Graphite addition for SiC formation in diamond/SiC/Si composite preparation

Wei Zheng , Xin-bo He , Mao Wu , Xuan-hui Qu , Rong-jun Liu , Dan-dan Guan

International Journal of Minerals, Metallurgy, and Materials ›› 2019, Vol. 26 ›› Issue (9) : 1166 -1176.

PDF
International Journal of Minerals, Metallurgy, and Materials ›› 2019, Vol. 26 ›› Issue (9) : 1166 -1176. DOI: 10.1007/s12613-019-1808-7
Article

Graphite addition for SiC formation in diamond/SiC/Si composite preparation

Author information +
History +
PDF

Abstract

Herein, graphite was used in the Si-vapor reactive infiltration of diamond/SiC/Si composites to produce composites with various SiC contents. X-ray diffraction was used to determine the phases of the composite, whereas scanning electron microscopy was used to confirm the Si–C reaction between the silicon, graphite, and diamond and to observe the SiC morphology. Various SiC contents in the composite were observed with graphite addition. Furthermore, the reaction between silicon and graphite (diamond) produced coarse (fine) SiC particles. The generation of a 10-μm-diameter Si–C area on the surface of the diamond was observed. The thermal conductivity (TC) and coefficient of thermal expansion (CTE) of the composite was investigated, where the TC varied from 317–426 W•m−1•K−1 with the increase of the SiC volume fraction from 38% to 76% and the corresponding CTE increased from 1.7 × 10-6 to 3.7 × 10−6 K−1, respectively. Furthermore, a critical point for the CTE was found to exist at approximately 250°C, where the composite was under a hydrostatic condition. Finally, the bending strength was found to range from 241 to 341 MPa.

Keywords

diamond / SiC / graphite / diffusion / composite

Cite this article

Download citation ▾
Wei Zheng, Xin-bo He, Mao Wu, Xuan-hui Qu, Rong-jun Liu, Dan-dan Guan. Graphite addition for SiC formation in diamond/SiC/Si composite preparation. International Journal of Minerals, Metallurgy, and Materials, 2019, 26(9): 1166-1176 DOI:10.1007/s12613-019-1808-7

登录浏览全文

4963

注册一个新账户 忘记密码

References

[1]

Zhao ZF, Liu YS, Feng W, Zhang Q, Cheng LF, Zhang LT. Improvement on the thermal conductivity of di-amond/CVI-SiC composites using large diamond particles. Diamond Relat. Mater., 2017, 74, 1.

[2]

Matthey B, Höhn S, Wolfrum AK, Mühle U, Motylenko M, Rafaja D, Michaelis A, Herrmann M. Micro-structural investigation of diamond-SiC composites produced by pressureless silicon infiltration. J. Eur. Ceram. Soc., 2017, 37, 1917.

[3]

Li YY, Yu Y, Cao XX, Wang Q, Li T, Hu Z, He HL, He DW. Enhancing dynamic strength of diamond-SiC composite: Design and performance. Comput. Mater. Sci., 2018, 145, 80.

[4]

Voronin GA, Zerda TW, Qian J, Zhao Y, He D, Dub SN. Diamond–SiC nanocomposites sintered from a mixture of diamond and silicon nanopowders. Diamond Relat. Mater., 2003, 12, 1477.

[5]

Ekimov EA, Gierlotka S, Gromnitskaya EL, Kozubowski JA, Palosz B, Lojkowski W, Naletov AM. Mechanical properties and microstructure of diamond–SiC nanocomposites. Inorg. Mater., 2002, 38, 1117.

[6]

Zhao Y, Qian J, Daemen LL, Pantea C, Zhang J, Voronin GA, Zerda TW. Enhancement of fracture toughness in nanostructured diamond–SiC composites. Appl. Phys. Lett., 2004, 84, 1356.

[7]

Qian J, Voronin G, Zerda TW, He D, Zhao Y. High-pressure, high-temperature sintering of diamond–SiC composites by ball-milled diamond–Si mixtures. J. Mater. Res., 2002, 17, 2153.

[8]

Gubicza J, Ungár T, Wang Y, Voronin G, Pantea C, Zerda TW. Microstructure of diamond–SiC nanocomposites determined by x-ray line profile analysis. Diamond Relat. Mater., 2006, 15, 1452.

[9]

Pantea C, Voronin AG, Zerda TW, Zhang JZ, Wang LP, Wang YB, Uchida T, Zhao YS. Kinetics of SiC formation during high P–T reaction between diamond and silicon. Diamond Relat. Mater., 2005, 14, 1611.

[10]

Ekimov EA, Gavriliuk AG, Palosz B, Gierlotka S, Dluzewski P, Tatianin E, Kluev Yu, Naletov AM, Presz A. High-pressure, high-temperature synthesis of SiC–diamond nanocrystalline ceramics. Appl. Phys. Lett., 2000, 77, 954.

[11]

Zhu CX, Lang J, Ma NG. Preparation of Si–diamond–SiC composites by in-situ reactive sintering and their thermal properties. Ceram. Int., 2012, 38, 6131.

[12]

Mlungwane K, Herrmann M, Sigalas I. The low-pressure infiltration of diamond by silicon to form diamond–silicon carbide composites. J. Eur. Ceram., 2008, 28, 321.

[13]

Unifantowicz P, Vaucher S, Lewandowska M, Kurzydłowski KJ. Mechanism of SiC crystals growth on {100} and {111} diamond surfaces upon microwave heating. Mater. Charact., 2010, 61, 648.

[14]

Shiryaev AA, Gaillard F. Local redox buffering by carbon at low pressures and the formation of moissanite–natural SiC. Eur. J. Mineral., 2014, 26, 53.

[15]

Zhou H, Singh RN. Kinetics model for the growth of silicon carbide by the reaction of liquid silicon with carbon. J. Am. Ceram. Soc., 1995, 78, 2456.

[16]

Hodaj F, Dezellus O, Barbier JN, Mortensen A, Eustathopoulos N. Diffusion-limited reactive wetting: effect of interfacial reaction behind the advancing triple line. J. Mater. Sci., 2007, 42, 8071.

[17]

Mlungwane K, Sigalas I, Herrmann M, Rodríguez M. The wetting behaviour and reaction kinetics in diamond–silicon carbide systems. Ceram. Int., 2009, 35, 2435.

[18]

Park JS, Sinclair R, Rowcliffe D, Stern M, Davidson H. Orientation relationship in diamond and silicon carbide composites. Diamond Relat. Mater., 2007, 16, 562.

[19]

Wittorf D, Jäger W, Dieker C, Flöter A, Güttler H. Electron microscopy of interfaces in chemical vapour deposition diamond films on silicon. Diamond Relat. Mater., 2000, 9, 1696.

[20]

Xue L, Su ZA, Yang X, Huang D, Yin T, Liu CX, Huang QZ. Microstructure and ablation behavior of C/C-HfC composites prepared by precursor infiltration and pyrolysis. Corros. Sci., 2015, 94, 165.

[21]

Liu Y, Fu QG, Wang BH, Liu TY, Sun J. The ablation behavior and mechanical property of C/C-SiC-ZrB2 composites fabricated by reactive melt infiltration. Ceram. Int., 2017, 43, 6138.

[22]

Jiang Y, Feng D, Ye CC, Wang W, Ru HQ. Preparation and characterization of Si-SiC coated graphite materials. J. Mater. Metall., 2018, 17, 50.

[23]

Fu QG, Shan YC, Cao CW, Li HJ, Li KZ. Oxidation and erosion resistant property of SiC/Si-Mo-Cr/MoSi2 multi-layer coated C/C composites. Ceram. Int., 2014, 41, 4101.

[24]

Herrmann M, Matthey B, Höhn S, Kinski I, Rafaja D, Michaelis A. Diamond-ceramics composites—New materials for a wide range of challenging applications. J. Eur. Ceram. Soc., 2012, 32, 1915.

[25]

Liu RJ, Cao YB, Yan CL, Zhang CR, He PB. Preparation and characterization of diamond-silicon carbide-silicon composites by gaseous silicon vacuum infiltration process. J. Superhard Mater., 2014, 36, 410.

[26]

Chen L, Yang X, Su ZA, Fang CQ, Zeng G, Huang QZ. Fabrication and performance of micro-diamond modified C/SiC composites via precursor impregnation and pyrolysis process. Ceram. Int., 2018, 44, 9601.

[27]

Tan ZQ, Chen ZZ, Fan GL, Li G, Zhang J, Xu R, Shan AD, Li ZJ, Zhang D. Effect of particle size on the thermal and mechanical properties of aluminum composites reinforced with sic and diamond. Mater. Des., 2016, 90, 845 851.

[28]

Nauyoks S, Wieligor M, Zerda TW, Balogh L, Ungar T, Stephens P. Stress and dislocations in diamond–SiC composites sintered at high pressure, high temperature conditions. Composites Part A, 2009, 40, 566.

[29]

Khorrami MS, Kazeminezhad M, Miyashita Y, Kokabi AH. Improvement in the mechanical properties of Al/SiC nanocomposites fabricated by severe plastic deformation and friction stir processing. Int. J. Miner. Metall. Mater., 2017, 24, 297.

[30]

Tayyebi M, Eghbali B. Microstructure and mechanical properties of SiC-particle-strengthening tri-metal Al/Cu/Ni composite produced by accumulative roll bonding process. Int. J. Miner. Metall. Mater., 2018, 25, 357.

[31]

Liu YS, Hu CH, Feng W, Men J, Cheng LF, Zhang LT. Microstructure and properties of diamond/SiC composites prepared by tape-casting and chemical vapor infiltration process. J. Eur. Ceram. Soc., 2014, 34, 3489.

[32]

Liu YS, Hu CH, Men J, Feng W, Cheng LF, Zhang LT. Effect of diamond content on microstructure and properties of diamond/SiC composites prepared by tape-casting and cvi process. J. Eur. Ceram. Soc., 2015, 35, 2233.

[33]

Sangsuwan P, Tewari SN, Gatica JE, Singh M, Dickerson R. Reactive infiltration of silicon melt through microporous amorphous carbon preforms. Metall. Mater. Trans. B, 1999, 30, 933.

[34]

Fitzer E, Gadow R. Fiber-reinforced silicon carbide. Am. Ceram. Soc. Bull., 1986, 65, 326.

[35]

Hon MH, Davis RF. Self-diffusion of 14C in polycrys-talline β-SiC. J. Mater. Sci., 1979, 14, 2411.

[36]

Pampuch R, Walasek E, Bialoskórski J. Reaction mechanism in carbon-liquid silicon systems at elevated temperature. Ceram. Int., 1986, 12, 99.

[37]

Sawyer GR, Page TF. Microstructural characterization of “REFEL” (reaction-bonded) silicon carbides. J. Mater. Sci., 1978, 13, 885.

[38]

Ness J N, Page T F. Microstructural evolution in reaction-bonded silicon carbide. J. Mater. Sci., 1986, 21, 1377.

[39]

Hon MH, Davis RF, Newbury DE. Self-diffusion of 30Si in polycrystalline β-SiC. J. Mater. Sci., 1980, 15, 2073.

AI Summary AI Mindmap
PDF

104

Accesses

0

Citation

Detail

Sections
Recommended

AI思维导图

/