The resistance of many kinds of rubber materials to dimethyl ether (DME) was studied. Both the mass and volume change of rubber materials, which were put in DME and then exposed to the air for different periods of time were measured. The results show that fluorine rubber (FKM), silicone rubber (SIR), and nitrile rubber (NBR) are unsuitable as seal materials for DME engines. Common polyvinylchloride (PVC) dissolved completely in DME, which has almost no impact on vulcanizing nylon material. The constitution of ethylene propylene terpolymer rubber (EPDM) has a major impact on its resistance to DME. A kind of EPDM with good resistance to DME was found, whose reliability was validated by 100 hours of DME engine operation.
{{custom_sec.title}}
{{custom_sec.title}}
{{custom_sec.content}}
参考文献
1. Fleisch T, McCarthy C, Basu A, et al.. A new clean diesel technology: demonstrationof ULEV emissions on a navistar diesel engine fueled with dimethylether. SAE 950061, 1995
2. Kapus P, Ofner H . Development of fuel injectionequipment and combustion system for DI diesels operated on dimethylether, SAE 950062, 1995
3. Yao Mingfa, Xu Sidu, Luo Yi . Experimental investigation on burning dimethyl ether(DME) in direct injection diesel engine. Journal of Combustion Science and Technology, 2002, 8(3): 252–257 (in Chinese)
4. Zhou Longbao, Wang Hewu, Huang Yongcheng, et al.. Performances and combustion characteristicsof dimethyl ether fueled light duty direct injection diesel engine. Journal of Xi'an Jiang Tong University, 2000, 34(1): 9–13 (in Chinese)
5. Li Degang, Huang Zhen, Qiao Xinqi, et al.. Effects of compression ratio and CO2 on the process of HCCI combustion fueled with DME. Journal of Shanghai Jiaotong University, 2005, 39(2): 169–172 (in Chinese)
6. Luo Maji, Huang Zhen . Numerical simulation of chemicalkinetics mechanism in HCCI combustion fueled with dimethyl ether. Journal of Shanghai Jiaotong University, 2005, 39(8): 1266–1271 (in Chinese)
7. Sorenson S C . Dimethyl ether in diesel engines–Progress and perspectives. Journal of Engineering for Gas Turbines and Power, 2001, 123(7): 652–658. doi:10.1115/1.1370373
8. Hashimoto K, Matsuzawa M, Harasawa N, et al.. Dimethylether(DME) and its seal materials. The Society of Rubber Industry, 2005, 78(3): 111–118
PDF(337 KB)
