Sensitivity and effect of key operational parameters on performance of a dual-cylinder free-piston engine generator

Abstract

The free-piston engine generator (FPEG) is regarded as the next generation of energy conversion system which may replace traditional engines in the future. The effect of key operational parameters like excess air ratio of input mixture and ignition position on the engine performance of a dual-cylinder FPEG was investigated, and their sensitivity was analyzed in this paper. The operating compression ratio of the system is susceptible to changes in excess air ratio and ignition position. At the same time, it decreases from 15.8 to 6.6 when excess air ratio increases from 0.85 to 1.15, but it increases from 6.1 to 13.3 as ignition position increases from 15 mm to 20 mm. The operating frequency and indicated power are more sensitive to changes in excess air ratio than ignition position. But it is the opposite for the indicated thermal efficiency and friction loss. Excess air ratio and ignition position have a quite similar influence on heat transfer. Therefore, from the perspective of system operation and performance, it is preferable to keep excess air coefficient slightly below 1.0. In contrast, when selecting ignition position, it is of great importance to comprehensively consider the risk of structural damage caused by the increase in the compression ratio and in-cylinder gas pressure.

Keywords

free piston engine generator / excess air ratio / ignition position / operation characteristics / sensitivity analysis / thermal efficiency

References

[1] MikalsenR, RoskillyA P. A review of free-piston engine history and applications [J]. Applied Thermal Engineering, 2007, 27(14–15): 2339-2352

[2] JiaB, MikalsenR, SmallboneA, et al.. A study and comparison of frictional losses in free-piston engine and crankshaft engines [J]. Applied Thermal Engineering, 2018, 140: 217-224

[3] JiaB, SmallboneA, ZuoZ, et al.. Design and simulation of a two- or four-stroke free-piston engine generator for range extender applications [J]. Energy Conversion and Management, 2016, 111: 289-298

[4] HanipahM R, MikalsenR, RoskillyA P. Recent commercial free-piston engine developments for automotive applications [J]. Applied Thermal Engineering, 2015, 75: 493-503

[5] RenH, XieH, YangH, et al.. Asymmetric vibration characteristics of two-cylinder four-stroke single-piston hydraulic free piston engine [J]. Journal of Central South University, 2014, 21(10): 3762-3768

[6] JiaB, TianG, FengH, et al.. An experimental investigation into the starting process of free-piston engine generator [J]. Applied Energy, 2015, 157: 798-804

[7] JiaB, SmallboneA, MikalsenR, et al.. Disturbance analysis of a free-piston engine generator using a validated fast-response numerical model [J]. Applied Energy, 2017, 185: 440-451

[8] LuJ, XuZ, LiuD, et al.. A starting control strategy of single-cylinder two-stroke free-piston engine generator [J]. Journal of Engineering for Gas Turbines and Power, 2020, 142(3): 031020

[9] ZhangC, LiK, SunZ. Modeling of piston trajectory-based HCCI combustion enabled by a free piston engine [J]. Applied Energy, 2015, 139: 313-326

[10] RaheemA T, AzizA R A, ZulkifliS A, et al.. Optimisation of operating parameters on the performance characteristics of a free piston engine linear generator fuelled by CNG-H₂ blends using the response surface methodology (RSM) [J]. International Journal of Hydrogen Energy, 2022, 47(3): 1996-2016

[11] ClarkN, McdanielT, AtkinsonR J, et al.. Modeling and development of a linear engine [C]//Proceedings of the Spring Technical Conference of the ASME Internel Combustion Engine Division. Fort Lauderdale, 1998, 30(2): 49-57

[12] AtkinsonC M, PetreanuS, ClarkN, et al.. Numerical simulation of a two-stroke linear engine-alternator combination [C]. SAE Technical Paper Series, 1999, 400 Commonwealth Drive, Warrendale, PA, United States, SAE International, 1416-1430

[13] JiaB, MikalsenR, SmallboneA, et al.. Piston motion control of a free-piston engine generator: A new approach using cascade control [J]. Applied Energy, 2016, 179: 1166-1175

[14] HanipahMDevelopment of a spark ignition free-piston engine generator [D], 2015, Newcastle, Newcastle University

[15] LiQResearch on free piston engine generator [D], 2011, Shanghai, Shanghai Jiao Tong University(in Chinese)

[16] LiQ, LiuT, XiaoJ, et al.. Design of free piston engine ECU based on MC9S12 [J]. Chinese Internal Combustion Engine Engineering, 2011, 32(1): 19-23(in Chinese)

[17] MaoJ, ZuoZ, FengH. Parameters coupling designation of diesel free-piston linear alternator [J]. Applied Energy, 2011, 88(12): 4577-4589

[18] MaoJ, ZuoZ, LiW, et al.. Multidimensional scavenging analysis of a free-piston linear alternator based on numerical simulation [J]. Applied Energy, 2011, 88(4): 1140-1152

[19] JiaB, ZuoZ, TianG, et al.. Development and validation of a free-piston engine generator numerical model [J]. Energy Conversion and Management, 2015, 91: 333-341

[20] JiaB, ZuoZ, FengH, et al.. Investigation of the starting process of free-piston engine generator by mechanical resonance [J]. Energy Procedia, 2014, 61: 572-577

[21] FengH, ZhangZ, JiaB, et al.. Investigation of the optimum operating condition of a dual piston type free piston engine generator during engine cold start-up process [J]. Applied Thermal Engineering, 2021, 182: 116124

[22] ZhangZ, FengH, JiaB, et al.. Effect of the stroke-to-bore ratio on the performance of a dual-piston free piston engine generator [J]. Applied Thermal Engineering, 2021, 185116456

[23] WuL, FengH, ZhangZ, et al.. Research on starting process and control strategy of opposed-piston free-piston engine generator—Simulation and test results [J]. Energy Reports, 2021, 74977-4987

[24] LiJ, ZuoZ, JiaB, et al.. Comparative analysis on friction characteristics between free-piston engine generator and traditional crankshaft engine [J]. Energy Conversion and Management, 2021, 245114630

[25] MikalsenR, RoskillyA P. Coupled dynamic-multidimensional modelling of free-piston engine combustion [J]. Applied Energy, 2009, 86(1): 89-95

[26] LiQ, XiaoJ, HuangZ. Simulation of a two-stroke free-piston engine for electrical power generation [J]. Energy & Fuels, 2008, 22(5): 3443-3449

[27] BoucherJ, LanzettaF, NikaP. Optimization of a dual free piston Stirling engine [J]. Applied Thermal Engineering, 2007, 27(4): 802-811

[28] KarabulutH. Dynamic analysis of a free piston Stirling engine working with closed and open thermodynamic cycles [J]. Renewable Energy, 2011, 36(6): 1704-1709

[29] GongY, ZhengD, WangW. Performance sensitivity analysis of liquid oxygen/methane rocket engine [J]. Journal of Rocket Propulsion, 2020, 46(1): 60-68(in Chinese)

[30] LiY, NingZ, LyuM, et al.. Evaluation of key engine technology based on fuel economy [J]. Vehicle Engine, 2019, 244(5): 8-15(in Chinese)

[31] AbdollahipourA, SoltanianH, PourmazaheriY, et al.. Sensitivity analysis of geomechanical parameters affecting a wellbore stability [J]. Journal of Central South University, 2019, 26(3): 768-778

[32] ZouX, GaoG, DongH, et al.. Crushing analysis and multi-objective optimization of bitubular hexagonal columns with ribs [J]. Journal of Central South University, 2017, 24(5): 1164-1173