Corrosion−wear behavior of nanocrystalline Fe₈₈Si₁₂ alloy in acid and alkaline solutions

Abstract

The corrosion−wear behavior of a nanocrystalline Fe₈₈Si₁₂ alloy disc coupled with a Si₃N₄ ball was investigated in acid (pH 3) and alkaline (pH 9) aqueous solutions. The dry wear was also measured for reference. The average friction coefficient of Fe₈₈Si₁₂ alloy in the pH 9 solution was approximately 0.2, which was lower than those observed for Fe₈₈Si₁₂ alloy in the pH 3 solution and in the case of dry wear. The fluctuation of the friction coefficient of samples subjected to the pH 9 solution also showed similar characteristics. The wear rate in the pH 9 solution slightly increased with increasing applied load. The wear rate was approximately one order of magnitude less than that in the pH 3 solution and was far lower than that in the case of dry wear, especially at high applied load. The wear traces of Fe₈₈Si₁₂ alloy under different wear conditions were examined and analyzed by scanning electron microscopy, energy-dispersive X-ray spectroscopy, and X-ray photoelectron spectroscopy. The results indicated that the tribo-chemical reactions that involve oxidation of the worn surface and hydrolysis of the Si₃N₄ ball in the acid solution were restricted in the pH 9 aqueous solution. Thus, water lubrication can effectively improve the wear resistance of nanocrystalline Fe₈₈Si₁₂ alloy in the pH 9 aqueous solution.

Keywords

iron silicon alloys / nanocrystalline alloys / wear behavior / corrosion / acid solutions / alkaline solutions

References

[1] Wood R.J.K. Tribo-corrosion of coatings: a review. J. Phys. D, 2007, 40(18): 5502.

[2] Meng H., Hu X., Neville A. A systematic erosion–corrosion study of two stainless steels in marine conditions via experimental design. Wear, 2007, 263(1-6): 355.

[3] Wang Q.Y., Bai S.L., Liu Z.D. Study on cavitation erosion–corrosion behavior of mild steel under synergistic vibration generated by ultrasonic excitation. Tribol. Trans., 2014, 57(4): 603.

[4] Wood R.J.K. Erosion–corrosion interactions and their effect on marine and offshore materials. Wear, 2006, 261(9): 1012.

[5] Kelsall G.H., Williams R.A. Electrochemical behavior of ferrosilicides (Fe_xSi) in neutral and alkaline aqueous electrolytes. J. Electrochem. Soc., 1991, 138(4): 941.

[6] Fushimi K., Kirsten A.L., Habazaki H. Heterogeneous hydrogen evolution on corroding Fe–3 at.% Si surface observed by scanning electrochemical microscopy. Electrochim. Acta, 2007, 52(12): 4246.

[7] Nishimura T., Katayama H., Noda K., Kodama T. Electrochemical behavior of rust formed on carbon steel in a wet/dry environment containing chloride ions. Corrosion, 2000, 56(9): 935.

[8] Giordana S., Mabille I., Fiaud C. Inhibiting effect of silicates on corrosion of low silicon alloyed steels in neutral non-oxidising conditions at 90°C. Corros. Eng. Sci. Technol., 2003, 38(4): 291.

[9] Giordana S., Fiaud C. Corrosion behaviour of low-Si alloyed steels in neutral reducing conditions at 90°C. Electrochim. Acta, 2002, 47(11): 1683.

[10] Mohr M., Daccache L., Horvat S., Brühne K., Jacob T., Fecht H.J. Influence of grain boundaries on elasticity and thermal conductivity of nanocrystalline diamond films. Acta Mater., 2017, 122, 92.

[11] Li X.Y., Liu W., Xu Y., Liu C.S., Pan B.C., Liang Y., Fang Q.F., Chen J.L., Luo G.N., Lu G.H., Wang Z. Radiation resistance of nano-crystalline iron: coupling of the fundamental segregation process and the annihilation of interstitials and vacancies near the grain boundaries. Acta Mater., 2016, 109, 115.

[12] Padilla H.A., Boyce B.L., Battaile C.C., Prasad S.V. Frictional performance and near-surface evolution of nanocrystalline Ni–Fe as governed by contact stress and sliding velocity. Wear, 2013, 297(1-2): 860.

[13] Sato H., Tsuzuki R., Kaneko Y., Watanabe Y. Nanocrystallized layer formed by sliding wear under high stress for pure Cu. Jpn. J. Appl. Phys., 2016

[14] Nia N.S., Creus J., Feaugas X., Savall C. Influence of metallurgical parameters on the electrochemical behavior of electrodeposited Ni and Ni–W nanocrystalline alloys. Appl. Surf. Sci., 2016, 370, 149.

[15] Balaraju J.N., Selvi V.E., Rajam K.S. Electrochemical behavior of nanocrystalline Ni-P alloys containing tin and tungsten. Prot. Met. Phys. Chem. Surf., 2010, 46(6): 686.

[16] Yan F.K., Tao N.R., Pan C., Liu L. Microstructures and corrosion behaviors of an austenitic stainless steel strengthened by nanotwinned austenitic grains. Adv. Eng. Mater., 2016, 18(4): 650.

[17] Mishra R., Balasubramaniam R. Effect of nanocrystalline grain size on the electrochemical and corrosion behavior of nickel. Corros. Sci., 2004, 46(12): 3019.

[18] Lee H.B., Lin C.S., Wuu D.S., Lee C.Y. Wear and corrosion investigation on the electrodeposited Ni–P coating. Tribol. Trans., 2011, 54(4): 497.

[19] Wasekar N.P., Sundararajan G. Sliding wear behavior of electrodeposited Ni–W alloy and hard chrome coatings. Wear, 2015, 342-343, 340.

[20] Liu C.S., Su F., Liang J.Z. Nanocrystalline Co–Ni alloy coating produced with supercritical carbon dioxide assisted electrodeposition with excellent wear and corrosion resistance. Surf. Coat. Technol., 2016, 292, 37.

[21] Kim J.H., Amanov A., Pyun Y.S., Cho I.S., Park J.H., Jang Y.S. Enhancement of fretting wear performance of Al–Si alloy by ultrasonic nanocrystalline surface modification (UNSM) technique. Sci. Adv. Mater., 2016, 8(2): 283.

[22] Wang Z.W., Yan Y., Qiao L.J. Tribocorrosion behavior of nanocrystalline metals: a review. Mate. Trans., 2015, 56(11): 1759.

[23] Fu L.C., Yang J., Bi Q.L., Ma J.Q., Liu W.M. Combustion synthesis and characterization of bulk nanocrystalline Fe₈₈Si₁₂ alloy. IEEE Trans. Nanotechnol., 2010, 9(2): 218.

[24] Zhang Y., Yin X., Wang J., Yan F. Influence of microstructure evolution on tribocorrosion of 304SS in artificial seawater. Corros. Sci., 2014, 88, 423.

[25] Archard J.F. Contact and rubbing of flat surfaces. J. Appl. Phys., 1953, 24(8): 981.

[26] Toru Y., Peter H. Analysis of XPS spectra of Fe²⁺ and Fe³⁺ ions in oxide materials. Appl. Surf. Sci., 2008, 254(8): 2441.

[27] Aghdam A.B., Khonsari M.M. On the correlation between wear and entropy in dry sliding contact. Wear, 2011, 270(11-12): 781.

[28] Wolff U., Schneider F., Mummert K., Schultz L. Stability and electrochemical properties of passive layers on Fe–Si alloys. Corrosion, 2000, 56(12): 1195.

[29] Omurtag Y., Doruk M. Some investigations on the corrosion characteristics of Fe–Si alloys. Corros. Sci., 1970, 10(4): 225.

[30] Palumbo G., Aust K.T. Structure-dependence of intergranular corrosion in high purity nickel. Acta Metall. Mater., 1990, 38(11): 2343.

[31] Henry P., Takadoum J., Berçot P. Depassivation of some metals by sliding friction. Corros Sci., 2011, 53(1): 320.