Experimental investigation of effect of refrigerant gases, compressor lubricant and operating conditions on performance of a heat pump

Abstract

In the field of heat pumps, there are a number of parameters that affect the performance and efficiency of the apparatus, which have been the subject of studies by individual researchers in the literature. This study describes an experimental method in order to investigate the effects of some significant parameters on heat pump performance. In this regard, a laboratory heat pump setup has been utilized to operate in different working conditions for achieving an appropriate estimation to find out effects of mentioned parameters such as refrigerant type and charge amount, compressor oil viscosity, compressor cooling fan, secondary fluids temperature and flow rate. Different refrigerants have been selected and used as circulating fluid in the installed heat pump. Although this work has been devoted to a detailed attempt to recognize the effects of various parameters on the coefficient of performance (COP) value, an appropriate method has been carried out to survey the obtained results by using economic analysis. It was revealed that one of the main parameters is refrigerant charge amount which has a notable effect on COP. The temperature of the heat source was also tested and the performance of the system increased by more than 11% by employing mentioned modifications and various operating conditions. In addition, by selecting a low viscosity compressor oil, the system performance increased by 18%. This improvement is more than 6% for the case that cooling fan is installed to cool the compressor element.

Keywords

heat pump efficiency / coefficient of performance (COP) / performance / compressor oil / charge amount

References

[1] GürbüzE Y, VariyenliH İ, SözenA, KhanlariA, ÖktenM. Experimental and numerical analysis on using CuO-Al₂O₃/water hybrid nanofluid in a U-type tubular heat exchanger [J]. International Journal of Numerical Methods for Heat & Fluid Flow, 2021, 31(1): 519-540

[2] KhanlariA, SözenA, AfshariF, ÇirinC, TuncerA D, GungorA. Drying municipal sewage sludge with v-groove triple-pass and quadruple-pass solar air heaters along with testing of a solar absorber drying chamber [J]. Science of the Total Environment, 2020, 709: 136198

[3] AfshariF, SahinB, KhanlariA, ManayE. Experimental optimization and investigation of compressor cooling fan in an air-to-water heat pump [J]. Heat Transfer Research, 2020, 51(4): 319-331

[4] ÇakirU, ÇomakliK, ÇomakliK, KarsliS. An experimental exergetic comparison of four different heat pump systems working at same conditions: As air to air, air to water, water to water and water to air [J]. Energy, 2013, 58210-219

[5] PanL-s, WangH-x, ChenQ-y, ChenC. Theoretical and experimental study on several refrigerants of moderately high temperature heat pump [J]. Applied Thermal Engineering, 2011, 31(1112): 1886-1893

[6] ÇağlarA, YamaliC. Performance analysis of a solar-assisted heat pump with an evacuated tubular collector for domestic heating [J]. Energy and Buildings, 2012, 54: 22-28

[7] KongX Q, ZhangD, LiY, YangQ M. Thermal performance analysis of a direct-expansion solar-assisted heat pump water heater [J]. Energy, 2011, 36(12): 6830-6838

[8] FernandoP, PalmB, LundqvistP, GranrydE. Propane heat pump with low refrigerant charge: Design and laboratory tests [J]. International Journal of Refrigeration, 2004, 27(7): 761-773

[9] PoggiF, Macchi-TejedaH, LeducqD, BontempsA. Refrigerant charge in refrigerating systems and strategies of charge reduction [J]. International Journal of Refrigeration, 2008, 31(3): 353-370

[10] ChoiH, ChoH, ChoiJ M. Refrigerant amount detection algorithm for a ground source heat pump unit [J]. Renewable Energy, 2012, 42: 111-117

[11] ZhangD, WuQ B, LiJ P, KongX Q. Effects of refrigerant charge and structural parameters on the performance of a direct-expansion solar-assisted heat pump system [J]. Applied Thermal Engineering, 2014, 73(1): 522-528

[12] CorberánJ M, Martínez-GalvánI, Martínez-BallesterS, Gonzálvez-MaciáJ, Royo-PastorR. Influence of the source and sink temperatures on the optimal refrigerant charge of a water-to-water heat pump [J]. International Journal of Refrigeration, 2011, 34(4): 881-892

[13] BjörkE, PalmB. Refrigerant mass charge distribution in a domestic refrigerator, Part I: Transient conditions [J]. Applied Thermal Engineering, 2006, 26(89): 829-837

[14] GanjehsarabiH, DincerI, GungorA. Analysis and optimisation of a cascade active magnetic regenerative refrigeration system [J]. International Journal of Exergy, 2016, 19(2): 143

[15] GuptaR, IrvingR. Possible effects of future domestic heat pump installations on the UK energy supply [J]. Energy and Buildings, 2014, 84: 94-110

[16] BiancoV, ScarpaF, TagliaficoL A. Estimation of primary energy savings by using heat pumps for heating purposes in the residential sector [J]. Applied Thermal Engineering, 2017, 114938-947

[17] GaigalisV, SkemaR, MarcinauskasK, KorsakieneI. A review on heat pumps implementation in Lithuania in compliance with the National Energy Strategy and EU policy [J]. Renewable and Sustainable Energy Reviews, 2016, 53: 841-858

[18] MahmoudiM, DehghanM, HaghgouH, Keyanpour-RadM. Techno-economic performance of photovoltaic-powered air-conditioning heat pumps with variable-speed and fixed-speed compression systems [J]. Sustainable Energy Technologies and Assessments, 2021, 45: 101113

[19] YanG, BaiT, YuJ-lin. Energy and exergy efficiency analysis of solar driven ejector-compressor heat pump cycle [J]. Solar Energy, 2016, 125243-255

[20] GanjehsarabiH, DincerI, GungorA. Exergoeconomic analysis of a heat pump tumbler dryer [J]. Drying Technology, 2014, 32(3): 352-360

[21] SozenA, KeçebaçA, GurbuzE Y. Enhancing the thermal performance of diffusion absorption refrigeration system by using magnesium aluminate spinel oxide compound nanoparticles: An experimental investigation [J]. Heat and Mass Transfer, 2021, 57(10): 1583-1592

[22] HepbasliA, ColakN, HanciogluE, IcierF, ErbayZ. Exergoeconomic analysis of plum drying in a heat pump conveyor dryer [J]. Drying Technology, 2010, 28(12): 1385-1395

[23] AfshariF, KaragozS, ComakliO, GhasemiZ H. Thermodynamic analysis of a system converted from heat pump to refrigeration device [J]. Heat and Mass Transfer, 2019, 55(2): 281-291

[24] AfshariF, ComakliO, KaragozS, ZavaraghH G. A thermodynamic comparison between heat pump and refrigeration device using several refrigerants [J]. Energy and Buildings, 2018, 168: 272-283