%A Zhengyi JIANG, %T Ribbed strip rolling by three-dimensional finite element method combining extremely thin array of elements %0 Journal Article %D 2010 %J Front. Mech. Eng. %J Frontiers of Mechanical Engineering %@ 2095-0233 %R 10.1007/s11465-009-0087-9 %P 52-60 %V 5 %N 1 %U {https://journal.hep.com.cn/fme/EN/10.1007/s11465-009-0087-9 %8 2010-03-05 %X In this paper, a three-dimensional finite element modelling of the ribbed strip rolling is carried out, coupling the use of an extremely thin array of elements that is equivalent to the calculation of the additional shear deformation work rate occurred by the velocity discontinuity in the roll bite. The formulation of the finite element modelling by adding a rib inclined contact surface boundary condition is derived, and the performance of the proposed method is conducted. The simulated rib height, forward slip, and the pulling down of rib height have been compared with the measured values and are in good agreement. The equivalent strain rate of the rib was obtained in the simulation. The effect of the rib inclined angle on pulling down of rib height has also been discussed, which is helpful in optimizing the design of the rib inclined angle.