Experimental studies of ash film fractions based on measurement of cenospheres geometry in pulverized coal combustion

Abstract

In pulverized coal particle combustion, part of the ash forms the ash film and exerts an inhibitory influence on combustion by impeding the diffusion of oxygen to the encapsulated char core, while part of the ash diffuses toward the char core. Despite the considerable ash effects on combustion, the fraction of ash film still remains unclear. However, the research of the properties of cenospheres can be an appropriate choice for the fraction determination, being aware that the formation of cenospheres is based on the model of coal particles with the visco-plastic ash film and a solid core. The fraction of ash film X is the ratio of the measuring mass of ash film and the total ash in coal particle. In this paper, the Huangling bituminous coal with different sizes was burnt in a drop-tube furnace at 1273, 1473, and 1673 K with air as oxidizer. A scanning electron microscope (SEM) and cross-section analysis have been used to study the geometry of the collected cenospheres and the effects of combustion parameters on the fraction of ash film. The results show that the ash film fraction increases with increasing temperature and carbon conversion ratio but decreases with larger sizes of coal particles. The high fraction of ash film provides a reasonable explanation for the extinction event at the late burnout stage. The varied values of ash film fractions under different conditions during the dynamic combustion process are necessary for further development of kinetic models.

Keywords

ash film fraction / cenospheres / coal combustion / fly ash

References

[1] Chen J Y, Mann A P, Kent J H. Computational modelling of pulverised fuel burnout in tangentially fired furnaces. Symposium (International) on Combustion, 1992, 24(1): 1381–1389

[2] Hottel H C, Stewart I M. Space requirement for the combustion of pulverized coal. Industrial & Engineering Chemistry, 1940, 32(5): 719–730

[3] Hurt R, Sun J K, Lunden M. A kinetic model of carbon burnout in pulverized coal combustion. Combustion and Flame, 1998, 113(1–2): 181–197

[4] Murphy J J, Shaddix C R. Effect of reactivity loss on apparent reaction order of burning char particles. Combustion and Flame, 2010, 157(3): 535–539 doi:10.1016/j.combustflame.2009.09.013

[5] Field M A. Measurements of the effect of rank on combustion rates of pulverized coal. Combustion and Flame, 1970, 14(2): 237–248

[6] Hurt R H, Mitchell R E. Unified high-temperature char combustion kinetics for a suite of coals of various rank. Symposium (International) on Combustion, 1992, 24(1): 1243–1250

[7] Cloke M, Wu T, Barranco R, Lester E. Char characterisation and its application in a coal burnout model. Fuel, 2003, 82(15–17): 1989–2000

[8] Niu Y, Shaddix C R. A sophisticated model to predict ash inhibition during combustion of pulverized char particles. Proceedings of the Combustion Institute, 2015, 35(1): 561–569

[9] Lunden M M, Yang N Y C, Headley T J, Shaddix C R. Mineral-char interactions during char combustion of a high-volatile coal. Symposium (International) on Combustion, 1998, 27(2): 1695–1702

[10] Niu Y, Liu S, Shaddix C R, Hui S. An intrinsic kinetics model to predict complex ash effects (ash film, dilution, and vaporization) on pulverized coal char burnout in air (O₂/N₂) and oxy-fuel (O₂/CO₂) atmospheres. Proceedings of the Combustion Institute, 2019, 37(3): 2781–2790

[11] Chen C, Kojima T. Single char particle combustion at moderate temperature: effects of ash. Fuel Processing Technology, 1996, 47(3): 215–232

[12] Niu Y, Wang S, Shaddix C R, Hui S. Kinetic modeling of the formation and growth of inorganic nano-particles during pulverized coal char combustion in O₂/N₂ and O₂/CO₂ atmospheres. Combustion and Flame, 2016, 173: 195–207

[13] Niu Y, Liu X, Wang S, Hui S, Shaddix C R. A numerical investigation of the effect of flue gas recirculation on the evolution of ultra-fine ash particles during pulverized coal char combustion. Combustion and Flame, 2017, 184: 1–10

[14] Fenelonov V B, Mel’gunov M S, Parmon V N. The properties of cenospheres and the mechanism of their formation during high-temperature coal combustion at thermal power plans. Kona Powder and Particle Journal, 2010, 28(0): 189–208

[15] Żyrkowski M, Neto R C, Santos L F, Witkowski K. Characterization of fly-ash cenospheres from coal-fired power plant unit. Fuel, 2016, 174: 49–53

[16] Yu J, Li X, Fleming E, Meng Z, Wang D, Tahmasebi A. Analysis on characteristics of fly ash from coal fired power stations. Energy Procedia, 2012, 17: 3–9

[17] Vassilev S V, Vassileva C G. Mineralogy of combustion wastes from coal-fired power stations. Fuel Processing Technology, 1996, 47(3): 261–280

[18] Li Y, Wu H. Ash cenosphere from solid fuels combustion. Part 1: an investigation into its formation mechanism using pyrite as a model fuel. Energy & Fuels, 2012, 26(1): 130–137

[19] Li Y, Gao X, Wu H. Further investigation into the formation mechanism of ash cenospheres from an Australian coal-fired power station. Energy & Fuels, 2013, 27(2): 811–815

[20] Raask E. Mineral Impurities in Coal Combustion: Behavior, Problems, and Remedial Measures. New York: Hemisphere, 1985

[21] Ranjbar N, Kuenzel C. Cenospheres: a review. Fuel, 2017, 207: 1–12

[22] Kolay P K, Bhusal S. Recovery of hollow spherical particles with two different densities from coal fly ash and their characterization. Fuel, 2014, 117(Part A): 118–124

[23] Ngu L L, Wu H, Zhang D K. Characterization of ash cenospheres in fly ash from Australian power stations. Energy & Fuels, 2007, 21(6): 3437–3445

[24] Niu Y, Gong Y, Zhang X, Liang Y, Wang D, Hui S. Effects of leaching and additives on the ash fusion characteristics of high-Na/Ca Zhundong coal. Journal of the Energy Institute, 2019, 92(4): 1115–1122

RIGHTS & PERMISSIONS

Higher Education Press