PDF
(323KB)
i
This article has been updated.
A Correction to this article was published on .
i
The Original Article was published on
i
The Original Article was published on
i
This article has been updated
i
This article was retracted on
i
This article has been updated
Abstract
Chinese wood-based composite manufacturers are plagued with serious formaldehyde emission (F-emission) problems. In this study, we investigated the use of an emulsifiable diphenylmethane-4, 4 -diisocyanate (MDI) -urea formaldehyde (UF) mixture adhesive in particleboard manufacture, in order to decrease F-emission to below 9 mg per 100 g board. We paid close attention to the effect of NH4Cl on MDI-UF curing and the method of adhesive application by differential scanning calorimetric (DSC) analysis and compared mechanical properties. Both results showed that the acidic agent NH4Cl did hinder EMDI-UF curing and it also affected the adhesive application method. We are of the opinion that when EMDI and UF are mixed first, without adding NH4Cl and then sprayed onto particles, mechanical properties will be improved and F-emissions will meet E1 grade requirements.
Keywords
UF-MDI adhesive mixture, formaldehyde emission, particleboard, curing agent, separate application, mixing application
Cite this article
Download citation ▾
Wang Weihong, Zhang Xianquan, Lu Renshu.
Adhesive application method in MDI-UF particleboard manufacture.
Front. For. China, 2006, 1 (2) : 225-229 DOI:10.1007/s11461-006-0006-8
CHANGE HISTORY
A Correction to this paper has been published:
https://doi.org
The Retraction Note was updated to reflect reception of statements of disagreement from all authors.
This article has been retracted.Please see the Retraction Notice for more detail:
https://doi.org