Combustion and emission characteristics of diesel/n-butanol blends with split-injection and exhaust gas recirculation stratification

Abstract

Oxygen fuels have broad application prospects and great potential for realizing efficient and clean combustion, and hence this study applies diesel/n-butanol blends to explore the influence of split-injection strategy on combustion and emission characteristics. Simultaneously, changing the way of exhaust gas recirculation (EGR) gas introduction forms uneven in-cylinder components distribution, and utilizing EGR stratification optimizes the combustion process and allows better emission results. The results show that the split-injection strategy can reduce the NO_x emissions and keep smoke opacity low compared with the single injection, but the rise in accumulation mode particles is noticeable. NO_x emissions show an upward trend as the injection interval expands, while soot emissions are significantly reduced. The increase in pre-injection proportion causes the apparent low-temperature heat release, and the two-stage heat release can be observed during the process of main combustion heat release. More pre-injection mass makes NO_x gradually increase, but smoke opacity reaches the lowest point at 15% pre-injection proportion. EGR stratification can optimize the emission results under the split injection strategy, especially the considerable suppression of accumulation mode particulate emissions. Above all, fuel stratification coupled with EGR stratification is beneficial for further realizing the in-cylinder purification of pollutants.

Keywords

oxygen fuel / split-injection / exhaust gas recirculation (EGR) stratification / pollutant emissions / particle size distribution

References

[1] PartoaaA A, AbdolzadehM, RezaeizadehM. Effect of fin attachment on thermal stress reduction of exhaust manifold of an off road diesel engine [J]. Journal of Central South University, 2017, 24(3): 546-559

[2] ChoJ, KimK, BaekS, et al.. Abatement potential analysis on CO₂ and size-resolved particle emissions from a downsized LPG direct injection engine for passenger car [J]. Atmospheric Pollution Research, 2019, 10(6): 1711-1722

[3] GengP, CaoE, TanQ, et al.. Effects of alternative fuels on the combustion characteristics and emission products from diesel engines: A review [J]. Renewable and Sustainable Energy Reviews, 2017, 71: 523-534

[4] PhoungthongK, TekasakulS, TekasakulP, et al.. Comparison of particulate matter and polycyclic aromatic hydrocarbons in emissions from IDI-turbo diesel engine fueled by palm oil-diesel blends during long-term usage [J]. Atmospheric Pollution Research, 2017, 8(2): 344-350

[5] KamimotoT, BaeM HHigh combustion temperature for the reduction of particulate in diesel engines [C], 1988, 400 Commonwealth Drive, Warrendale, PA, United States, SAE International

[6] ChenZ, QinT, HeT, et al.. Effect of equivalence ratio on diesel direct injection spark ignition combustion [J]. Journal of Central South University, 2020, 27(8): 2338-2352

[7] KosakaH, AizawaT, KamimotoT. Two-dimensional imaging of ignition and soot formation processes in a diesel flame [J]. International Journal of Engine Research, 2005, 6(1): 21-42

[8] JinC, YaoM, LiuH, et al.. Progress in the production and application of n-butanol as a biofuel [J]. Renewable and Sustainable Energy Reviews, 2011, 15(8): 4080-4106

[9] LiY, NingZ, YanJ, et al.. Experimental investigation on combustion and unregulated emission characteristics of butanol-isomer/gasoline blends [J]. Journal of Central South University, 2019, 26(8): 2244-2258

[10] RakopoulosC D, RakopoulosD C, GiakoumisE G, et al.. The combustion of n-butanol/diesel fuel blends and its cyclic variability in a direct injection diesel engine [J]. Proceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 2011, 225(3): 289-308

[11] LiuH, LeeC F, HuoM, et al.. Comparison of ethanol and butanol as additives in soybean biodiesel using a constant volume combustion chamber [J]. Energy & Fuels, 2011, 25(4): 1837-1846

[12] ChenG, ShenY, ZhangQ, et al.. Experimental study on combustion and emission characteristics of a diesel engine fueled with 2, 5-dimethylfuran-diesel, n-butanol-diesel and gasoline-diesel blends [J]. Energy, 2013, 54: 333-342

[13] LuX, HanD, HuangZ. Fuel design and management for the control of advanced compression-ignition combustion modes [J]. Progress in Energy and Combustion Science, 2011, 37(6): 741-783

[14] LiY, TangW, ChenY, et al.. Potential of acetone-butanol-ethanol (ABE) as a biofuel [J]. Fuel, 2019, 242: 673-686

[15] LiY, ChenY, WuG, et al.. Experimental comparison of acetone-n-butanol-ethanol (ABE) and isopropanol-n-butanol-ethanol (IBE) as fuel candidate in spark-ignition engine [J]. Applied Thermal Engineering, 2018, 133: 179-187

[16] LiY, ChenY, WuG, et al.. Experimental evaluation of water-containing isopropanol-n-butanol-ethanol and gasoline blend as a fuel candidate in spark-ignition engine [J]. Applied Energy, 2018, 219: 42-52

[17] ZhaoHHCCI and CAI engines for the automotive industry [M], 2007, Cambridge, Woodhead Publishing

[18] ReitzR D. Directions in internal combustion engine research [J]. Combustion and Flame, 2013, 160(1): 1-8

[19] KrishnasamyA, GuptaS K, ReitzR D. Prospective fuels for diesel low temperature combustion engine applications: A critical review [J]. International Journal of Engine Research, 2021, 22(7): 2071-2106

[20] MaghbouliA, YangW, AnH, et al.. Effects of injection strategies and fuel injector configuration on combustion and emission characteristics of a D. I. diesel engine fueled by bio-diesel [J]. Renewable Energy, 2015, 76: 687-698

[21] FitzgeraldR P, SteeperR. Thermal and chemical effects of NVO fuel injection on HCCI combustion [J]. SAE International Journal of Engines, 2010, 3(1): 46-64

[22] CungK, MoizA, JohnsonJ, et al.. Spray-combustion interaction mechanism of multiple-injection under diesel engine conditions [J]. Proceedings of the Combustion Institute, 2015, 35(3): 3061-3068

[23] KumarS, ChoJ H, ParkJ, et al.. Advances in diesel-alcohol blends and their effects on the performance and emissions of diesel engines [J]. Renewable and Sustainable Energy Reviews, 2013, 22: 46-72

[24] SuhH K. Investigations of multiple injection strategies for the improvement of combustion and exhaust emissions characteristics in a low compression ratio (CR) engine [J]. Applied Energy, 2011, 88(12): 5013-5019

[25] de la GarzaO A, Martínez-MartínezS, AvulapatiM M, et al.. Biofuels and its spray interactions under pilot-main injection strategy [J]. Energy, 2021, 219: 119464

[26] BragadeshwaranA, KasiananthamN, KaisanM U, et al.. Influence of injection timing and exhaust gas recirculation (EGR) rate on lemon peel oil-fuelled CI engine [J]. Environmental Science and Pollution Research International, 2019, 26(21): 21890-21904

[27] WangP, TangX, ShiL, et al.. Experimental investigation of the influences of Miller cycle combined with EGR on performance, energy and exergy characteristics of a four-stroke marine regulated two-stage turbocharged diesel engine [J]. Fuel, 2021, 300120940

[28] KobashiY, WangY, ShibataG, et al.. Ignition control in a gasoline compression ignition engine with ozone addition combined with a two-stage direct-injection strategy [J]. Fuel, 2019, 249154-160

[29] SunC, LiuY, QiaoX, et al.. Experimental study of effects of exhaust gas recirculation on combustion, performance, and emissions of DME-biodiesel fueled engine [J]. Energy, 2020, 197: 117233

[30] FuyutoT, NagataM, HottaY, et al.. In-cylinder stratification of external exhaust gas recirculation for controlling diesel combustion [J]. International Journal of Engine Research, 2010, 11(1): 1-15

[31] KaiserS A, SchildM, SchulzC. Thermal stratification in an internal combustion engine due to wall heat transfer measured by laser-induced fluorescence [J]. Proceedings of the Combustion Institute, 2013, 34(2): 2911-2919

[32] LiuH, ZhengZ, YaoM, et al.. Influence of temperature and mixture stratification on HCCI combustion using chemiluminescence images and CFD analysis [J]. Applied Thermal Engineering, 2012, 33–34135-143

[33] ZhangM, WangJ, HuangZ, et al.. Numerical study of effects of the intermediates and initial conditions on flame propagation in a real homogeneous charge compression ignition engine [J]. Thermal Science, 2014, 18(1): 79-87

[34] TsudaS, KosakaH, AizawaT. DE3-2: A study on effect of heterogeneity of oxygen concentration and temperature distributions in a combustion chamber on combustion and emissions of diesel engine (DE: Diesel engine combustion, general session papers) [J]. The Proceedings of the International Symposium on Diagnostics and Modeling of Combustion in Internal Combustion Engines, 2008, 2008(7): 189-196

[35] ChoiS, ParkW, LeeS, et al.. Methods for in-cylinder EGR stratification and its effects on combustion and emission characteristics in a diesel engine [J]. Energy, 2011, 36(12): 6948-6959

[36] ShenZ, CuiW, LiuZ, et al.. Distribution evolution of intake and residual gas species during CO₂ stratification combustion in diesel engine [J]. Fuel, 2016, 166: 427-435

[37] NordK E, HauptD. Reducing the emission of particles from a diesel engine by adding an oxygenate to the fuel [J]. Environmental Science & Technology, 2005, 39(16): 6260-6265

[38] ZhangY, TaoW, LiZ, et al.. Experimental studies on the combustion and particulate matter emission characteristics of biodiesel surrogate component/diesel [J]. Applied Thermal Engineering, 2018, 131: 565-575