Effect of Cotton Waste-Based MCC on Interface and Mechanical Properties of Jute/Glass Fiber-Reinforced Epoxy Composites
Hongyang LI , Jiahua YANG , Zechuan WANG , Lan YAO , Ni WANG
Journal of Donghua University(English Edition) ›› 2026, Vol. 43 ›› Issue (5) : 71 -79.
With the increasingly prominent issues of energy shortage and environmental pollution, it has become imperative to develop natural fiber-reinforced composites for applications in infrastructure, automobiles, etc. In this study, jute fibers, as low-cost natural fibers, were selected as the reinforcement for the composites. To enhance the overall mechanical properties, glass fibers were also added as the reinforcement to form the hybrid composites. To improve the interfacial properties between the fibers and the epoxy resin, the microcrystalline cellulose (MCC) prepared from cotton waste was employed to modify the composites. The introduction of MCC in the designed four jute/glass epoxy composites changed the mechanical properties. Especially for the composite with two layers of glass fiber fabrics on each of the top and bottom surfaces and two layers of jute fabrics in the middle (designated as 2G2J2G), its bending strength and bending modulus after MCC addition reached 113.66 MPa and 11.87 GPa, respectively, which were 34.19% and 23.26% higher than those of the composite without MCC. Scanning electron microscopy (SEM) observations revealed that MCC was uniformly dispersed in the epoxy resin matrix, which would have a positive effect on the interfacial strengthening.
natural fiber-reinforced composite / microcrystalline cellulose / jute / glass fiber / interface performance
| [1] |
|
| [2] |
|
| [3] |
|
| [4] |
|
| [5] |
|
| [6] |
|
| [7] |
|
| [8] |
|
| [9] |
|
| [10] |
|
| [11] |
Saha S, Das S, |
| [12] |
|
| [13] |
|
| [14] |
|
| [15] |
Dilfi K F A, |
| [16] |
|
| [17] |
|
| [18] |
|
| [19] |
|
| [20] |
|
| [21] |
|
/
| 〈 |
|
〉 |