Image processing method for defect images of ferromagnetic metal casings based on pulsed eddy current testing

Abstract

In oil and gas extraction, ferromagnetic metal casings serve as critical infrastructure to ensure the safety of hydrocarbon transport. However, under high-temperature and high-pressure conditions, casings buried deep underground are prone to deformation, twisting, and even rupture due to erosion and corrosion, potentially leading to significant economic losses and safety hazards. Therefore, regular inspection and maintenance of in-service well casings are essential. Pulsed eddy current testing (PECT) has been widely used for casing defect detection owing to its efficiency, non-contact nature, and rich information content. However, the presence of substantial noise during detection degrades the quality of defect detection images. To address this issue, we investigated image processing techniques for casing defect detection images and proposed an image processing algorithm (BIC) based on bidimensional empirical mode decomposition (BEMD), improved wavelet threshold denoising (IWTD), and contrast limited adaptive histogram equalization (CLAHE). The proposed method first applied BEMD-IWTD for noise suppression in defect detection images, followed by CLAHE for image enhancement. To validate the effectiveness of the method, defect detection experiments were conducted on casings with ring-shaped and local defects, and the acquired images were processed. After being processed with the BIC algorithm, ring-shaped defects of different depths could be effectively distinguished, especially the 1 mm and 2 mm deep defects that were previously affected by noise. In the local defect images, small-sized defects difficult to be identified due to noise interference were successfully recognized, and the defect contrast C_d was significantly improved. The results demonstrate that the proposed BIC algorithm effectively suppresses the noise in defect detection images, enhances the contrast between defects and the background, and improves defect recognition and detection accuracy, providing reliable image processing support for subsequent defect analysis.

Keywords

ferromagnetic metal casing / nondestructive testing (NDT) / pulsed eddy current testing (PECT) / defect detection / image denoising / image enhancement

Acknowledgement

This work was supported by National Natural Science Foundation of China (No.62303385).

Declaration of conflicting interests

The authors have no conflict of interests related to this publication.

References

[1] LACKEY G,PFANDER I,GARDINER J,et al. Composition and origin of surface casing fluids in a major US oil- and gas-producing region. Environmental Science & Technology, 2022, 56(23): 17227-17235.

[2] DENG K H,LIU W Y,LIU B,et al. Repairing force for deformed casing shaping with spinning casing swage and damage behaviour of cement sheath. Applied Mathematical Modelling, 2019, 70: 425-438.

[3] LACKEY G,RAJARAM H. Modeling gas migration, sustained casing pressure, and surface casing vent flow in onshore oil and gas wells. Water Resources Research, 2019, 55(1): 298-323.

[4] LIU K,GAO D L,WANG Y B,et al. Effect of local loads on shale gas well integrity during hydraulic fracturing process. Journal of Natural Gas Science and Engineering, 2017, 37: 291-302.

[5] SAFAEI A,ASEFI M,AHMADI M,et al. Chemical treatment for sand production control: a review of materials, methods, and field operations. Petroleum Science, 2023, 20(3): 1640-1658.

[6] MUBARAK G,VERMA C,BARSOUM I,et al. Internal corrosion in oil and gas wells during casings and tubing: challenges and opportunities of corrosion inhibitors. Journal of the Taiwan Institute of Chemical Engineers, 2023, 150: 105027.

[7] ZHANG W,SUN H,TAO A H,et al. Local defect detection of ferromagnetic metal casing based on pulsed eddy current testing. IEEE Transactions on Instrumentation and Measurement, 2022, 71: 6003109.

[8] ZHAO X,WANG Z B,LIU B. Phase aberration correction in ultrasonic phased array non-destructive testing systems. Journal of Measurement Science and Instrumentation, 2015, 6(1): 47-52.

[9] GUNARATHNE G P P,QURESHI Y. Development of a synthetic A-scan technique for ultrasonic testing of pipelines. IEEE Transactions on Instrumentation and Measurement, 2005, 54(1): 192-199.

[10] LI B L,SUN C H,XIN S C,et al. Development of a 16-channel broadband piezoelectric micro ultrasonic transducer array probe for pipeline butt-welded defect detection. Sensors, 2022, 22(19): 7133.

[11] TRUSHKEVYCH O,EDWARDS R S. Characterisation of small defects using miniaturised EMAT system. NDT & E International, 2019, 107: 102140.

[12] J.SHULL P. Nondestructive evaluation: theory, techniques, and applications. New York: Marcel Dekker, 2016.

[13] MIN K,RYONG Y,SOO P. Analysis of a defect signal deformations induced by eddy current in RFECT system for pipeline inspection. IEEE Transactions on Magnetics, 2018, 54(11): 6202905.

[14] VASIC D,BILAS V,AMBRUS D. Pulsed eddy-current nondestructive testing of ferromagnetic tubes. IEEE Transactions on Instrumentation and Measurement, 2004, 53(4): 1289-1294.

[15] XU Z Y,WU X J,LI J,et al. Assessment of wall thinning in insulated ferromagnetic pipes using the time-to-peak of differential pulsed eddy-current testing signals. NDT & E International, 2012, 51: 24-29.

[16] ULAPANE N,ALEMPIJEVIC A,VALLS MIRO J,et al. Non-destructive evaluation of ferromagnetic material thickness using Pulsed Eddy Current sensor detector coil voltage decay rate. NDT & E International, 2018, 100: 108-114.

[17] RAO B P C,RAJ B, JAYAKUMAR T,et al. An intelligent imaging scheme for automated eddy current testing. Nondestructive Testing and Evaluation, 2001, 17(1): 41-57.

[18] LI Y,YAN B,LI D,et al. Pulse-modulation eddy current inspection of subsurface corrosion in conductive structures. NDT & E International, 2016, 79: 142-149.

[19] NAFIAH F,SOPHIAN A,KHAN M R,et al. Image-based feature extraction technique for inclined crack quantification using pulsed eddy current. Chinese Journal of Mechanical Engineering, 2019, 32(1): 26.

[20] YAN B,LI Y,REN S T,et al. Recognition and evaluation of corrosion profile via pulse-modulation eddy current inspection in conjunction with improved Canny algorithm. NDT & E International, 2019, 106: 18-28.

[21] LI Y,YAN B,LI W J,et al. Pulse-modulation eddy current probes for imaging of external corrosion in nonmagnetic pipes. NDT & E International, 2017, 88: 51-58.

[22] XIE S J,CHEN Z M,TAKAGI T,et al. Quantitative non-destructive evaluation of wall thinning defect in double-layer pipe of nuclear power plants using pulsed ECT method. NDT & E International, 2015, 75: 87-95.

[23] ZHU P P,CHENG Y H,BAI L B,et al. Local sparseness and image fusion for defect inspection in eddy current pulsed thermography. IEEE Sensors Journal, 2019, 19(4): 1471-1477.

[24] YAN B,LI Y,LIU Z S,et al. Pulse-modulation eddy current imaging for 3D profile reconstruction of subsurface corrosion in metallic structures of aviation. IEEE Sensors Journal, 2021, 21(24): 28087-28096.

[25] LI H C,YU Y T,LI L F,et al. A weighted estimation algorithm for enhancing pulsed eddy current infrared image in ecpt non-destructive testing. Applied Sciences, 2019, 9(20): 4199.

[26] REN S,LI Y,LIU Z S,et al. Gradient-field pulsed eddy current imaging of hidden corrosion in layered conductors via sparse Bayesian learning alongside baseline estimation and denoising with sparsity. Sensors and Actuators A: Physical, 2022, 346: 113900.

[27] ZHU C C,CHEN H Q,ZHU X C,et al. Pulsed eddy current imaging of partially missing solder in brazing joints of stainless steel core plates. Materials, 2024, 17(22): 5561.

[28] BALAKRISHNAN S,CACCIOLA M,UDPA L,et al. Development of image fusion methodology using discrete wavelet transform for eddy current images. NDT & E International, 2012, 51: 51-57.

[29] PARK M,KIM D,OH H S. Quantile-based empirical mode decomposition: an efficient way to decompose noisy signals. IEEE Transactions on Instrumentation and Measurement, 2015, 64(7): 1802-1813.

[30] SADIQ FAREED M M,CHUN Q,AHMED G,et al. Saliency detection by exploiting multi-features of color contrast and color distribution. Computers & Electrical Engineering, 2018, 70: 551-566.

[31] ANNUM R,RIAZ M M,GHAFOOR A. Saliency detection using contrast enhancement and texture smoothing operations. Signal, Image and Video Processing, 2018, 12(3): 505-511.

[32] KALBOUSSI R,ABDELLAOUI M,DOUIK A. Video saliency detection using motion distinctiveness and uniform contrast measure. Informatica, 2019, 30(1): 53-72.

[33] XIE J,XU C H,WU C W,et al. Visualization of defects in CFRP-reinforced steel structures using improved eddy current pulsed thermography. Automation in Construction, 2023, 145: 104643.