Influence of gangue existing states in iron ores on the formation and flow of liquid phase during sintering

Abstract

Gangue existing states largely affect the high-temperature characteristics of iron ores. Using a micro-sintering method and scanning electron microscopy, the effects of gangue content, gangue type, and gangue size on the assimilation characteristics and fluidity of liquid phase of five different iron ores were analyzed in this study. Next, the mechanism based on the reaction between gangues and sintering materials was unraveled. The results show that, as the SiO₂ levels increase in the iron ores, the lowest assimilation temperature (LAT) decreases, whereas the index of fluidity of liquid phase (IFL) increases. Below 1.5wt%, Al₂O₃ benefits the assimilation reaction, but higher concentrations proved detrimental. Larger quartz particles increase the SiO₂ levels at the local reaction interface between the iron ore and CaO, thereby reducing the LAT. Quartz-gibbsite is more conductive to assimilation than kaolin. Quartz-gibbsite and kaolin gangues encourage the formation of liquid-phase low-Al₂O₃-SFCA with high IFL and high-Al₂O₃-SFCA with low IFL, respectively.

Keywords

iron ores / ore sintering / assimilation / liquid phase / fluidity

References

[1] Rath SS, Sahoo H, Das B. Optimization of flotation variables for the recovery of hematite particles from BHQ ore. Int. J. Miner. Metall. Mater., 2013, 20(7): 605.

[2] Wu SL, Liu Y, Du JX, Mi K, Lin H. New concept of iron ores sintering basic characteristics. J. Univ. Sci. Technol. Beijing, 2002, 24(3): 254

[3] Wu SL, Du JX, Ma HB, Tian YQ, Xu HF. Fluidity of liquid phase in iron ores during sintering. J. Univ. Sci. Technol. Beijing, 2005, 27(3): 291

[4] Yan LJ, Wu SL, You Y, Pei YD, Zhang LH. Assimilation of iron ores and ore matching method based on complementary assimilation. J. Univ. Sci. Technol. Beijing, 2010, 32(3): 298

[5] Wu SL, Oliveira D, Dai YM, Xu J. Ore-blending optimization model for sintering process based on characteristics of iron ores. Int. J. Miner. Metall. Mater., 2012, 19(3): 217.

[6] Yang LX, Davis L. Assimilation and mineral formation during sintering for blends containing magnetite concentrate and hematite/pisolite sintering fines. ISIJ Int., 1999, 39(3): 239.

[7] Wu SL, Dai YM, Oliveira D, Pei YD, X J, Han HL. Optimization of ore blending during sintering based on complementation of high temperature properties. J. Univ. Sci. Technol. Beijing, 2010, 32(6): 719

[8] Kasai E, Saito F. Differential thermal analysis of assimilation and melt-formation phenomena in the sintering process of iron ores. ISIJ Int., 1996, 36(8): 1109.

[9] Kasai E, Wu SL, Omori Y. Factors governing the strength of agglomerated granules after sintering. ISIJ Int., 1991, 31(1): 17.

[10] Machida S, Nushiro K, Ichikawa K, Noda H, Sakai H. Experimental evaluation of chemical composition and viscosity of melts during iron ore sintering. ISIJ Int., 2005, 45(4): 513.

[11] Hsien LH, Whiteman JA. Effect of raw material composition on the mineral phases in lime-fluxed iron ore sinter. ISIJ Int., 1993, 33(4): 462.

[12] Xue MS, Guo XM. Effect of Al₂O₃ and SiO₂ on formation and crystal structure of calcium ferrite containing Al₂O₃ and SiO₂. J. Chin. Rare Earth Soc., 2008, 26, 205

[13] Scarlett NVY, Pownceby MI, Madsen IC, Christensen AN. Reaction sequences in the formation of silico-ferrites of calcium and aluminum in iron ore sinter. Metall. Mater. Trans. B, 2004, 35, 929.

[14] Wang XL. Metallurgy of Iron and Steel, 2013, Beijing, Metallurgical Industry Press, 51

[15] Guo XM. Formation and Mineralogy of Calcium Ferrite, 1999, Beijing, Metallurgical Industry Press, 153

[16] Lu L, Holmes RJ, Manuel JR. Effects of alumina on sintering performance of hematite iron ores. ISIJ Int., 2007, 47(3): 349.