Particle simulation of the failure process of brittle rock under triaxial compression

Abstract

In order to investigate the failure process of brittle rock under triaxial compression through both experimental and numerical approaches, the particle simulation method was used in numerical simulations and the simulated results were compared with those of the experiment. The numerical simulation results, such as fracture propagation, microcrack distribution, stress-strain response, and damage patterns, were discussed in detail. The simulated results under various confining pressures (0–60 MPa) are in good agreement with the experimental results. The simulated results reveal that rock failure is caused by axial splitting under uniaxial compression. As the confining pressure increases, rock failure occurs in a few localized shear planes and the rock mechanical behavior is changed from brittle to ductile. Consequently, the peak failure strength, microcrack numbers, and the shear plane angle increase, but the ratio of tensile to shear microcracks decreases. The damage formation during the compression simulations indicates that the particle simulation method can produce similar behaviors as those observed through laboratory compression tests.

Keywords

rock mechanics / compression testing / failure / fracture modes / simulation / microcracks

References

[1] Wu X.Y., Baud P., Wong T.F. Micromechanics of compressive failure and spatial evolution of anisotropic damage in Darley Dale sandstone. Int. J. Rock Mech. Min. Sci., 2000, 37(1–2): 143.

[2] Li Y.P., Chen L.Z., Wang Y.H. Experimental research on pre-cracked marble under compression. Int. J. Solids Struct., 2005, 42(9–10): 2505.

[3] Ge X.R., Ren J.X., Pu Y.B., et al. State Real-in time CT test of the rock meso-damage propagation law. Sci. China Ser. E., 2001, 44(3): 328.

[4] Cai M.F., Liu D.M. Study of failure mechanisms of rock under compressive-shear loading using real-time LASER holography. Int. J. Rock Mech. Min. Sci., 2009, 46(1): 59.

[5] Tang C.A., Tham L.G., Lee P.K.K., et al. Numerical studies of the influence of microstructure on rock failure in uniaxial compression—Part II: Constraint, slenderness and size effect. Int. J. Rock Mech. Min. Sci., 2000, 37(4): 571.

[6] Van Mier J.G.M. Fracture Process of Concrete, 1997 New York, CRC Press

[7] Liang Z.Z., Tang C.A., Li H.X., et al. Numerical simulation of 3-d failure process in heterogeneous rocks. Int. J. Rock Mech. Min. Sci., 2004, 41(1): 323.

[8] Liu H.Y., Kou S.Q., Lindqvist P.A., et al. Numerical studies on the failure process and associated microseismicity in rock under triaxial compression. Tectonophysics, 2004, 384, 149.

[9] Yuan S.C., Harrison J.P. A review of the state of the art in modelling progressive mechanical breakdown and associated fluid flow in intact heterogeneous rocks. Int. J. Rock Mech. Min. Sci., 2006, 43(7): 1001.

[10] Yang S.Q., Jiang Y.Z., Xu W.Y., et al. Experimental investigation on strength and failure behavior of pre-cracked marble under conventional triaxial compression. Int. J. Solids Struct., 2008, 45(17): 4796.

[11] Fang Z., Harrison J.P. Application of a local degradation model to the analysis of brittle fracture of laboratory scale rock specimens under triaxial conditions. Int. J. Rock Mech. Min. Sci., 2002, 39(4): 459.

[12] Pan P.Z., Feng X.T., Hudson J.A. Study of failure and scale effects in rocks under uniaxial compression using 3D cellular automata. Int. J. Rock Mech. Min. Sci., 2009, 46(4): 674.

[13] Zhao C.B., Hobbs B.E., Ord A., et al. Particle simulation of spontaneous crack generation problems in large-scale quasi-static systems. Int. J. Numer. Methods Eng., 2007, 69, 2302.

[14] Zhao C.B., Hobbs B.E., Ord A., et al. Phenomenological modeling of crack generation in brittle crustal rocks using the particle simulation method. J. Struct. Geol., 2007, 29, 1034.

[15] Zhao C.B., Hobbs B.E., Ord A., et al. Particle simulation of spontaneous crack generation associated with the laccolithic type of magma intrusion processes. Int. J. Numer. Methods Eng., 2008, 75, 1172.

[16] Zhao C.B., Peng S.L., Liu L.M., et al. Effective loading algorithm associated with the explicit dynamic relaxation method for simulating static problems. J. Cent. South Univ. Technol., 2009, 16, 125.

[17] Zhao C.B., Hobbs B.E., Ord A. Fundamentals of Computational Geoscience, 2009 Berlin, Springer, 175.

[18] Potyondy D.O., Cundall P.A. A bonded-particle model for rock. Int. J. Rock Mech. Min. Sci., 2004, 41(8): 1329.

[19] ISRM. Rock Characterization Testing and Monitoring, 1986 Oxford, Pergamon Press

[20] Particle Flow Code in Two Dimensions (PFC2D), Itasca Consulting Group Inc., Minneapolis, 2003.