Effect of cement types, mineral admixtures, and bottom ash on the curing sensitivity of concrete

Kinaanath Hussain , Pongsak Choktaweekarn , Warangkana Saengsoy , Theerati Srichan , Somnuk Tangtermsirikul

International Journal of Minerals, Metallurgy, and Materials ›› 2013, Vol. 20 ›› Issue (1) : 94 -105.

PDF
International Journal of Minerals, Metallurgy, and Materials ›› 2013, Vol. 20 ›› Issue (1) : 94 -105. DOI: 10.1007/s12613-013-0699-2
Article

Effect of cement types, mineral admixtures, and bottom ash on the curing sensitivity of concrete

Author information +
History +
PDF

Abstract

The curing sensitivity of concrete with cement Types 1, 3, and 5 as well as multiple powders consisting of cement, fly ash, and limestone powder was studied. Bottom ash was also used in the study as an internal curing agent and a partial substitution of fine aggregate. The curing sensitivity index was calculated by considering the performances of compressive strength and carbonation depth. Specimens were subjected to two curing conditions: continuously water-cured and continuously air-cured. The results show that cement Type 3 has a lower curing sensitivity, while cement Type 5 increases the curing sensitivity. For the mixes without bottom ash, the use of fly ash increases the curing sensitivity, while limestone powder reduces the curing sensitivity of concrete. The use of bottom ash in concrete reduces the curing sensitivity, especially at a lower mass ratio of water to binder. Concrete with limestone powder, together with bottom ash, is least sensitive to curing. The curing sensitivity calculated from carbonation depth also has a similar tendency as that derived by considering compressive strength. From the test results of compressive strength and curing sensitivity, bottom ash has been proven to be an effective internal curing agent.

Keywords

concrete / curing / sensitivity analysis / fly ash / limestone powder / bottom ash

Cite this article

Download citation ▾
Kinaanath Hussain, Pongsak Choktaweekarn, Warangkana Saengsoy, Theerati Srichan, Somnuk Tangtermsirikul. Effect of cement types, mineral admixtures, and bottom ash on the curing sensitivity of concrete. International Journal of Minerals, Metallurgy, and Materials, 2013, 20(1): 94-105 DOI:10.1007/s12613-013-0699-2

登录浏览全文

4963

注册一个新账户 忘记密码

References

[1]

ACI Committee 308, Standard practice for curing concrete (ACI 308-92), [in] ACI Manual of Concrete Practice, Part 2, Detroit, 1992, p. 19.

[2]

EIT 1014 Committee. EIT Standard 1014-46, Standard Specification for Materials and Construction of Concrete Structures, 2003 3rd Ed. Thailand, Global Graphic Printing House, 72.

[3]

Aitcin P.C., Miao B., Cook W.D., Mitchell D. Effect of size and curing on cylinder compressive strength of normal and high-strength concretes. ACI Mater. J., 1994, 91(4): 349.

[4]

Wood S.L. Evaluation of the Long-term Properties of Concrete, 1992, Skokie, Portland Cement Association

[5]

Lura P., Jensen O.M., Igarashi S.I. Experimental observation of internal water curing of concrete. Mater. Struct., 2007, 40(2): 211.

[6]

Cusson D., Hoogeveen T. Internal curing of high-performance concrete with pre-soaked fine lightweight aggregate for prevention of autogenous shrinkage cracking. Cem. Concr. Res., 2008, 38(6): 757.

[7]

Zhutovsky S., Kovler K., Bentur A. Influence of cement paste matrix properties on the autogenous curing of high performance concrete. Cem. Concr. Compos., 2004, 26(5): 499.

[8]

Kurama H., Kaya M. Usage of coal combustion bottom ash in concrete mixture. Constr. Build. Mater., 2008, 22(9): 1922.

[9]

Kasemchaisiri R., Tangtermsirikul S. A method to determine water retainability of porous fine aggregate for design and quality control of fresh concrete. Constr. Build. Mater., 2007, 21(6): 1322.

[10]

Kasemchaisiri R., Tangtermsirikul S. Properties of self-compacting concrete incorporating bottom ash as a partial replacement of fine aggregate. Sci. Asia, 2008, 34, 87.

[11]

K. Kaewmanee and S. Tangtermsirikul, Use of bottom ash as a fine aggregate replacing material in concrete, [in] Proceedings of the 2nd Annual Concrete Conference, Udonthani, 2006, p. MAT104.

[12]

CPC-18 Measurement of hardened concrete carbonation depth. Mater. Struct., 1988, 21, 453.

[13]

Khunthongkeaw J., Tangtermsirikul S., Leelawat T. A study on carbonation depth prediction for fly ash concrete. Constr. Build. Mater., 2006, 20(9): 744.

[14]

Khunthongkeaw J., Tangtermsirikul S. Model for simulating carbonation of fly ash concrete. J. Mater. Civ. Eng., 2005, 17(5): 570.

[15]

Tangtermsirikul S. Durability and Mix Design of Concrete, 2003 1st Ed. Rangsit Campus, Printing House of Thammasat University, 77.

[16]

Bonavetti V., Donza H., Rahhal V., Irassar E. Influence of initial curing on the properties of concrete containing limestone blended cement. Cem. Concr. Res., 2000, 30(5): 703.

[17]

Lothenbach B., Le Saout G., Gallucci E., Scrivener K. Influence of limestone on the hydration of Portland cements. Cem. Concr. Res., 2008, 38(6): 848.

[18]

Tongaroonsri S. Prediction of Autogenous Shrinkage, Drying Shrinkage and Shrinkage Cracking in Concrete [Dissertation], 2009, Pathum Thani, Sirindhorn International Institute of Technology, Thammasat University, 66.

AI Summary AI Mindmap
PDF

134

Accesses

0

Citation

Detail

Sections
Recommended

AI思维导图

/