Design of 32 kbit one-time programmable memory for microcontroller units
Hwang-gon Jeon , Hui-ling Yang , In-hwa Choi , Pan-bong Ha , Young-hee Kim
Journal of Central South University ›› 2012, Vol. 19 ›› Issue (12) : 3475 -3483.
Design of 32 kbit one-time programmable memory for microcontroller units
A 32 kbit OTP (one-time programmable) memory for MCUs (micro-controller units) used in remote controllers was designed. This OTP memory is used for program and data storage. It is required to apply 5.5 V to BL (bit-line) and 11 V to WL (word-line) for a OTP cell of 0.35 μm ETOX (EEPROM tunnel oxide) type by MagnaChip. We use 5 V transistors on column data paths to reduce the area of column data paths since they require small areas. In addition, we secure device reliability by using HV (high-voltage) transistors in the WL driver. Furthermore, we change from a static logic to a dynamic logic used for the WL driver in the core circuit. Also, we optimize the WD (write data) switch circuit. Thus, we can implement them with a small-area design. In addition, we implement the address predecoder with a small-area logic circuit. The area of the designed 32 kbit OTP with 5 V and HV devices is 674.725 μm×258.75 μm (=0.1745 mm2) and is 56.3% smaller than that using 3.3 V devices.
one-time programmable memory / micro controller unit / EEPROM tunnel oxide / small-area
| [1] |
|
| [2] |
|
| [3] |
|
| [4] |
|
| [5] |
|
| [6] |
|
| [7] |
|
| [8] |
|
| [9] |
|
| [10] |
|
| [11] |
|
| [12] |
|
| [13] |
|
| [14] |
|
| [15] |
|
/
| 〈 |
|
〉 |