Thermomechanical and microstructural characteristics of cemented backfill incorporating low-dosage polyvinyl chloride powder

Abstract

With the increasing mining depth, heat hazards have become a critical challenge in deep underground operations. This study explores the incorporation of polyvinyl chloride (PVC) powder as a partial cement replacement in cemented backfill to improve thermal insulation and promote sustainable waste utilization. Five mix designs were prepared with 0, 5wt%, 10wt%, 15wt%, and 20wt% PVC, and their thermomechanical behaviors were systematically evaluated through uniaxial compressive strength (UCS) testing, thermal parameter measurements, energy evolution analysis, and microstructural characterization via scanning electron microscopy. The results showed that the UCS and energy absorption capacity first increased and then decreased with PVC addition, reaching an optimum at 10wt% PVC, which achieved an 87.5% higher strength and improved energy dissipation compared with the control. The thermal conductivity and specific heat capacity progressively decreased with increasing PVC content, with the maximum reductions of 23.0% and 40.2%, respectively, for 20wt% PVC. Microstructural analysis confirmed that moderate PVC addition reduced the porosity and enhanced the internal compactness, whereas excessive PVC likely inhibited calcium silicate hydrate gel formation and weakened the structural integrity. A PVC dosage of 10wt% was identified as the optimal replacement level, providing a favorable balance between strength and thermal insulation. This study provides new insights into sustainable backfill design and offers a practical strategy for mitigating thermal hazards in deep mining environments.

Keywords

cemented backfill / polyvinyl chloride / uniaxial compressive strength / thermal properties / microstructure

References

[1] Cai MF, Li P, Tan WH, Ren FH. Key engineering technologies to achieve green, intelligent, and sustainable development of deep metal mines in China. Engineering, 2021, 7111513

[2] M. Wang, G.M. Wen, P. Liu, et al., Optimization of deep mine cooling by functional backfill using wall surface modification method, Int. Commun. Heat Mass Transf., 157(2024), art. No. 107817.

[3] Z.A. Touchente, M. Khellaf, G. Raffin, N. Lebaz, and A. Elaissari, Recent advances in polyvinyl chloride (PVC) recycling, Polym. Adv. Technol., 35(2024), No. 1, art. No. e6228.

[4] C. Liu and C. Liu, Exploring plastic-management policy in China: Status, challenges and policy insights, Sustainability, 15(2023), No. 11, art. No. 9087.

[5] Salih FA, Usman F, Hayder G, Ani YA. Evaluation of some beneficial environmental impacts and enhanced thermal properties resulting from waste plastic integration into concrete. Ann. Chim. Sci. Mat., 2023, 473165

[6] Gesoglu M, Güneyisi E, Hansu O, Etli S, Alhassan M. Mechanical and fracture characteristics of self-compacting concretes containing different percentage of plastic waste powder. Constr. Build. Mater., 2017, 140562

[7] Bahij S, Omary S, Feugeas F, Faqiri A. Fresh and hardened properties of concrete containing different forms of plastic waste–A review. Waste Manage., 2020, 113157

[8] M.N. Noor Azline, K.N. Byron, A.A. Farah Nora Aznieta, and M. Ernaleza, A brief review on polyvinyl chloride plastic as aggregate for construction materials, J. Eng. Appl. Sci., 70(2023), No. 1, art. No. 142.

[9] N.S. Yaya, S. Cao, and E. Yilmaz, Innovative reinforcement: Assessing strength features of waste microplastics reinforced backfills in sustainable mine waste management, Constr. Build. Mater., 460(2025), art. No. 139744.

[10] Wang J, Guo S, Liu XM, Zhang ZQ. Utilization of red mud and coal gangue for underground backfill material: Hydration and environmental characteristics. Int. J. Miner. Metall. Mater., 2025, 3261358

[11] J. Ahmad, A. Majdi, A.B. Elhag, et al., A step towards sustainable concrete with substitution of plastic waste in concrete: Overview on mechanical, durability and microstructure analysis, Crystals, 12(2022), No. 7, art. No. 944.

[12] Y.C. Guo, X.M. Li, J. Zhang, and J.X. Lin, A review on the influence of recycled plastic aggregate on the engineering properties of concrete, J. Build. Eng., 79(2023), art. No. 107787.

[13] J.M. Khatib, A. Jahami, A. Elkordi, H. Abdelgader, and M. Sonebi, Structural assessment of reinforced concrete beams incorporating waste plastic straws, Environments, 7(2020), No. 11, art. No. 96.

[14] X.L. Wang, Z. Qiu, Q.H. Gu, et al., Wear failure of pipelines transporting cemented paste backfill: A review, Phys. Fluids, 37(2025), No. 7, art. No. 071309.

[15] Halim N, Taib N, Aziz ZA. The performance of thermal property in concrete containing waste pet (polyethylene terephthalate) as an alternative sustainable building material. IOP Conference Series: Earth and Environmental Science. 2020012108

[16] Ruiz-Herrero JL, Nieto DV, López-Gil A, et al. . Mechanical and thermal performance of concrete and mortar cellular materials containing plastic waste. Constr. Build. Mater., 2016, 104298

[17] Boutlikht M, Hebbache K, Douadi A, Tabchouche S. Assessment of the PVC waste addition effect on the concrete mechanical performance. Rev. Compos. Mater. Av., 2023, 33285

[18] A. Merlo, L. Lavagna, D.S. Riera, and M. Pavese, Mechanical properties of mortar containing waste plastic (PVC) as aggregate partial replacement, Case Stud. Constr. Mater., 13(2020), art. No. e00467.

[19] Ceran B, Şimşek B, Uygunoǧlu T, Şara ON. PVC concrete composites: Comparative study with other polymer concrete in terms of mechanical, thermal and electrical properties. J. Mater. Cycles Waste Manage., 2019, 214818

[20] M. Belmokaddem, A. Mahi, Y. Senhadji, and B.Y. Pekmezci, Mechanical and physical properties and morphology of concrete containing plastic waste as aggregate, Constr. Build. Mater., 257(2020), art. No. 119559.

[21] M. Manjunatha D. Seth, B. Kvgd, S. Roy, and R.B. Tangadagi, Utilization of industrial-based PVC waste powder in self-compacting concrete: A sustainable building material, J. Cleaner Prod., 428(2023), art. No. 139428.

[22] Manjunatha M, Seth D, Balaji KVGD. Role of engineered fibers on fresh and mechanical properties of concrete prepared with GGBS and PVC waste powder-An experimental study. Mater. Today Proc., 2021, 473683

[23] N. Sharma, Influence of PVC waste powder and calcined clay on the properties of concrete, [in] AIP Conference Proceedings, AIP Publishing, Mathura, 2023, art. No. 020001.

[24] Célestin JCH, Fall M. Thermal conductivity of cemented paste backfill material and factors affecting it. Int. J. Min. Reclam. Environ., 2009, 234274

[25] J. Li, G.R. Feng, J.W. Bai, et al., Thermal effect on bearing behavior and instability of coal-backfill composites, Compos. Struct., 371(2025), art. No. 119447.

[26] Y. Liu, L.R. Min, S.T. Zhang, H. Fang, C.C. Wang, and Y.J. Du, Study on the thermal-mechanical properties and heat transfer characteristics of low leakage heat storage functional backfill body, J. Energy Storage, 94(2024), art. No. 112257.

[27] Y.F. Hu, L.J. Zheng, B. Zhang, K.Q. Li, and B. Han, Key attributes of superfine tailings cemented paste backfill modified with nano-Al₂O₃: Mechanical properties, flowability, microstructure, and thermal decomposition characteristics, Constr. Build. Mater., 458(2025), art. No. 139511.

[28] C. Zhang, J.P. Guo, A. Taheri, W.D. Song, X.L. Wang, and W.H. Xia, Mechanical characteristics and constitutive model of cemented tailings backfill under temperature-time effects, J. Build. Eng., 96(2024), art. No. 110630.

[29] W.B. Xu, Q.L. Li, and B. Liu, Coupled effect of curing temperature and age on compressive behavior, microstructure and ultrasonic properties of cemented tailings backfill, Constr. Build. Mater., 237(2020), art. No. 117738.

[30] W. Sun, S.Y. Zhang, J.X. Li, and Z.Y. Li, Experimental study on energy dissipation of layered backfill under impact load, Constr. Build. Mater., 347(2022), art. No. 128478.

[31] Yang YB, Lai XP, Zhang Y, et al. . Strength deterioration and energy dissipation characteristics of cemented backfill with different gangue particle size distributions. J. Mater. Res. Technol., 2023, 255122

[32] J. Yang, X.B. Yang, S.H. Yin, et al., Damage characteristics and constitutive model of magnesium slag-based cemented backfill based on energy dissipation, Constr. Build. Mater., 449(2024), art. No. 138443.

[33] Munoz H, Taheri A, Chanda EK. Fracture energy-based brittleness index development and brittleness quantification by pre-peak strength parameters in rock uniaxial compression. Rock Mech. Rock Eng., 2016, 49124587

[34] S.H. Yin, Y. Zhou, X. Chen, and G.C. Li, A new acoustic emission characteristic parameter can be utilized to evaluate the failure of cemented paste backfill and rock combination, Constr. Build. Mater., 392(2023), art. No. 132017.

[35] Feng SW, Yu YC, Liu YM. Experimental study on the dynamic mechanical properties and failure characteristics of in situ cemented backfill under impact loading. Min. Metall. Explor., 2025, 4231639

[36] G.Y. Gao, B. Wen, Y.D. Li, F. Li, D.W. Huo, and X.W. Hu, Effect of temperature on thermal properties and residual strength of coal gangue concrete, Case Stud. Therm. Eng., 53(2024), art. No. 103792.

[37] Zhang XY, Xu MY, Liu L, et al. . Experimental study on thermal and mechanical properties of cemented paste backfill with phase change material. J. Mater. Res. Technol., 2020, 922164

[38] K. Wu, Z.Y. Dou, Z.H. Liu, and J.X. Xu, Study on hydration heat release model and its influence coefficient of addition concrete, Appl. Sci., 14(2024), No. 6, art. No. 2276.

[39] Zheng D, Song WD, Tan YY, Cao S, Yang ZL, Sun LJ. Fractal and microscopic quantitative characterization of unclassified tailings flocs. Int. J. Miner. Metall. Mater., 2021, 2891429

[40] B.W. Wang, M.C. Kang, C.Y. Liu, L. Yang, Q.L. Li, and S.L. Zhou, Experimental study on mechanical and microstructure properties of cemented tailings-waste rock backfill with continuous gradation, J. Build. Eng., 95(2024), art. No. 110146.

[41] Sengul O, Azizi S, Karaosmanoglu F, Tasdemir MA. Effect of expanded perlite on the mechanical properties and thermal conductivity of lightweight concrete. Energy Build., 2011, 432–3671

RIGHTS & PERMISSIONS

University of Science and Technology Beijing