Effect of vertical load difference on cracking behaviors in multistory masonry buildings and numerical simulation

Abstract

To investigate the causes of cracks in multistory masonry buildings, the effect of vertical load difference on cracking behaviors was investigated experimentally by testing and measuring the displacements at the testing points of a large sized real masonry U-shaped model. Additionally, the cracking behaviors in U-shaped model were analyzed with shear stress and numerical simulated with ANSYS software. The experimental results show that the deformation increases with the increase of the vertical load. The vertical load results in different deformation between the bearing wall and non-bearing wall, which leads to cracking on the non-bearing wall. The rapid deformation happens at 160 kN and cracks occur firstly at the top section of non-bearing wall near to the bearing wall. New cracks are observed and the previous cracks are enlarged and developed with the increase of vertical load. The maximum crack opening reaches 12 mm, and the non-bearing wall is about to collapse when the vertical load arrives at 380 kN. Theoretical analysis indicates that the shear stress reaches the maximum value at the top section of the non-bearing wall, and thus cracks tend to happen at the top section of the non-bearing wall. Numerical simulation results about the cracking behaviors are in good agreement with experiments results.

Keywords

vertical load difference / cracking / deformation / multistory masonry building

References

[1] MassartT. J., PeerlingsR. H. J., GeersM. G. D.. An enhanced multi-scale approach for masonry wall computations with localization of damage[J]. International Journal for Numerical Methods in Engineering, 2007, 69(5): 1022-1059

[2] SpenceS. M. J., GioffrèM., GrigoriuM. D.. Probabilistic models and simulation of irregular masonry walls[J]. Journal of Engineering Mechanics, 2008, 134(9): 750-762

[3] WuC.-q., HaoH.. Derivation of 3D masonry properties using numerical homogenization technique[J]. International Journal for Numerical Methods in Engineering, 2006, 66(11): 1717-1737

[4] PintucchiB., ZaniN.. Effects of material and geometric non-linearities on the collapse load of masonry arches[J]. European Journal of Mechanics, A Solids, 2009, 28(1): 45-61

[5] WangS.-h., TangC.-a., ZhuF.-sheng.. Numerical modeling and analysis of masonry micro-cracks[J]. Journal of Building Structure, 2003, 24(2): 64-69

[6] MilaniG., LourencoP., TralliA.. Homogenization approach for the limit analysis of out-of-plane loaded masonry walls[J]. Journal of Structural Engineering, 2006, 32(10): 1650-1663

[7] PophnJ. R. B., SchulzA. E., LuM., StolarskiH. K., OjardN. J.. Influence of transverse loading on the stability of slender unreinforced masonry walls[J]. Engineering Structures, 2008, 30(10): 2830-2839

[8] BaqiA., BhandariN. M., TrikhaD. N.. Experimental study of pre-stressed masonry flexural elements[J]. J Struct Eng, ASCE, 1999, 125(3): 245-254

[9] NaraineK., ShinaS. N.. Behavior of brick masonry under cyclic compressive loading[J]. J Struct Eng, ASCE, 1989, 115(6): 1432-1445

[10] RiceJ. R., RudnickiJ. W.. A note on some features of the theory of localization of deformation[J]. Int J Sol Struct, 1980, 16: 597-605

[11] SmitR. J. M.Toughness of heterogeneous polymeric systems: A modeling approach[D], 1998, Netherlands, Eindhoven University of Technology

[12] StrvroulakisG. E.. On the static behavior of cracked masonry walls[J]. European Journal of Mechanics, A Solids, 1990, 9(4): 341-358

[13] MassartT. J., PeerlingsR. H. J., GeersM. G. D.. Structural damage analysis of masonry walls using computational homogenization[J]. International Journal of Damage Mechanics, 2007, 16: 199-226

[14] WangM.-tie.Cracking controlling in engineering structure[M], 1997, Beijing, Chinese Construction Industry Press

[15] SunX.-f., FangX.-s., GuanL.-tai.Materials mechanics[M], 1994, Beijing, Higher Education Press