%A YANG Zhiyong, XU Meng, HUANG Tian, NI Yanbing %T Variable identification and automatic tuning of the main module of a servo system of parallel mechanism %0 Journal Article %D 2007 %J Front. Mech. Eng. %J Frontiers of Mechanical Engineering %@ 2095-0233 %R 10.1007/s11465-007-0014-x %P 82-88 %V 2 %N 1 %U {https://journal.hep.com.cn/fme/EN/10.1007/s11465-007-0014-x %8 2007-03-05 %X The variables of the main module of a servo system for miniature reconfigurable parallel mechanism were identified and automatically tuned. With the reverse solution module of the translation, the module with the exerted translation joint was obtained, which included the location, velocity and acceleration of the parallelogram carriage-branch. The rigid dynamic reverse model was set as the virtual work principle. To identify the variables of the servo system, the triangle-shaped input signal with variable frequency was adopted to overcome the disadvantages of the pseudo-random number sequence, i.e., making the change of the vibration amplitude of the motor dramatically, easily impact the servo motor and make the velocity loop open and so on. Moreover, all the variables including the rotary inertia of the servo system were identified by the additive mass. The overshoot and rise time were the optimum goals, the limited changing load with the attitude was considered, and the range of the controller variables in the servo system was identified. The results of the experiments prove that the method is accurate.