Influence of end caps on the unconfined compressive strength of bio-cemented sand

Guijie Sang , Grainne El Mountassir , James M. Minto , Rebecca J. Lunn

Biogeotechnics ›› 2026, Vol. 4 ›› Issue (4) : 100189

PDF (6814KB)
Biogeotechnics ›› 2026, Vol. 4 ›› Issue (4) :100189 DOI: 10.1016/j.bgtech.2025.100189
research-article
Influence of end caps on the unconfined compressive strength of bio-cemented sand
Author information +
History +
PDF (6814KB)

Abstract

Microbially induced carbonate precipitation (MICP) has been widely studied for enhancing soil strength, particularly through unconfined compressive strength (UCS) testing of treated sands. Many studies report correlations between UCS and calcium carbonate (CaCO3) content, significant variability exists, often attributed to reagent properties, soil characteristics, injection strategies, and environmental conditions. However, the role of experimental testing procedures-especially end preparation and capping methods-has been largely overlooked. When preparing cylindrical specimens for UCS testing, conventional grinding methods often fail to achieve the required surface flatness, owing to the relatively weak bio-cementation bond. This shortcoming necessitates the use of appropriate capping methods to minimise stress concentrations induced by surface irregularities. In this study, we examined the effects of using two different end capping methods on the UCS of bio-cemented sand specimens: (1) bonded gypsum plaster caps (ASTM C617/C617M-15), and (2) unbonded silicone (rubber) caps (ASTM C1231/C1231M-15). The two end caps produced significantly different mechanical responses. Unbonded silicone-capped specimens exhibited more ductile behaviour, lower peak strengths, and stress-strain curves with multiple peaks and troughs-attributed to near-surface damage as the cap deforms. In contrast, bonded gypsum-capped specimens exhibited higher peak strengths at lower axial strains and smoother stress–strain curves. These behaviours are attributed to the much higher stiffness of cured gypsum plaster relative to the bio-cemented sand. Consequently, failure in these bonded specimens typically occurred at the weakest point (i.e. the least dense section as evidenced by X-ray radiography), with some showing well-defined shear bands across the sample length. The study also demonstrated that the measured UCS of bio-cemented sand is highly sensitive to density variations along the sample length, in addition to CaCO3 content. To minimise the influence of surface irregularities on UCS results, it is therefore recommended that core specimens be capped with gypsum plaster in accordance with ASTM C617/C617M-15. The capping method should also be reported when presenting UCS data as it can significantly influence the mechanical response.

Keywords

Biocementation / Capping methods / Surface flatness / Density variation / UCS-CaCO3 Relationship

Cite this article

Download citation ▾
Guijie Sang, Grainne El Mountassir, James M. Minto, Rebecca J. Lunn. Influence of end caps on the unconfined compressive strength of bio-cemented sand. Biogeotechnics, 2026, 4 (4) : 100189 DOI:10.1016/j.bgtech.2025.100189

登录浏览全文

4963

注册一个新账户 忘记密码

References

[1]

Al Qabany, A., & Soga, K. (2013). Effect of chemical treatment used in MICP on engineering properties of cemented soils. Géotechnique, 63, 331-339. https://doi.org/10.1680/geot.SIP13.P.022

[2]

Cheng, L., Cord-Ruwisch, R., & Shahin, M. A. (2013). Cementation of sand soil by microbially induced calcite precipitation at various degrees of saturation. Canadian Geotechnical Journal, 50, 81-90. https://doi.org/10.1139/cgj-2012-0023

[3]

Cheng, L., Shahin, M. A., Asce, M., Mujah, D., & Scholar, P. (2017). Influence of key environmental conditions on microbially induced cementation for soil stabilization. Journal of Geotechnical and Geoenvironmental Engineering, 143. https://doi.org/10.1061/(ASCE)GT.1943-5606.0001586

[4]

Cheng, L., Shahin, M. A., & Cord-Ruwisch, R. (2014). Bio-cementation of sandy soil using microbially induced carbonate precipitation for marine environments. Geotechnique, 64, 1010-1013. https://doi.org/10.1680/geot.14.T.025

[5]

Choi, S.-G., Wu, S., & Chu, J. (2016). Biocementation for sand using an eggshell as calcium source. Journal of Geotechnical and Geoenvironmental Engineering, 142, Article 06016010. https://doi.org/10.1061/(ASCE)GT.1943-5606.0001534

[6]

Cui, M. J., Zheng, J. J., Zhang, R. J., Lai, H. J., & Zhang, J. (2017). Influence of cementation level on the strength behaviour of bio-cemented sand. Acta Geotechnica, 12, 971-986. https://doi.org/10.1007/s11440-017-0574-9

[7]

El Mountassir, G., Minto, J. M., van Paassen, L. A., Salifu, E., & Lunn, R. J. (2018). Applications of microbial processes in geotechnical engineering. Advances in Applied Microbiology, 104, 39-91. https://doi.org/10.1016/BS.AAMBS.2018.05.001

[8]

Gowthaman, S., Iki, T., Nakashima, K., Ebina, K., & Kawasaki, S. (2019). Feasibility study for slope soil stabilization by microbial induced carbonate precipitation (MICP) using indigenous bacteria isolated from cold subarctic region. SN Applied Sciences, 1, 1-16. https://doi.org/10.1007/s42452-019-1508-y

[9]

Li, D., Tian, K., Zhang, H., Wu, Y., Nie, K., & Zhang, S. (2018). Experimental investigation of solidifying desert aeolian sand using microbially induced calcite precipitation. Construction and Building Materials, 172, 251-262. https://doi.org/10.1016/J.CONBUILDMAT.2018.03.255

[10]

Li, M., Wen, K., Li, Y., & Zhu, L. (2017). Impact of oxygen availability on microbially induced calcite precipitation (MICP) treatment. Geomicrobiol Journal, 35, 15-22. https://doi.org/10.1080/01490451.2017.1303553

[11]

Liu, L., Liu, H. L., Stuedlein, A., Evans, T. M., & Xiao, Y. (2019). Strength, stiffness, and microstructure characteristics of biocemented calcareous sand. Canadian Geotechnical Journal, 56(10), 1502-1513. https://doi.org/10.1139/cgj-2018-0007

[12]

Ma, G., Xiao, Y., He, X., Li, J., Chu, J., & Liu, H. (2022). Kaolin-nucleation-based biotreated calcareous sand through unsaturated percolation method. Acta Geotechnica, 17, 3181-3193. https://doi.org/10.1007/S11440-022-01459-Y/FIGURES/12

[13]

Mahawish, A., Bouazza, A., & Gates, W. P. (2018). Improvement of coarse sand engineering properties by microbially induced calcite precipitation. Geomicrobiol Journal, 35, 887-897. https://doi.org/10.1080/01490451.2018.1488019;WGROUP:STRING:PUBLICATION

[14]

Mahawish, A., Bouazza, A., & Gates, W. P. (2016). Biogrouting coarse materials using soil-lift treatment strategy. Canadian Geotechnical Journal, 53, 2080-2085. https://doi.org/10.1139/cgj-2016-0167

[15]

Rowshanbakht, K., Khamehchiyan, M., Sajedi, R. H., & Nikudel, M. R. (2016). Effect of injected bacterial suspension volume and relative density on carbonate precipitation resulting from microbial treatment. Ecological Engineering, 89, 49-55. https://doi.org/10.1016/J.ECOLENG.2016.01.010

[16]

Sang, G., Lunn, R. J., El Mountassir, G., & Minto, J. M. (2023). Meter-scale MICP improvement of medium graded very gravelly sands: Lab measurement, transport modelling, mechanical and microstructural analysis. Engineering Geology, 324, Article 107275. https://doi.org/10.1016/j.enggeo.2023.107275

[17]

Sang, G., Lunn, R. J., El Mountassir, G., Minto, J. M., McLachlan, E., Bradley, D., & Henderson, K. (2024a). Improving non-uniform gravelly sand using microbially induced carbonate precipitation: An outdoor cubic-meter scale trial by engineering contractors. Engineering GeologyArticle 107791. https://doi.org/10.1016/J.ENGGEO.2024.107791

[18]

Sang, G., Lunn, R. J., Minto, J. M., & El Mountassir, G. (2024b). Microbially induced carbonate precipitation for soil improvement: Insights from a meter-scale radial grouting trial. BiogeotechnicsArticle 100157. https://doi.org/10.1016/J.BGTECH.2024.100157

[19]

Terzis, D., & Laloui, L. (2018). 3-D micro-architecture and mechanical response of soil cemented via microbial-induced calcite precipitation. 2018 8:1 Scientific Reports, 8, 1-11. https://doi.org/10.1038/s41598-018-19895-w

[20]

van Paassen, L. A., Ghose, R., Linden, T. J. M. van der, Star, W. R. L. van der, & Loosdrecht, M. C. M. van (2010). Quantifying Biomediated Ground Improvement by Ureolysis: Large-Scale Biogrout Experiment. Journal of Geotechnical and Geoenvironmental Engineering, 136, 1721-1728. https://doi.org/10.1061/(ASCE)GT.1943-5606.0000382

[21]

Whiffin, V. S., van Paassen, L. A., & Harkes, M. P. (2007). Microbial carbonate precipitation as a soil improvement technique. Geomicrobiol Journal, 24, 417-423. https://doi.org/10.1080/01490450701436505

[22]

Wu, S., Li, B., & Chu, J. (2020). Large-scale model tests of biogrouting for sand and rock. Proceedings of the Institution of Civil Engineers-Ground Improvement. https://doi.org/10.1680/JGRIM.18.00074

[23]

Xiao, P., Liu, H., Xiao, Y., Stuedlein, A. W., & Evans, T. M. (2018). Liquefaction resistance of bio-cemented calcareous sand. Soil Dynamics and Earthquake Engineering, 107, 9-19. https://doi.org/10.1016/j.soildyn.2018.01.00

[24]

Xiao, Y., He, X., Evans, T. M., Stuedlein, A. W., & Liu, H. (2019). Unconfined compressive and splitting tensile strength of basalt fiber-reinforced biocemented sand. Journal of Geotechnical and Geoenvironmental Engineering, 145, Article 04019048. https://doi.org/10.1061/(ASCE)GT.1943-5606.0002108

PDF (6814KB)

0

Accesses

0

Citation

Detail

Sections
Recommended

/

〈 〉