Cellular lightweight concrete containing high-calcium fly ash and natural zeolite

Abstract

Cellular lightweight concrete (CLC) with the controlled density of approximately 800 kg/m³ was made from a preformed foam, Type-I Portland cement (OPC), fly ash (FA), or natural zeolite (NZ), and its compressive strength, setting time, water absorption, and microstructure of were tested. High-calcium FA and NZ with the median particle sizes of 14.52 and 7.72 μm, respectively, were used to partially replace OPC at 0, 10wt%, 20wt%, and 30wt% of the binder (OPC and pozzolan admixture). A water-to-binder mass ratio (W/B) of 0.5 was used for all mixes. The testing results indicated that CLC containing 10wt% NZ had the highest compressive strength. The replacement of OPC with NZ decreased the total porosity and air void size but increased the capillary porosity of the CLC. The incorporation of a suitable amount of NZ decreased the setting time, total porosity, and pore size of the paste compared with the findings with the same amount of FA. The total porosity and cumulative pore volume decreased, whereas the gel and capillary pores increased as a result of adding both pozzolans at all replacement levels. The water absorption increased as the capillary porosity increased; this effect depended on the volume of air entrained and the type or amount of pozzolan.

Keywords

lightweight concrete / fly ash / zeolites / compressive strength / microstructure / water absorption

References

[1] Karakurt C, Kurama H, Topçu B. Utilization of natural zeolite in aerated concrete production. Cem. Concr. Compos., 2010, 32(1): 1.

[2] ACI Committee 116, Cement and Concrete Terminology (ACI 116R-00), ACI Manual of Concrete Practice, 2000.

[3] ASTM C796-04. Standard Test Method for Foaming Agents for Use in Producing Cellular Concrete Using Preformed Foam, 2004

[4] Just A, Middendorf B. Microstructure of high-strength foam concrete. Mater. Charact., 2009, 60(7): 741.

[5] Tikalsky PJ, Pospisil J, MacDonald W. A method for assessment of the freeze-thaw resistance of preformed foam cellular concrete. Cem. Concr. Res., 2004, 34(5): 889.

[6] Nambiar EK K, Ramamurthy K. Models relating mixture composition to the density and strength of foam concrete using response surface methodology. Cem. Concr. Compos., 2006, 28(9): 752.

[7] Chindaprasirt P, Jaturapitakkul C, Sinsiri T. Effect of fly ash fineness on compressive strength and pore size of blended cement paste. Cem. Concr. Compos., 2005, 27(4): 425.

[8] ASTM C188-95. Standard Test Method for Density of Hydraulic Cement, 2003

[9] Uzal B, Turanl L. Blended cements containing high volume of natural zeolites: properties, hydration and paste microstructure. Cem. Concr. Compos., 2012, 34(1): 101.

[10] BS 1881-116. Method of Determination of Compressive Strength of Concrete Cubes, 1983

[11] Washburn EW. Note on a method of determining the distribution of pore sizes in a porous material. PNAS, 1921, 7(4): 115.

[12] Gallé C. Effect of drying on cement-based materials pore structure as identified by mercury intrusion porosimetry: a comparative study between oven-, vacuum-, and freezedrying. Cem. Concr. Res., 2001, 31(10): 1467.

[13] Konecny L, Naqvi SJ. The effect of different drying techniques on the pore size distribution of blended cement mortars. Cem. Concr. Res., 1993, 23(5): 1223.

[14] Chindaprasirt P, Jaturapitakkul C, Sinsiri T. Effect of fly ash fineness on microstructure of blended cement paste. Constr. Build. Mater., 2007, 21(7): 1534.

[15] ASTM C618. Standard Specification for Coal Fly Ash and Raw or Calcined Natural Pozzolan for Use as a Mineral Admixture in Concrete, 2003

[16] Kroehong W, Sinsiri T, Jaturapitakkul C, Chindaprasirt P. Effect of palm oil fuel ash fineness on the microstructure of blended cement paste. Constr. Build. Mater., 2011, 25(11): 4095.

[17] Canpolat F, Yιlmaz K, Köse M M, Sümer M, Yurdusev MA. Use of zeolite, coal bottom ash and fly ash as replacement materials in cement production. Cem. Concr. Res., 2004, 34(5): 731.

[18] Scrivener KL, Nonat A. Hydration of cementitious materials, present and future. Cem. Concr. Res., 2011, 41(7): 651.

[19] Wongkeo W, Chaipanich A. Compressive strength, microstructure and thermal analysis of autoclaved and air cured structural lightweight concrete made with coal bottom ash and silica fume. Mater. Sci. Eng. A, 2010, 527(16–17): 3676.

[20] Nambiar EK K, Ramamurthy K. Influence of filler type on the properties of foam concrete. Cem. Concr. Compos., 2006, 28(5): 475.

[21] Kolias S, Georgiou C. The effect of paste volume and of water content on the strength and water absorption of concrete. Cem. Concr. Compos., 2005, 27(2): 211.

[22] Nochaiya T, Wongkeo W, Chaipanich A. Utilization of fly ash with silica fume and properties of Portland cement-fly ash-silica fume concrete. Fuel, 2010, 89(3): 768.

[23] Poon CS, Lam L, Kou SC, Lin ZS. A study on the hydration rate of natural zeolite blended cement pastes. Constr. Build. Mater., 1999, 13(8): 427.

[24] Perraki T, Kontori E, Tsivilis S, Kakali G. The effect of zeolite on the properties and hydration of blended cements. Cem. Concr. Compos., 2010, 32(2): 128.

[25] Ahmadi B, Shekarchi M. Use of natural zeolite as a supplementary cementitious material. Cem. Concr. Compos., 2010, 32(2): 134.

[26] Yιlmaz B, Uçar A, Öteyaka B, Uz V. Properties of zeolitic tuff (clinoptilolite) blended portland cement. Build. Environ., 2007, 42(11): 3808.

[27] Bilim C. Properties of cement mortars containing clinoptilolite as a supplementary cementitious material. Constr. Build. Mater., 2011, 25(8): 3175.

[28] Cyr M, Lawrence P, Ringot E. Efficiency of mineral admixtures in mortars: quantification of the physical and chemical effects of fine admixtures in relation with compressive strength. Cem. Concr. Res., 2006, 36(2): 264.

[29] Gopalan MK. Nucleation and pozzolanic factors in strength development of class fly ash concrete. ACI Mater. J., 1993, 90(2): 117.

[30] Montgomery DG, Hughes DC, Williams RIT. Fly ash in concrete: a microstructure study. Cem. Concr. Res., 1981, 11(4): 591.

[31] Nambiar EK K, Ramamurthy K. Sorption characteristics of foam concrete. Cem. Concr. Res., 2007, 37(9): 1341.

[32] Chindaprasirt P, Rattanasak U. Shrinkage behavior of structural foam lightweight concrete containing glycol compounds and fly ash. Mater. Des., 2011, 32(2): 723.

[33] Mehta PK. Studies on blended Portland cements containing Santorin earth. Cem. Concr. Res., 1981, 11(4): 507.

[34] Cem. Concr. Res., 1996, 26(10p.1545)

[35] Nambiar EK K, Ramamurthy K. Airvoid characterisation of foam concrete. Cem. Concr. Res., 2007, 37(2): 211.

[36] Wang KS, Chiou IJ, Chen CH, Wang D. Lightweight properties and pore structure of foamed material made from sewage sludge ash. Constr. Build. Mater., 2005, 19(8): 627.