Ohmic contact properties of p-type surface conductive layer on H-terminated diamond films prepared by DC arc jet CVD

Abstract

With the advantages of high deposition rate and large deposition area, polycrystalline diamond films prepared by direct current (DC) arc jet chemical vapor deposition (CVD) are considered to be one of the most promising materials for high-frequency and high-power electronic devices. In this paper, high-quality self-standing polycrystalline diamond films with the diameter of 100 mm were prepared by DC arc jet CVD, and then, the p-type surface conductive layer with the sheet carrier density of 10¹¹–10¹³ cm⁻² on the H-terminated diamond film was obtained by micro-wave hydrogen plasma treatment for 40 min. Ti/Au and Au films were deposited on the H-terminated diamond surface as the ohmic contact electrode, respectively, afterwards, they were treated by rapid vacuum annealing at different temperatures. The properties of these two types of ohmic contacts were investigated by measuring the specific contact resistance using the transmission line method (TLM). Due to the formation of Ti-related carbide at high temperature, the specific contact resistance of Ti/Au contact gradually decreases to 9.95 × 10⁻⁵ Ω·cm² as the temperature increases to 820°C. However, when the annealing temperature reaches 850°C, the ohmic contact for Ti/Au is degraded significantly due to the strong diffusion and reaction between Ti and Au. As for the as-deposited Au contact, it shows an ohmic contact. After annealing treatment at 550°C, low specific contact resistance was detected for Au contact, which is derived from the enhancement of interdiffusion between Au and diamond films.

Keywords

polycrystalline materials / diamond films / chemical vapor deposition / ohmic contacts / contact resistance

References

[1] Landstrass MI, Ravi KV. Resistivity of chemical vapor deposited diamond films. Appl. Phys. Lett., 1989, 55(10): 1391.

[2] Rezek B, Nebel CE. Electronic properties of plasma hydrogenated diamond surfaces: a microscopic study. Diamond Relat. Mater., 2006, 15(9): 1374.

[3] Chen H, Jia CC, Li SJ, Jia XJ, Yang X. Se lective interfacial bonding and thermal conductivity of diamond/Cu-alloy composites prepared by HPHT technique. Int. J. Miner. Metall. Mater., 2012, 19(4): 364.

[4] Fan YM, Guo H, Xu J, Chu K, Zhu XX, Jia CC. Effects of boron on the microstructure and thermal properties of Cu/diamond composites prepared by pressure in-filtration. Int. J. Miner. Metall. Mater., 2011, 18(4): 472.

[5] Chu K, Jia CC, Liang XB, Chen H. Effect of sintering temperature on the microstructure and thermal conductivity of Al/diamond composites prepared by spark plasma sintering. Int. J. Miner. Metall. Mater., 2010, 17(2): 234.

[6] Hayashi K, Yamanaka S, Watanabe H, Sekiguchi T, Okushi H, Kajimura K. Investigation of the effect of hydrogen on electrical and optical properties in chemical vapor deposited on homoepitaxial diamond films. J. Appl. Phys., 1997, 81(2): 744.

[7] Strobel P, Riedel M, Ristein J, Ley L. Surface transfer doping of diamond. Nature, 2004, 430, 439.

[8] Maier F, Riedel M, Mantel B, Ristein J, Ley L. Origin of surface conductivity in diamond. Phys. Rev. Lett., 2000, 85(16): 3472.

[9] Phys. Rev. B, 2003, 68(4)

[10] Rezek B, Kozak H, Kromka A. Stabilizing diamond surface conductivity by phenol-formaldehyde and acrylate resins. Thin Solid Films, 2009, 517(13): 3738.

[11] Kueck D, Schmidt A, Denisenko A, Kohn E. Analysis of passivated diamond surface channel FET in dualgate configuration: localizing the surface acceptor. Diamond Relat. Mater., 2010, 19(2–3): 166.

[12] Kueck D, Jooss S, Kohn E. Technology of passivated surface channel MESFETs with modified gate structures. Diamond Relat. Mater., 2009, 18(10): 1306.

[13] Ueda K, Kasu M, Yamauchi Y, Makimoto T, Schwitters M, Twitchen DJ, Scarsbrook GA, Coe SE. Diamond FET using high-quality polycrystalline diamond with f _T of 45GHz and f _max of 120 GHz. IEEE Electron Device Lett., 2006, 27(7): 570.

[14] Kasu M, Ueda K, Ye H, Yamauchi Y, Sasaki S, Makimoto T. 2 W/mm output power density at 1 GHz for diamond FETs. Electron. Lett., 2005, 41(22): 1249.

[15] Appl. Phys. Express, 2010, 3(5)

[16] Yamada H, Chayahara A, Mokuno Y, tsubouchi N, Shikata S, Fujimori N. Developments of elemental technologies to produce inch-size single-crystal diamond wafers. Diamond Relat. Mater., 2011, 20(4): 616.

[17] Yamada H, Chayahara A, Umezawa H, Tsubouchi N, Mokuno Y, Shikata S. Fabrication and fundamental characterizations of tiled clones of single-crystal diamond with 1-inch size. Diamond Relat. Mater., 2012, 24, 29.

[18] Williams OA, Jackman RB, Nebel C, Foord JS. Black diamond: a new material for active electronic devices. Diamond Relat. Mater., 2002, 11(3–6): 39.

[19] Williams OA, Jackman RB, Nebel C, Foord JS. High carrier mobilities in black diamond. Semicond. Sci. Technol., 2003, 18(3): 77.

[20] Lu FX, Tang WZ, Zhong GF, Zhong GF, Huang TB, Liu JM, Li GH, Lo TL, Zhang YG, Sun ZL, Du SM, He QY, Wang SI. Economical deposition of a large area of high quality diamond film by a high power DC arc plasma jet operating in a gas recycling mode. Diamond Relat. Mater., 2000, 9(9–10): 1655.

[21] Lu FX, Tang WZ, Huang TB, Liu JM, Song JH, Yu WX, Tong YM. Large area high quality diamond film deposition by high power DC arc plasma jet operating at gas recycling mode. Diamond Relat. Mater., 2001, 10(9–10): 1551.

[22] Liu Z, Li CM, Chen LX, Wang LM, Hei LF, Lu FX. Deposition of crackless freestanding diamond films on Mo substrates with Zr interlayer. Int. J. Miner. Metall. Mater., 2010, 17(2): 246.

[23] Zhen CM, Wang YY, He SH, Guo QF, Yan ZJ, Pu YJ. Ohmic contacts to boron-doped diamond. Opt. Mater., 2003, 23(1–2): 117.

[24] Venkatesan V, Malta DM, Das K, Belu AM. Evaluation of ohmic contacts formed by B+ implantation and Ti-Au metallization on diamond. J. Appl. Phys., 1993, 74(2): 1179.

[25] McKeag RD, Chan SSM, Johnson C, Chalker PR, Jackman RB. High temperature stability of chemically vapour deposited diamond diodes. Mater. Sci. Eng B, 1995, 29(1–3): 223.

[26] Cui JB, Ristein J, Ley L. Dehydrogenation and the surface phase transition on diamond (111): kinetics and electronic structure. Phys. Rev. B, 1999, 59(8): 5847.

[27] Liu JL, Li CM, Chen LX, Wei JJ, Hei LF, Wang JJ, Feng ZH, Guo H, Lv FX. Nucleation and growth surface conductivity of H-terminated diamond films prepared by DC arc jet CVD. Diamond Relat. Mater., 2012, 32, 48.