] Lee Y S, Koh D H, Kim H W, et al.. Improved bake-hardening response of Al-Zn-Mg-Cu alloy through pre-aging treatment [J]. Scripta Materialia, 2018, 147: 45-49

[20] Li Z-g, Zang R-j, Zhao P-z, et al.. Effects of pre-aging and natural aging on the clusters, strength and hemming performance of AA6014 alloys [J]. Materials Science and Engineering A, 2020, 782: 139206

[21] Luo J, Luo H-y, Li S-j, et al.. Effect of pre-ageing treatment on second nucleating of GPII zones and precipitation kinetics in an ultrafine grained 7075 aluminum alloy [J]. Materials & Design, 2020, 187: 108402

[22] Wang F, Gong Y-l, Du Y, et al.. Microstructures and mechanical properties of an Al-Zn-Mg-Cu alloy processed by two-step aging treatment [J]. Journal of Materials Engineering and Performance, 2020, 29(7): 4404-4411

[23] Li G-j, Guo M-x, Du J-q, et al.. Synergistic improvement in bake-hardening response and natural aging stability of Al-Mg-Si-Cu-Zn alloys via non-isothermal pre-aging treatment [J]. Materials & Design, 2022, 218: 110714

[24] Chung T F, Yang Y L, Huang B M, et al.. Transmission electron microscopy investigation of separated nucleation and in-situ nucleation in AA7050 aluminium alloy [J]. Acta Materialia, 2018, 149: 377-387

[25] Chung T F, Yang Y L, Shiojiri M, et al.. An atomic scale structural investigation of nanometre-sized η precipitates in the 7050 aluminium alloy [J]. Acta Materialia, 2019, 174: 351-368

[26] Deschamps A, Fribourg G, Bréchet Y, et al.. In situ evaluation of dynamic precipitation during plastic straining of an Al-Zn-Mg-Cu alloy [J]. Acta Materialia, 2012, 60(5): 1905-1916

[27] Ho K C, Lin J, Dean T A. Constitutive modelling of primary creep for age forming an aluminium alloy [J]. Journal of Materials Processing Technology, 2004, 153–154: 122-127

[28] Jeunechamps P P, Ho K C, Lin J, et al.. A closed form technique to predict springback in creep age-forming [J]. International Journal of Mechanical Sciences, 2006, 48(6): 621-629

[29] Lam A C L, Shi Z-s, Lin J-g, et al.. Influences of residual stresses and initial distortion on springback prediction of 7B04-T651 aluminium plates in creep-age forming [J]. International Journal of Mechanical Sciences, 2015, 103: 115-126

[30] Lam A C L, Shi Z-s, Yang H-l, et al.. Creep-age forming AA2219 plates with different stiffener designs and pre-form age conditions: Experimental and finite element studies [J]. Journal of Materials Processing Technology, 2015, 219: 155-163

[31] Ho K C, Lin J, Dean T A. Modelling of springback in creep forming thick aluminum sheets [J]. International Journal of Plasticity, 2004, 20(4): 733-751 5

[32] Lei C, Li H, Fu J, et al.. Non-isothermal creep aging behaviors of an Al-Zn-Mg-Cu alloy [J]. Materials Characterization, 2018, 144: 431-439

[33] Li C-b, Han S-q, Liu S-d, et al.. Grain structure effect on quench sensitivity of Al-Zn-Mg-Cu-Cr alloy [J]. Transactions of Nonferrous Metals Society of China, 2016, 26(9): 2276-2282

[34] Zou Y, Wu X-d, Tang S-b, et al.. The effect of pre-ageing/stretching on the ageing-hardening behavior of Al-Zn-Mg-Cu alloys correlated with Zn/Mg ratio [J]. Materials Science and Engineering A, 2022, 830: 142331

RIGHTS & PERMISSIONS

Central South University