Fracture behavior and microstructure analysis of Al₂O₃–MgO–CaO castables for steel-ladle purging plugs

Abstract

Three different castables based on the Al₂O₃–MgO–CaO system were prepared as steel-ladle purging plug refractories: corundum- based low-cement castable (C-LCC), corundum-spinel-based low-cement castable (C-S-LCC), and corundum-spinel no-cement castable (C-S-NCC) (hydratable alumina (ρ-Al₂O₃) bonded). The fracture behavior at room temperature was tested by the method of “wedge-splitting” on samples pre-fired at different temperatures; the specific fracture energy G _f ^′ and notched tensile strength σ_NT were obtained from these tests. In addition, the Young’s modulus E was measured by the method of resonance frequency of damping analysis (RFDA). The thermal stress resistance parameter R′′′′ calculated using the values of G _f ^′, σ _NT, and E was used to evaluate the thermal shock resistance of the materials. According to the microstructure analysis results, the sintering effect and the bonding type of the matrix material were different among these three castables, which explains their different fracture behaviors.

Keywords

castables / alumina / magnesia / copper oxide / fracture behavior / microstructure / thermal shock resistance

References

[1] Becker J.U., Berger R., Buhr A., Rasim W.A., Tiemann H. Purging plugs for steel ladles-laboratory and plant results from a BOF steel plant. UNITECR1997, 1997 143.

[2] Chaudhuri S., Stein D. Application of new gas purging systems in ladle metallurgy. InterCeram, 1992, 41(5): 313.

[3] Egashira H., Aramaki K., Tomimatsu H., Morimoto S., Yoshida T. Development of long-life slit plug material for steel ladle. Taikabutsu Overseas, 1998, 18(4): 85.

[4] Zhao M. Stirring units for LF/VD ladle in Baosteel. UNITECR1999, 1999 267.

[5] Simonin F., Olagnon C., Maximilien S., Fantozzi G. Thermomechanical behavior of high alumina refractory castables with synthetic spinel additions. J. Am. Ceram. Soc., 2000, 83(10): 2481.

[6] Tschegg E.K. Testing Device and Appropriate Specimen Shapes for Tests to Measure Fracture Values, 1990

[7] Tschegg E.K. New equipments for fracture tests on concrete. Materialpruefung, 1991, 33, 338.

[8] Harmuth H., Bradt R.C. Investigation of refractory brittleness by fracture mechanical and fractographic methods. InterCeram, 2010, 62(4): 6.

[9] Jin S.L., Gruber D., Harmuth H. Determination of Young’s modulus, fracture energy and tensile strength of refractories by inverse estimation of a wedge splitting procedure. Eng. Fract. Mech., 2014, 116, 228.

[10] Guan Z.D., Zhang Z.T., Jiao J.S. Physical Properties of Inorganic Materials, 1992, Beijing, Tsinghua University Press, 160.

[11] Long B., Buhr A., Xu G.Y. Thermodynamic evaluation and properties of refractory materials for steel ladle purging plugs in the system Al₂O₃–MgO–CaO. Ceram. Int., 2016, 42(10): 11930.