The article is about the research of distribution of deformation on thickness of the maple samples received by means of hot rolling. In relation to these conditions when rolling in broadband camp, distribution of deformation on thickness of strips was estimated by method of screws, and character of structure was specified by metallographic method. The authors provided schedules of distribution of deformation in samples and photo of structure. Schedules of heterogeneity of the saved-up deformation on thickness of previously squeezed out technological flute are submitted.
The article discusses approaches to determination of start of movement of "floating" elements of combined tool cutting unit for non-rigid shaft machining.
The article considers material deformation in conditions of deformation speed changing. Curve hardenings are analyzed at various speed of deformation of samples and the method of creation of a curve of hardening of material in the conditions of change of speed of deformation of preparation is shown.
This article describes how to improve the technology of manufacturing "body pump" parts of EPAN composite material reinforced by nanoscale carbon fibers.
The article presents the results of comparative analysis of a number of alternative machining holes produced on the basis of experts assessment. Experimental studies were carried out for processing, recognized to be the best by comparative analysis results. Machining conditions and tool selection influence on technological characteristics of holes. The results of this study allow to approach to selection of optimal parameters for machining of holes.
The paper considers the current situation on the wear-resistant coatings and their practical application as the primary method of increasing of cutting tool performance.
The paper is devoted to study of structure, mechanical properties and wear resistance of multilayer coating formed by oxyacetylene welding carbide-containing rods, powder material with nickel sublayer. The amount of wear depends on the structure of the deposited material and welding conditions.
The authors suggest using of CNC machine and a device for securing parts without the use of hand work for manufacture of 48 square seats in thrust bearings separators for helicopters.